Correction to: Foreword to the memorial issue for Professor Roberto Marassi

Journal of Solid State Electrochemistry -     

Foreword to the memorial issue for Professor Roberto Marassi

Journal of Solid State Electrochemistry -     

Electrocatalytic properties of platinum nanocenters electrogenerated at ultra-trace levels within zeolitic phosphododecatungstate cesium salt matrices

A unique preparation method of obtaining stable composite film (with ultra-low platinum content) highly active towards oxygen reduction and hydrogen oxidation is presented here. The matrix for platinum centers consists of high-surface-area zeolite-type acidic salt of cesium phosphododecatungstate (Cs_2.5H_0.5PW₁₂O₄₀) admixed with carbon (Vulcan XC-72) carriers. Platinum nanoparticles were deposited on the working electrode modified with matrix via corrosion of platinum counter electrode during cyclic voltammetry experiment conducted in acid electrolyte containing chloride ions. The results obtained from rotating disk voltammetry revealed that the composite film containing Pt nanoparticles at very low loadings (on the level of 2–5 μg cm^?2) demonstrated remarkable electrocatalytic activity towards both oxygen reduction and hydrogen oxidation, particularly, when compared to the performance of the Cs_2.5H_0.5PW₁₂O₄₀-free system (i.e., containing only Vulcan support) prepared and examined under analogous conditions. The phenomenon should be primarily ascribed to the mesoporous nature of the matrix enabling immobilization and stabilization of small catalytic nanoparticles (1–2 nm diameters) inside the pores as well as to high surface acidity of the polyoxometalate-based salt providing proton-rich environment at the electrocatalytic interface.     

Study of the Lithium Storage Mechanism of N-Doped Carbon-Modified Cu2S Electrodes for Lithium-Ion Batteries

Owing to their high specific capacity and abundant reserve, Cu_xS compounds are promising electrode materials for lithium-ion batteries (LIBs). Carbon compositing could stabilize the Cu_xS structure and repress capacity fading during the electrochemical cycling, but the corresponding Li⁺ storage mechanism and stabilization effect should be further clarified. In this study, nanoscale Cu₂S was synthesized by CuS co-precipitation and thermal reduction with polyelectrolytes. High-temperature synchrotron radiation diffraction was used to monitor the thermal reduction process. During the first cycle, the conversion mechanism upon lithium storage in the Cu₂S/carbon was elucidated by operando synchrotron radiation diffraction and in situ X-ray absorption spectroscopy. The N-doped carbon-composited Cu₂S (Cu₂S/C) exhibits an initial discharge capacity of 425 mAh g⁻¹ at 0.1 A g⁻¹, with a higher, long-term capacity of 523 mAh g⁻¹ at 0.1 A g⁻¹ after 200 cycles; in contrast, the bare CuS electrode exhibits 123 mAh g⁻¹ after 200 cycles. Multiple-scan cyclic voltammetry proves that extra Li⁺ storage can mainly be ascribed to the contribution of the capacitive storage.     

Temperature and potential-dependent structural changes in a Pt cathode electrocatalyst viewed by in situ XAFS

The paper presents an X-ray absorption fine structure (XAFS) investigation of Pt supported on Vulcan XC-72 operating as a cathode catalyst in a polymer electrolyte membrane fuel cell (PEM FC). XAFS spectroscopy was performed in situ using a cell developed by the authors and optimized for absorption measurements. Low-noise spectra were obtained using the transmission mode over the Pt L₃ XAFS range, enabling multiple-scattering XAFS data-analysis for the Pt nanocrystalline system under operating conditions. Accurate measurements of the local structure were performed at various potentials and working temperatures. Changes in the near-edge structures reflecting variations in the Pt electronic structure were observed for various potential values in the cathode activation region. The Pt average local geometric structure was found to be practically potential-independent. The increase in structural disorder caused by the higher working FC temperature was not found to affect the catalyst’s performance in the kinetically controlled region.     

Electrochemical study on nickel aluminum layered double hydroxides as high-performance electrode material for lithium-ion batteries based on sodium alginate binder

Journal of Solid State Electrochemistry - Nickel aluminum layered double hydroxide (NiAl LDH) with nitrate in its interlayer is investigated as a negative electrode material for lithium-ion...     

Correlation of AC-impedance and in situ X-ray spectra of LiCoO2

In-situ X-ray and AC-impedance spectra have been obtained simultaneously during the deintercalation of lithium from LiCoO2 using a specially designed electrochemical cell. The AC-dispersions have been correlated with the cell parameters obtained from the X-ray spectra. The correlation confirms previous hypothesis on the interpretation of the AC-dispersions in terms of an equivalent circuit comprising an element that relates the change of the intrinsic electronic conductivity, occurring at the early stages of deintercalation, to the semiconductor to metal transition caused by the change of the cell parameters.