Determination of affinity constants and response factors of the noncovalent dimer of gramicidin by electrospray ionization mass spectrometry and mathematical modeling

The dimerization of gramicidin, a 15-residue membrane peptide, in solution can be viewed as a model for protein-protein interactions. We reported previously that the dimer can be observed when electrosprayed from organic solvents and that the abundances of the dimer depends on the dielectric constant of the solvent. Here, we report an effort to determine an affinity constant for the dimerization of gramicidin by using gas-phase abundance. Two issues affecting the determination are the electrospray-induced dissociation of the dimer and discrimination in the electrospray of the dimer compared with the monomer. Other methods developed for the purpose of determining affinity from mass spectral abundance do not address the dissociation of the complex in the gas phase or can not be applied for cases of low affinity constant, K(a). We present a mathematical model that uses the ratio of the signal intensities of the dimer and the monomer during a titration. The model also incorporates the dissociation and an electrospray ionization-response factor of the dimer for extracting the affinity constant for the dimerization of gramicidin. The dimerization constants from the new method agree within a factor of two with values reported in the literature.     

An organocatalytic enantioselective synthesis of (+)-duryne

An efficient enantioselective synthesis of the potent anticancer agent (+)-duryne was achieved by the use of a one-pot organocatalyzed hydroxylation/Ohira–Bestmann and Grubbs cross-metathesis/selective cis-Wittig reaction. This new approach is envisioned to facilitate the synthesis of every representative member of the family.     

Properties of Graphene/Waterborne Polyurethane Nanocomposites Cast from Colloidal Dispersion Mixtures

Nanocomposites of waterborne polyurethane (WPU) reinforced with functionalized graphene sheets (FGSs) were effectively prepared by casting from a colloidal dispersion of FGS and WPU, and the morphology and physical properties were examined. The finer aqueous FGS dispersions or WPU with smaller particles yielded nanocomposites with enhanced electrical conductivity and thermal resistance due to finely dispersed FGS. The FGS nucleated the crystallization of the polycaprolactone (PCL) segments in WPU and improved its modulus. However, FGS inhibited crystal growth and deteriorated the tensile properties at high deformation, i.e., tensile strength and elongation at break, because the interaction between FGS and WPU hindered the chain rearrangement of WPU in the nanocomposite.     

Microwave–assisted synthesis of <Emphasis Type="Italic">submicrometer</Emphasis> GaO(OH) and Ga<Subscript>2</Subscript>O<Subscript>3</Subscript> rods

Submicrometer sized gallium oxide hydroxide (GaO(OH)) and gallium oxide (Ga₂O₃) rods have been successfully fabricated on a large scale by refluxing an aqueous solution of Ga(NO₃)₃ and NH₄OH in a simple domestic microwave oven (DMO). The structures, morphologies, compositions and physical properties of the as–synthesized and calcined products have been characterized by powder X-ray diffraction (XRD), transmission electron microscopy (TEM), selected area electron diffraction (SAED), selected area energy dispersive X-ray spectroscopy (SAEDS), thermo gravimetric analysis (TGA), differential scanning calorimetry (DSC), and energy dispersive X-ray (EDX) analysis. TEM images show that submicrometer sized as–synthesized Ga O(OH) rods have diameters of 0.3–0.5 m and lengths of 3.2–3.5 m. The calcined product consists of submicrometer rods with diameters of 0.4–0.5 m and lengths of 5–5.5 m. XRD, EDX and SAED analysis together indicate that the as–synthesized product has an orthorhombic gallium oxide hydroxide (GaO(OH)) crystal structure, and that the calcined product is rhombohedral Ga₂O₃. A possible mechanism for the formation of submicrometer sized GaO(OH) rods is discussed briefly.     

Nernst effect and diamagnetism in phase fluctuating superconductors

We study superconducting systems in the regime where superconductivity is destroyed by phase fluctuations. We find that the Nernst effect has a much sharper temperature decay than predicted by Gaussian fluctuations, with an onset temperature that tracks Tc rather than the pairing temperature. We find a close quantitative connection with diamagnetism--the ratio of magnetization to transverse thermoelectric conductivity reaches a fixed value at high temperatures. We interpret measurements on underdoped cuprates in terms of a dilute vortex liquid over a wide temperature range above Tc.     

Termolecular chemistry facilitated by radical-radical recombinations and its impact on flame speed predictions

Recent theoretical studies have shown that termolecular chemistry can be facilitated through reactions of flame radicals (H, O, and OH) or O₂ with highly-energized collision complexes (either radical or stable species) formed in exothermic reactions. In this work, radical-radical recombination reaction induced termolecular chemistry and its impact on combustion modeling was studied. Two recombination reactions, H + CH₃ + M → CH₄ + M and H + OH + M → H₂O + M, were analyzed using ab-initio master equation analyses guided by quasiclassical trajectory results. The dynamics results and the master equation calculations indicate that CH₄^? and H₂O^? (formed in the two radical-radical reactions outlined above) react rapidly with flame radicals and O₂ at rates that are competitive with collisional cooling. The addition of these processes into conventional combustion modeling requires two modifications: the inclusion of the new nonthermal termolecular reaction rates and the simultaneous reduction of the competing recombination reaction rates. The former is described with newly derived Arrhenius expressions based on quasiclassical trajectories, and the latter is achieved by perturbing the recombination reaction rate during the simulation. Kinetic modeling was used to gauge the impact of including this nonthermal chemistry for H₂/CH₄-air laminar flames speeds. Inclusion of this nonthermal chemistry has a noticeable impact on simulated flame speeds. The procedure developed here can be utilized to properly quantify the effects of such nonthermal reactions in macroscopic kinetic models.     

Sensitive and selective spectrophotometric methods for the determination of pheniramine maleate in bulk drug and in its formulations using sodium hypochlorite

Two simple, selective and sensitive spectrophotometric methods are described for the determination of pheniramine maleate (PAM) in pure and dosage forms. The method is based on the reaction of PAM with hypochlorite in the presence of Kolthoff buffer (phosphate-borate) of pH 7.0 to form the chloro derivative of PAM, destruction of the excess hypochlorite by nitrite ion (the chloro derivative of drug is unaffected under the optimized conditions) followed by the oxidation of iodide with the chloro derivative of PAM to iodine (I ₃ ^? which is either measured directly at 355 (method A) or reacted with starch to form a blue chromogen measurable at 590 nm (method B). The optimum conditions that affect the reaction were ascertained, and under these conditions linear relationship was obtained in the concentration ranges of 2–50 and 1–25 μg/mL PAM in methods A and B, respectively. The calculated molar absorptivity values are 7.26 × 10³ and 1.28 × 10⁴ L/(mol cm) for method A and method B, respectively. Sandell’s sensitivity values, limits of detection (LOD) and quantification (LOQ) are calculated as per ICH guidelines. The proposed methods were applied successfully to the determination of PAM in tablets and injection with good accuracy and precision and without interferences from common additives. The results obtained by the proposed methods were compared favourably with those of the reference method. The accuracy and reliability of the proposed methods were further checked by recovery studies via standard addition procedure.     

Synthesis,structure and reactivity of a macrocyclic imine: aza-[13]-macrodiolides

The in situ synthesis and subsequent reactions of macrocylic imine 2 are reported. The imine was trapped with cyanotrimethylsilane to give α-amino nitrile aza-[13]-macrodiolides in a 1:1 ratio of diastereomers. A crystal structure of the syn α-cyano nitrile diastereomer, 7a, provided insights into the lack of selectivity in reactions of 2 relative to macrocyclic alkene 1. Reactions to functionalize the syn diastereomer 7a are also reported.     

Complexes of a new series of α-diimine macrocycles,I: Template synthesis of cadmium(II) complexes of tetraazamacrocycles derived from 2,3-butanedione or benzil

Summary Cadmium(II) complexes of the type [CdL] (NO₃)₂ (whereL = tetraazamacrocycle with a 12 to 32-membered ring) have been synthesized by the reactions of 2,3-butanedione or benzil with different aliphatic diamines viz. ethylenediamine, 1,3-diaminopropane, 1,4-diaminobutane, 1,6-diaminohexane, 1,8-diaminooctane and 1,12-diaminododecane in the presence of Cd(II) as template. These complexes have been characterized by elemental analyses, conductivity measurements and IR and NMR spectral studies.

---

Komplexe einer neuen Serie von -Diimin-Macrocyclen, 1. Mitt.: Synthese von Cadmium(II)-Komplexen von Tetraazamacrocyclen aus 2,3-Butandion oder Benzil

Zusammenfassung Es wurden Cadmium(II)-Komplexe des Typs [CdL] (NO₃)₂ (wobeiL einen 12-bis 32-gliedrigen Tetraazamacrocyclus darstellt) mittels der Reaktion von 2,3-Butandion oder Benzil mit verschiedenen aliphatischen Diaminen (Ethylendiamin, 1,3-Diaminopropan, 1,4-Diaminobutan, 1,6-Diaminohexan, 1,8-Diaminooctan und 1,12-Diaminododecan) hergestellt. Die Komplexe wurden mittels Elementaranalyse, Leitfähigkeitsmessungen und Infrarot- bzw. Kernresonanzspektroskopie charakterisiert.