On fixed point and almost fixed point problems of lower semicontinuous type multivalued mappings

In the present paper, some new almost fixed point theorems and fixed point theorems for lower semicontinuous type multivalued mappings are obtained in metrizable H-spaces.     

On the existence of positive solutions for a class of singular boundary value problems

In this paper, by the use of a fixed point theorem, many new necessary and sufficient conditions for the existence of positive solutions in C[0,1]∩C¹[0,1]∩C²(0,1) or C[0,1]∩C²(0,1) are presented for singular superlinear and sublinear second-order boundary value problems. Singularities at t=0, t=1 will be discussed.     

利用"对比法"判断气体状态参量的变化趋势

理想气体的温度、体积和压强三个状态参量之间的关系由气体状态方程pV/T=恒量决定。当气体状态发生变化时，判断某一个参量的变化趋势是一个比较复杂的问题。如图1，为p—T图中的状态变化曲线，状态由A变化到B，判断体积的变化趋势。     

断续喷洒去溶电热雾化法在电感耦合等离子体原子发射光谱方法中的应用研究

本文所讨论的电热雾化法是采用继续喷洒去溶技术,使试样在石墨炉表面逐步积累的进样方法。文章简要介绍了实验条件的选择和控制以及石墨炉装置的结构,探讨了提高电热雾化法相对检测能力的途径。实验结果表明:谱线黑度值与试样积累时间的对数值之间具有较好的线性关系。     

VOCs控制催化剂的研制

以堇青石蜂窝陶瓷体为第一载体、γ-Al2O3为第二载体,制成的含稀土La和过渡金属元素的复合氧化物催化剂,在连续流动的反应体系上评价了催化剂对苯、氰氢酸、乙酸和氯苯等VOCs的氧化反应活性.结果表明: 采用LaCuMn组合制备的催化剂,La的含量在7%～10%左右、Cu的含量在5.5%左右、Mn的含量在7.5%左右时,第二载体γ-Al2O3的负载以采用半胶、pH值4～5、加入某些活性剂、负载量以7%～10%、活化温度为400～500 ℃时制成的催化剂的活性最好,研制的VOCs控制催化剂对各种VOCs均具有很高的催化活性.     

Structural and photocatalytic properties of the new solid photocatalyst In2BiTaO7

In₂BiTaO₇ was synthesized using the solid-state reaction method and its photocatalytic properties were investigated. The results of powder X-ray diffraction (XRD) indicated that the compound crystallizes in the pyrochlore-type structure, cubic system with space group Fd-3m. The lattice parameter is 10.6972(1) ?. In addition, the compound shows strong optical absorption in the visible region (λ > 420 nm) and the band gap of In₂BiTaO₇ was estimated to be about 2.47 eV. For the photocatalytic reaction, H₂ or O₂ evolution was observed from CH₃OH/H₂O or AgNO₃ solution respectively with In₂BiTaO₇ as the photocatalyst under visible light irradiation, indicating that In₂BiTaO₇ is responsive to visible light for splitting water. Furthermore, the catalyst remained photoactive in the wavelength range up to 510 nm. Photocatalytic degradation of methylene blue (MB) dye over the compound was further investigated under visible light irradiation. The results showed that complete removal of aqueous MB could be achieved after irradiation for 135 min over In₂BiTaO₇. Furthermore, under visible light irradiation In₂BiTaO₇ showed markedly higher catalytic activity compared to P-25 for MB photocatalytic degradation.     

An Unsupervised Video Stabilization Algorithm Based on Key Point Detection

In recent years, video stabilization has improved significantly in simple scenes, but is not as effective as it could be in complex scenes. In this study, we built an unsupervised video stabilization model. In order to improve the accurate distribution of key points in the full frame, a DNN-based key-point detector was introduced to generate rich key points and optimize the key points and the optical flow in the largest area of the untextured region. Furthermore, for complex scenes with moving foreground targets, we used a foreground and background separation-based approach to obtain unstable motion trajectories, which were then smoothed. For the generated frames, adaptive cropping was conducted to completely remove the black edges while maintaining the maximum detail of the original frame. The results of public benchmark tests showed that this method resulted in less visual distortion than current state-of-the-art video stabilization methods, while retaining greater detail in the original stable frames and completely removing black edges. It also outperformed current stabilization models in terms of both quantitative and operational speed.     

神光-Ⅲ主机装置MJ级能源系统研制现状

介绍了神光-Ⅲ主机装置能源系统的功能要求、组成结构和设计方法,以及关键单元器件的功能要求和设计方法。该系统是片状放大器系统的重要组成部分,由6个束组共108套最大储能为1.2 MJ的能源模块组成,总储能达到110 MJ（最大130 MJ）。每套模块产生一个脉宽610 s(10 %峰值)的电流脉冲,驱动10组、共20支氙灯,为片状放大器提供泵浦能量,峰值电流为0.25 MA。目前投入试运行的36套能源模块的各项电气性能指标满足设计要求,能确保片状放大器小信号增益系数达到5.0%/cm,为片状放大器提供足够的泵浦能量,满足激光器的能量需求。     

Highly Effective Proton-Conduction Matrix-Mixed Membrane Derived from an -SO3H Functionalized Polyamide

Developing a low-cost and effective proton-conductive electrolyte to meet the requirements of the large-scale manufacturing of proton exchange membrane (PEM) fuel cells is of great significance in progressing towards the upcoming “hydrogen economy” society. Herein, utilizing the one-pot acylation polymeric combination of acyl chloride and amine precursors, a polyamide with in-built -SO₃H moieties (PA-PhSO₃H) was facilely synthesized. Characterization shows that it possesses a porous feature and a high stability at the practical operating conditions of PEM fuel cells. Investigations of electrochemical impedance spectroscopy (EIS) measurements revealed that the fabricated PA-PhSO₃H displays a proton conductivity of up to 8.85 × 10⁻² S·cm⁻¹ at 353 K under 98% relative humidity (RH), which is more than two orders of magnitude higher than that of its -SO₃H-free analogue, PA-Ph (6.30 × 10⁻⁴ S·cm⁻¹), under the same conditions. Therefore, matrix-mixed membranes were fabricated by mixing with polyacrylonitrile (PAN) in different ratios, and the EIS analyses revealed that its proton conductivity can reach up to 4.90 × 10⁻² S·cm⁻¹ at 353 K and a 98% relative humidity (RH) when the weight ratio of PA-PhSO₃H:PAN is 3:1 (labeled as PA-PhSO₃H-PAN (3:1)), the value of which is even comparable with those of commercial-available electrolytes being used in PEM fuel cells. Additionally, continuous tests showed that PA-PhSO₃H-PAN (3:1) possesses a long-life reusability. This work demonstrates, using the simple acylation reaction with the sulfonated module as precursor, that low-cost and highly effective proton-conductive electrolytes for PEM fuel cells can be facilely achieved.