Synthesis of proteophosphoglycans of Leishmania major and Leishmania mexicana

A novel approach for the synthesis of various fragments of proteophosphoglycans from Leishmania major and Leishmania mexicana proteophosphoglycans has been developed. These compounds have been obtained by coupling alpha-mannosyl and alpha-N-acetyl-glucosamine phosphoramidite derivatives with the serine hydroxyl of various amino acids and peptides to give, after oxidation with tert-BuOOH, phosphotriesters exclusively as alpha-anomers in good yield. The resulting compounds could be deblocked using conventional methods. Glycophosphorylation of preassembled and properly protected peptides was found to be more efficient for the preparation of proteophosphoglycan fragments than a building block approach strategy using a phosphoglycosylserine derivative.     

Application of Alizarine Derivatives as Chromogenic Reagents for the Spectrophotometric Determination of Some Sulfa Drugs

A spectrophotometric procedure for the determination of six pharmaceutical sulfonamides containing a primary aromatic amino group using alizarine (I), alizarine blue (II), alizarine red (III), and quinalizarine (IV), that offers advantages of simplicity, rapidity, sensitivity, precision, and stability, has been developed. The proposed method is based on the formation of colored products with the chromogenic reagents (I-IV). A linear correlation was found between absorbance at λ_max and the concentration. For more accurate results, Ringbom optimum concentration ranges are evaluated. The molar absorptivities (ε), absorptivities (a), and Sandell sensitivities for all sulfonamides derivatives with the chromogenic reagents tested were calculated. The procedures developed are applied for bulk sulfa drugs and some of their dosage forms.     

Electrochemical characterization and stress corrosion cracking behavior of α-brass in molybdate-containing electrolytes

One of the major challenges in material design is the achievement of reasonable operational efficiency through understanding the factors affecting the material’s performance particularly strength and service lifetime characteristics. In this work, the electrochemical behavior of 72Cu–28Zn α-brass alloy in Na₂MoO₄-containing electrolytes was investigated using potentiodynamic polarization and electrochemical frequency modulation techniques complemented with scanning electron microscopy. Also, stress corrosion cracking behavior of the alloy under both open-circuit potential and anodic applied potentials, using the slow strain rate technique, was evaluated. The results drawn from the different techniques are comparable.     

Dose response of hydrazine – Deproteinated tooth enamel under blue light stimulation

The beta dose response and Optically Stimulated Luminescence (OSL) signal stability characteristics of human tooth enamel deproteinated by hydrazine reagent under blue photon stimulation are reported. Removal of the protein organic component of tooth enamel resulted in a higher OSL sensitivity and slower fading of OSL signals. The effect of chemical sample preparation on the enamel sample sensitivity is discussed and further steps to make this deproteinization treatment suitable for in vitro dose reconstruction studies are suggested.     

Synthesis and Antibacterial Activity of Some New S-Triazole Derivatives

Abstract

Alkylation of 4-anilino-5-phenyl-4H-1,2,4-triazole-3-thiol (1) with some halo compounds yielded the corresponding sulfides 2a–f. Some sulfides 2e,f were cyclized to give triazolothiadiazines 3 and 4. Triazolothiadiazoles 5 and 6 were prepared through the reaction of compound 1 with carbon disulfide or ethyl orthoformate, respectively. Treatment of compound 1 with ethyl chloroformate or phenyl isothiocyanate yielded triazolo-thiadiazole and triazole 9 and 10, respectively. Reaction of compound 1 with Lawesson's reagent gave triazolothiadiazaphosphole derivative 11. Also, compound 1 underwent cyclocondensation reactions with some bidentate reagents to give triazolothiazines 4, 12, and 13. Triazolo-thiazepines and triaziepine 14–16 were synthesized via the reaction of compound 1 with β-ketoesters or ethyl cyanoacetate. Tricyclic systems 19 and 20 were prepared through the reaction of compound 4 with the appropriate reagent. Some synthesized compounds were tested for antibacterial activity.

Supplemental materials are available for this article. Go to the publisher's online edition of Phosphorus, Sulfur, and Silicon and the Related Elements to view the free supplemental file.     

Biochemical study for the effect of henna (Lawsonia inermis) on Escherichia coli

Leaf samples of Lawsonia inermis (Li) were examined for their antimicrobial potential. Broth extracts in different concentrations were prepared and bioassayed in vitro for the growth of Escherichia coli. The growth of E. coli pathogen was inhibited to various degrees by increasing the concentration of the herbal powder. In addition to the observed alterations which were detected electrophoretically in the protein pattern, were activities of the amylase enzyme and glycoprotein fractions. The protein pattern has one common band of Rf 0.47 and two characteristic bands of Rf 0.36 and Rf 0.42 for E. coli sample. The quantitative mutation was observed in the bacteria with different concentrations of L. inermis compared with the control. Some types of proteins in E. coli completely disappeared upon being S.I affected. The amylase pattern showed one common band with Rf 0.037 and two characteristic bands with Rf 0.18 and Rf 0.37 for E. coli sample. The obvious quantitative mutation observed in bacteria with different concentrations of L. inermis compared with E. coli. The glycoprotein pattern recorded one common band at R₁ with Rf 0.94 for E. coli sample and bacteria inoculated with different concentrations of L. inermis. These results confirmed the antibacterial activity of henna leaves and supported the traditional use of the plant in therapy of bacterial infections and disturbances that occurred at the biochemical level. The broth extract of the L. inermis leaves showed obvious antibacterial activity against E. coli.     

Validation of scanning electron microscope (SEM), energy dispersive X-ray (EDX) and gamma spectrometry to verify source nuclear material for safeguards purposes

Ten ore samples, two unpurified yellow cake samples and natural uranyl nitrate hexahydrate sample were analyzed by Scanning Electron Microscope (SEM) and Energy Dispersive X-ray (EDX) method to verify source nuclear material. Samples represent source nuclear material as possible. All samples were scanned at ideal conditions; working distance = 10 mm, voltage = 30 kV, magnification value = × 100, spot size = 50 to screen samples for the presence of uranium and thorium, Also Hyper pure germanium (HPGe) gamma spectrometers were applied to estimate the uranium and thorium contents in Bq/kg (ppm). For the ore samples uranium-238 ranges from 1,049.23 Bq/kg (85.30 ppm) to 2,096.06 Bq/kg (170.41 ppm), uranium-235 ranges from 47.51 to 105.61 Bq/kg and thorium-232 ranges from 22.84 Bq/kg (5.65 ppm) to 41.78 Bq/kg (10.34 ppm). For the yellow cake samples and uranyl nitrate hexahydrate uranium-238 ranges from 42.99 Bq/kg (3.50 ppm) to 71,887.2 Bq/kg (5,844.49 ppm) and thorium-232 is 4.78 Bq/kg (1.83 ppm) and the other two samples are lower than the detection limit.     

Determination of Lambda-Cyhalothrin and Malathion Residues in Locust by Gas Chromatography with Electron Capture Detection

Journal of Analytical Chemistry - A reliable, easy, and reproducible method was developed for the quantification of λ-cyhalothrin and malathion residues in desert locust. For the extraction, a...     

Preparation and dispersion stability of aqueous metal oxide nanofluids for potential heat transfer applications: a review of experimental studies

Journal of Thermal Analysis and Calorimetry - Nanofluids have recently attracted attention of many researchers due to their growing potential applications in heat transfer devices. They possess...     

Performance enhancement of the power penalty in DWDM FSO communication using DPPM and OOK modulation

This paper presents the design and performance enhancement of the power penalty (PP) in a dense wavelength division multiplexing based on free space optical communication (FSOC) link using digital pulse position modulation (DPPM) and on–off keying (OOK) modulation. Such a system has a high performance, low cost, robust and power efficient, reliable, excessive flexibility, and higher data rate for access networks. The system performance is evaluated for an 8-channel wavelength-division-multiplexing for hybrid fiber FSOC system at 2.5 Gbps on widely accepted modulation schemes under various atmospheric turbulence (AT) regimes conditions. The performance of system is introduced in terms of PP, bit-error rate (BER), transmission distance and the average received optical power. The numerical results shows that the improvement of the PP using DPPM modulation of 0.2–3.0 dB for weak turbulence (WT) regimes for BER of 10^?6 and above 20, 25 dB for strong turbulence (ST) regimes are reported for BER of 10^?6 and 10^?9, as respectively (depending on the AT level). Further, we develop of improvement the PP caused by multiple-access interference about 6.686 dB which is predicted for target BER of 10^?9 in WT and 1 dB at target BER of 10^?6 in ST when the 8 user are active on the system of optical network units. Additionally, the optical power budget and margin losses of a system are calculated with different link length. The proposed approach of DPPM merges superiority with higher enhancement of PP about 0.8 dB for BER equal 10^?9 at FSO link length l_fso?=?2000 m compared to OOK at 1 dB for WT. An improvement of 2 dB is observed using the DPPM scheme over an OOK due to capability of detect pulses under background noise conditions with increased receiver sensitivity.