Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Solid Lipid Nanoparticles (SLNs): Preparation and Properties of Calix[4]resorcinarene Derived Systems.

Solid Lipid Nanoparticles (SLNs) have been prepared fromc-2,c-8,c-14,c-20-tetraundecyl-4,6,10,12,16,18,22,24-octahydroxyresorc[4]areneas colloidal suspensions. Photon Correlation Spectroscopy studies revealed aparticle hydrodynamic diameter of 150 nm. Non-contact mode Atomic ForceMicroscopy allows observation of the particles as slightly flattened sphericalobjects of 236 (±40) nm diameter and 145 (±40) nm height. Thestudy of the preparation parameters showed that shear force does not affectthe hydrodynamic size of the SLNs. In contrast, the viscosity and the pH ofthe aqueous phase, the amphiphile concentration in the organic phase and thevolume of organic phase used, all lead to variation in the size of the particles.In term of post preparation parameters only the ionic strength has been shownto affect significantly the particle size; while the pH of the storing solution,microwave, ultrasonic and thermal treatments do not. Short and long-termstability studies have been performed to measure the effect of the ionic strengthon the stability of the particles. The use of carbohydrate cryoprotectants does notallow re-dispersion of the colloidal suspension after freeze-drying.     

Latin Squares without Orthogonal Mates

In 1779 Euler proved that for every even n there exists a latin square of order n that has no orthogonal mate, and in 1944 Mann proved that for every n of the form 4k + 1, k ≥ 1, there exists a latin square of order n that has no orthogonal mate. Except for the two smallest cases, n = 3 and n = 7, it is not known whether a latin square of order n = 4k + 3 with no orthogonal mate exists or not. We complete the determination of all n for which there exists a mate-less latin square of order n by proving that, with the exception of n = 3, for all n = 4k + 3 there exists a latin square of order n with no orthogonal mate. We will also show how the methods used in this paper can be applied more generally by deriving several earlier non-orthogonality results.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

Constructing Space for Science at the Royal Institution of Great Britain

Those who have worked in the Royal Institution of Great Britain have, since its foundation in 1799, made significant contributions to scientific knowledge, to its practical application, and to its communication to a wide variety of audiences. Such work cannot be carried out in an architectural vacuum, and in this paper we examine how the buildings of the Royal Institution, 20 and 21 Albemarle Street in central London, have shaped the work undertaken within its walls and how, on a number of occasions, the buildings have been reconfigured to take account of the evolving needs of scientific research and communication. This paper is based on the Conservation Plan of the Royal Institution that we wrote during 2003. The Conservation Plan did not examine the land owned by the Royal Institution to the north (i.e., 22 and 23 Albemarle Street; for this area see Richard Garnier, “Grafton Street, Mayfair,” Georgian Group Journal 13 (2003), 210–272), but it did discuss 18 and 19 Albemarle Street. In this paper we concentrate on the core Royal Institution buildings at 20 and 21 Albemarle Street. Other studies of the relationship of architecture,space, and science include Crosbie Smith and Jon Agar, ed., Making Space for Science: Territorial Themes in the Shaping of Knowledge (Basingstoke: Macmillan, 1997); Peter Galison and Emily Thompson, ed., The Architecture of Science (Cambridge, Mass.: MIT Press, 1999); and Sophie Forgan,“The architecture of science and the idea of a university,” Studies in History and Philosophy of Science 20 (1989), 405–434. Frank A.J.L. James is Professor of the History of Science at the Royal Institution; he has written widely on the history of nineteenth-century science in its social and cultural contexts and is editor of the Correspondence of Michael Faraday. He is President of the British Society for the History of Science. Anthony Peers is an Associate of Rodney Melville and Partners where he works in the field of building conservation as an architectural historian. He is a Council member of the Ancient Monument Society.