排序方式: 共有124条查询结果,搜索用时 15 毫秒
1.
Niyazi Bicak Bunyamin Karagoz Umit Tunca 《Journal of polymer science. Part A, Polymer chemistry》2003,41(16):2549-2555
The controlled reaction of equimolar quantities of maleic anhydride and glycidol in dimethoxyethane gives soluble polyesters with one hydroxyl group in each repeating unit. The reaction proceeds with stepwise ring opening of the components and gives highly viscous clear solutions in relatively short periods. In the first step, monomaleate ester formation takes place around 80 °C. The ring opening of the oxirane group is the second step, and it occurs at 120 °C. The overall reaction is the formation of soluble polyesters with moderate molecular weights (6000–18,000), without the elimination of water. The soluble polyesters can be crosslinked tightly by direct heating at 190 °C without additional vinyl monomer. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2549–2555, 2003 相似文献
2.
Gurkan Hizal Umit Tunca Sermin Aras Humeyra Mert 《Journal of polymer science. Part A, Polymer chemistry》2006,44(1):77-87
Copper‐catalyzed controlled/living radical polymerization (LRP) of styrene (St) was conducted using the silica gel‐supported CuCl2/N,N,N′,N′,N″‐pentamethyldiethylenetriamine (SG‐CuCl2/PMDETA) complex as catalyst at 110 °C in the presence of a definite amount of air. This novel approach is based on in situ generation and regeneration of Cu(I) via electron transfer reaction between phenols and Cu(II). Sodium phenoxide or p‐methoxyphenol was used as a reducing agent of Cu(II) complexes in LRP. The number–average molecular weight, Mn,GPC, increases linearly with monomer conversion and agrees well with the theoretical values up to 85% conversion The molecular weight distribution, Mw/Mn, decreases as the conversion increases and reaches values below 1.2. The catalyst was recovered in aerobic condition and reused in copper‐catalyzed LRP of St. For the second run, the number–average molecular weights increased with monomer conversion and the polydispersities decreased as the polymerization proceeded and reached to the value <1.3 at 81% conversion. The recycled catalyst retained 90% of its original activity in the subsequent polymerization. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 77–87, 2006 相似文献
3.
Reduced Ni-Mo/Al(2)O(3) catalysts exhibit a behavior analogous to that of sulfided Ni-Mo/Al(2)O(3) catalysts in hydrogenation of linear aldehydes to alcohols. Similar to what has been previously reported for sulfided catalysts, NO and CO(2) can be used over the reduced Ni-Mo catalysts as probe molecules for the active sites responsible for two competing reactions -- aldehyde hydrogenation to alcohols and condensation reactions to heavy products, respectively. Reduced catalysts have a higher aldehyde conversion activity and alcohol selectivity than their sulfided counterparts. The reduction temperature has a strong effect on the surface density of anion vacancies, which are responsible for alcohol formation. Reduction temperature also plays a role in determining the abundance of OH groups on the alumina surface. The effect of reduction temperature also manifests itself through the differences seen in the oxidation states of Mo and Ni species. 相似文献
4.
Sittichai Natesakhawat Xueqin Wang Lingzhi Zhang Umit S. Ozkan 《Journal of molecular catalysis. A, Chemical》2006,260(1-2):82-94
Chromium-free iron-based catalysts were prepared and studied in regard to their performance in the high-temperature water-gas shift reaction (HTS). The effects of various catalyst preparation variables (i.e., Fe/promoter ratio, pH of precipitation medium, calcination and reduction temperatures) and preparation methods were investigated. Aluminum is a potential chromium replacement in HTS catalysts. Further improvement in WGS activity of Fe–Al catalysts can be achieved by the addition of small amounts of copper or cobalt. Catalysts were characterized using BET surface area measurements, temperature-programmed reduction (TPR), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS). As a textural promoter, aluminum and chromium prevent the sintering of iron oxides and stabilize magnetite phase by retarding its further reduction to FeO and metallic Fe. The promotional effect of Cu is found to be strongly dependent on the preparation method. 相似文献
5.
Meng-Che Tu Deepa Rajwar Gopal Ammanath Palaniappan Alagappan Umit Hakan Yildiz Bo Liedberg 《Analytica chimica acta》2016
A colorimetric Al3+ sensor based on fluorescence recovery of a conjugated copolymer-ATP complex is proposed. An optimized ratio of two polythiophene (PT) monomers is utilized to synthesize copolymer (CP) that yielded maximized colorimetric response for Al3+ in deionized (DI) and tap water. The electrostatic disassembly of CP-ATP upon addition of Al3+ led to an evident visual color change. The lowest concentration of Al3+ for naked eye observation is around 4 μM, which is below the threshold levels in drinking water according to European Economic Community (EEC) standard. Besides, the proposed assay showed a similar response to Al3+ in tap water. The proposed methodology showed selective and sensitive detection for Al3+ in analytically relevant concentration ranges without involving sophisticated instrumentation, illustrating the applicability for on-site drinking water monitoring. 相似文献
6.
Latif Elçi Ümit Divrikli Mustafa Soylak 《International journal of environmental analytical chemistry》2013,93(10):711-723
A simple, economic and sensitive method for selective determination of As(III) and As(V) in water samples is described. The method is based on selective coprecipitation of As(III) with Ce(IV) hydroxide in presence of an ammonia/ammonium buffer at pH 9. The coprecipitant was collected on a 0.45 µm membrane filter, dissolved with 0.5 mL of conc. nitric acid and the solution was completed to 2 or 5 mL with distilled water. As(III) in the final solutions was determined by graphite furnace atomic absorption spectrometry (GFAAS). Under the working condition, As(V) was not coprecipitated. Total inorganic arsenic was determined after the reduction of As(V) to As(III) with NaI. The concentration of As(V) was calculated by the difference of the concentrations obtained by the above determinations. Both the determination of arsenic with GF-AAS in presence of cerium and the coprecipitation of arsenic with Ce(IV) hydroxide were optimised. The suitability of the method for determining inorganic arsenic species was checked by analysis of water samples spiked with 4–20 µg L?1 each of As(III) and As(V). The preconcentration factor was found to be 75 with quantitative recovery (≥95%). The accuracy of the present method was controlled with a reference method based on TXRF. The relative error was under 5%. The relative standard deviations for the replicate analysis ( n?=?5) ranged from 4.3 to 8.0% for both As(III) and As(V) in the water samples. The limit of detection (3σ) for both As (III) and As(V) were 0.05 µg L?1. The proposed method produced satisfactory results for the analysis of inorganic arsenic species in drinking water, wastewater and hot spring water samples. 相似文献
7.
Hakan Durmaz Aydan Dag Alp Hizal Gurkan Hizal Umit Tunca 《Journal of polymer science. Part A, Polymer chemistry》2008,46(21):7091-7100
3‐Arm star‐block copolymers, (polystyrene‐b‐poly(methyl methacrylate))3, (PS‐b‐PMMA)3, and (polystyrene‐b‐poly(ethylene glycol))3, (PS‐b‐PEG)3, are prepared using double‐click reactions: Huisgen and Diels–Alder, with a one‐pot technique. PS and PMMA blocks with α‐anthracene‐ω‐azide‐ and α‐maleimide‐end‐groups, respectively, are achieved using suitable initiators in ATRP of styrene and MMA, respectively. However, PEG obtained from a commercial source is reacted with 3‐acetyl‐N‐(2‐hydroxyethyl)‐7‐oxabicyclo[2.2.1]hept‐5‐ene‐2‐carboxamide (7) to give furan‐protected maleimide‐end‐functionalized PEG. Finally, PS/PMMA and PS/PEG blocks are linked efficiently with trialkyne functional linking agent 1,1,1‐tris[4‐(2‐propynyloxy)phenyl]‐ethane 2 in the presence of CuBr/N,N,N′,N″,N″‐pentamethyldiethylenetriamine (PMDETA) at 120 °C for 48 h to give two samples of 3‐arm star‐block copolymers. The results of the peak splitting using a Gaussian deconvolution of the obtained GPC traces for (PS‐b‐PMMA)3 and (PS‐b‐PEG)3 displayed that the yields of target 3‐arm star‐block copolymers were found to be 88 and 82%, respectively. © Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46: 7091–7100, 2008 相似文献
8.
Aydan Dag Hakan Durmaz Gurkan Hizal Umit Tunca 《Journal of polymer science. Part A, Polymer chemistry》2008,46(1):302-313
Diels–Alder click reaction was successfully applied for the preparation of 3‐arm star polymers (A3) using furan protected maleimide end‐functionalized polymers and trianthracene functional linking agent (2) at reflux temperature of toluene for 48 h. Well‐defined furan protected maleimide end‐functionalized polymers, poly (ethylene glycol), poly(methyl methacrylate), and poly(tert‐butyl acrylate) were obtained by esterification or atom transfer radical polymerization. Obtained star polymers were characterized via NMR and GPC (refractive index and triple detector detection). Splitting of GPC traces of the resulting polymer mixture notably displayed that Diels–Alder click reaction was a versatile and a reliable route for the preparation of A3 star polymer. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46: 302–313, 2008 相似文献
9.
Eda Gungor Gurkan Hizal Umit Tunca 《Journal of polymer science. Part A, Polymer chemistry》2008,46(20):6703-6711
The terminal alkyne homocoupling reaction (oxidative alkyne coupling) is presented here as a new route for the preparation of A2B2 type 4‐miktoarm star copolymer. The block copolymer with terminal alkyne at the junction point prepared by NMP‐ATRP and ROP‐NMP sequential routes is coupled via diyne formation to give (PS)2‐(PMMA)2 and (PCL)2‐(PS)2 4‐miktoarm star polymers, respectively, by using a combination of (PPh3)2PdCl2/PPh3/CuI in a solvent mixture of Et3N/CH3CN at room temperature for 72 h. The molecular weight, intrinsic viscosity ([η]), radius of gyration (Rg), and hydrodynamic radius (Rh) of A2B2 4‐miktoarm star copolymers were calculated using triple‐detection GPC as results of three detectors response. © 2008 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46: 6703–6711, 2008 相似文献
10.
Eda Gungor Cigdem Bilir Hakan Durmaz Gurkan Hizal Umit Tunca 《Journal of polymer science. Part A, Polymer chemistry》2009,47(22):5947-5953
Azidopropyl‐heptaisobutyl‐substituted polyhedral oligomeric silsesquioxane (POSS‐N3) was reacted with 1,1,1‐tris[4‐(2‐propynyloxy)phenyl]‐ethane ( 1 ) and poly(ethylene glycol) (PEG)‐b‐poly(methyl methacrylate) (PMMA) copolymer with alkyne at its center (PEG‐PMMA‐alkyne) affording the first time synthesis of 3‐arm star POSS and PEG‐PMMA‐POSS 3‐miktoarm star terpolymer, respectively, in the presence of CuBr/N,N,N′,N″,N″‐pentamethyldiethylenetriamine as catalyst and N,N‐dimethylformamide/tetrahydrofuran as solvent at room temperature. The precursors and the target star polymers were characterized comprehensively by 1H NMR, GPC, and DSC. © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 47: 5947–5953, 2009 相似文献