Thermal,morphostructural and spectrometric characterization of an antibacterial kaolinite-based filter modified with silver for water treatment

Journal of Thermal Analysis and Calorimetry - The aim of this work is to synthesize and characterize a new structured silver–clay dried, calcined or sintered at different temperatures...     

Application of pressure sensitive paint measurement to a low-solidity cascade diffuser of a transonic centrifugal compressor

A pressure sensitive paint (PSP) measurement has been known as a pressure field measurement technique based on the oxygen quenching phenomenon of luminescence of specific luminophores. A PSP measurement was applied for pressure field measurement in a low-solidity circular cascade diffuser of a single-stage transonic centrifugal compressor with 5 in pressure ratio for HFC134a gas. The oxygen concentration was about 500 ppm. Ru (bath-phen) was adsorbed on a silica-gel thinlayer chromatography sheet, and the sheet was pasted onto the side-wall between the cascade vanes. A drastic change in luminescent intensity was recognized during a surge condition. Also the pressure variations based on luminescent intensity agreed well with the pressure fluctuations measured using a semiconductor pressure sensor with high-frequency-response. It was shown that a PSP measurement worked well to investigate the unsteady pressure fields in a circular cascade diffuser of a transonic centrifugal compressor. Moreover, the time response of PSP becomes clear as a problem to be overcome for the present.     

Acylation of hydrazides with acetic acid and formic acid

In peptide synthesis, hydrazides are important intermediates for the azide coupling method. A hydrazide is converted to the corresponding azide in the presence of an acid and a nitrite. When acetic acid (or formic acid) is used as the acid, partial acetylation (or formylation) of the hydrazide occurs as a side reaction. Formylation of the hydrazide is much faster than acetylation. Removal of the formyl group on the hydrazide with hydrazine and hydroxylamine was studied. The rate of deformylation with hydrazine treatment is faster than that with hydroxylamine treatment.     

Polyiodide composition in poly(vinyl acetate)-iodine-iodide complex

Polyiodide formed by complexation of poly(vinyl acetate) (PVAc) with iodine in the presence of iodide has been investigated by chemical analysis and resonance Raman spectrophotometry. When PVAc films were immersed in iodide-iodine aqueous solutions which had different ratios of iodide to iodine concentration [I^?]/[I₂], the complex films exhibited tremendous variations of swelling degree, despite the relatively small change in the amount of bound iodine. From a quantitative chemical analysis, the composition of polyiodide bound to PVAc was found to be 1.01 ± 0.035 in the molar ratio of iodide to iodine irrespective of the composition of the iodide-iodine aqueous solution ([I^?]/[I₂] = 2–500). The polyiodide formed in PVAc-iodine-iodide complex was therefore inferred to be (I₃^?)_n. Resonance Raman spectra obtained on PVAc-iodine-iodide complexes were also identical to those of the benzamide-iodine complex, in which the polyiodide consists of (I₃^?)_n, consistent with the result from chemical analysis.     

Fluorimetric assay for measuring Dns-His-Lys-Arg-His-Lys cleaving enzyme using high-performance liquid chromatography

A rapid and sensitive assay for the determination of Dns-His-Lys-Arg-His-Lys cleaving enzyme activity is reported. This assay is based on fluorimetric detection of a dansylated dipeptide, 5-dimethylaminonaphthalene-1-sulfonyl-His-Lys, enzymatically formed from the substrate 5-dimethylaminonaphthalene-1-sulfonyl-His-Lys-Arg-His-d-Lys, after separation by high-performance liquid chromatography (HPLC) using a C-18 reversed-phase column by isocratic elution. This assay is sensitive enough to measure 5-dimethylaminonaphthalene-1-sulfonyl-His-Lys at concentrations as low as 7 pmol, and yields highly reproducible results and requires less than 9.0 min per sample for separation and quantitation. The optimum pH for Dns-His-Lys-Arg-His-Lys cleaving enzyme activity was 7.5-8.0. The Michaelis constant (K_m) and the maximum velocity (V_max) values were 33.3 μM and 47.07 pmol/(μg h), respectively with the use of enzyme extract obtained from bovine pituitary. By using this assay, axonal transport of this enzyme activity was observed 48 h after double ligations of rat sciatic nerves. The high sensitivity and selectivity of this assay would be useful for clarification of the physiological role of this enzyme.     

Effects of electrolytes on the configuration change of cobalt(II)-halide complexes in chloroform/water reverse micelle systems.

The effects of various salts and HClO4 on the configuration change of cobalt(II)-halide complexes in CHCl3/CTAC or CTAB/H2O reverse micelle systems were examined at 25 degrees C by means of spectrophotometry, where CTAC and CTAB represent cetyltrimethylammonium chloride and bromide, respectively. The formation of the [CoCl4]> or [CoBr4]2- species of the tetrahedral configuration from [Co(H2O)6]2+ of the octahedral configuration in the reverse micelles was greatly promoted not only by a decrease in the W value (W = [H2O]/[surfactant]), but also, at a constant W value (e.g., W = 2.0), by the addition of relatively low concentrations of salts or the acid (e.g., 4.0 mol dm(-3) in the aqueous phase or 4.0 x 10(-2) mol dm(-3) in the whole reverse micelle system). The effects of perchlorate salts increased as Na+ < or = Li+ approximately H+ < Sr2+ < Ca2+ < Mg2+. Non-metallic salts, various tetraalkylammonium (R4N+) salts at lower concentrations, gave minor effects. The enhanced effects of metal salts on the configuration change of the cobalt(II)-halide complexes were interpreted by a further distortion of the hydrogen-bonded structure of the water in a "water pool" in the presence of salts of even relatively low concentrations. A conformation change with increasing temperature was also attributed to a further distortion of the water structure. An almost completed formation of [CoBr4]2- as well as [CoCl4]2- was attained in the reverse micelles at a low W value of 0.69 containing LiClO4 or HClO4. A partial transfer of the [CoX4]2- species from a "water pool" into the CHCl3 phase by the addition of the metal salts may be suspected. An examination of cobalt(II)-bromide complexes in dichloromethane/CTAB/H2O at W = 1.3 - 5.55 justified all the arguments concerning the chloroform systems. The Raman spectra of D2O containing concentrated LiBr and LiClO4 have supplied conclusive evidence that the hydrogen-bonded structure of the bulk water is completely distorted by extremely concentrated salts.     

N-Alkyl cysteine-assisted thioesterification of peptides

A new method for the preparation of peptide thioester by the post-solid phase peptide synthesis (SPPS) approach was developed. A series of N-alkyl cysteine derivatives were prepared and used as the C-terminus residue of the peptides prepared by the Fmoc SPPS. The synthetic peptides released from resin by TFA were readily converted to the peptide thioester in aqueous 3-mercaptopropionic acid (MPA) without significant side reactions.     

Recent progress in the solid-phase synthesis of glycopeptide

The recent understanding of the biological role of glycoproteins has brought about a demand for the highly homogeneous glycopeptides as the functional model for glycoproteins. Thus, much efforts have been made to establish easy and efficient method for glycopeptide synthesis. In this paper, we briefly review the recent advances in the synthesis of O- and N-linked glycopeptide based on the solid-phase method. In O-glycopeptide section, the preparation of glycosylated amino acid units with mucin type and other O-linked carbohydrate chains and their use for solid-phase synthesis are summarized. Other approaches, such as the glycosylation of resin bound peptide are also overviewed. In N-glycopeptide section, the synthesis using glycosylated amino acid units as well as other methods are described.     

Sonochemical coating of magnetite nanoparticles with silica

Magnetite nanoparticles were coated with silica through the hydrolysis and condensation of tetraethyl orthosilicate (TEOS) under ultrasonic irradiation. The ultrasonic irradiation was used to prevent the agglomeration of the magnetite particles and accelerate the hydrolysis and condensation of TEOS. TEM, DLS, XRF, VSM, TG and sedimentation test were used to characterize the silica-coated magnetite particles. The dispersibility of silica-coated magnetite particles in aqueous solution was improved significantly and the agglomerate particle size was decreased to 110 nm. It was found that the agglomerate particle size of silica-coated magnetite particles was mainly decided by the coating temperature and the pH value in the silica-coating process. The weight ratio of silica in silica-coated magnetite particles was mainly decided by the pH value in the silica-coating process. The dispersibility of silica-coated magnetite particles was mainly decided by the agglomerate particle size of the suspension. The oxidation of magnetite particles in air was limited through the coated silica. The magnetism of silica-coated magnetite particles decreased slightly after silica-coating.     

Heteroarylthiomethylsilanes. Synthesis and application to heteroarylthiomethylation of carbonyl compounds [1]

Heteroarylthiomethyltrimethylsilanes bearing a 2-pyridyl, 2-imidazolyl, 5-tetrazolyl, or 2-pyrimidinyl group, readily prepared by the reaction of heteroarylmercaptans with halomethyltrimethylsilane in the presence of a base, are synthetic equivalents of heteroarylthiomethyl anions, otherwise inaccessible, and are effective reagents for the introduction of a heteroarythiomethyl group at a carbonyl carbon atom in the presence of a catalytic amount of tetrabutylammonium fluoride.