Growth of NaBi（WO4）2 Dendrite and Mechanism

The solid-liquid interface motion of NaBi（WO4）2 （NBWO） melt crystal growth is observed in an in situ system, in which the whole processes of interface transition from fiat interface and cellular to dendrite are visualized. The spacing of the dendrite under smaller temperature gradient turns out to be larger than that under larger temperature gradient, which is found to be sensitive to the temperature distribution. The mechanism of dendrite growth of NBWO is studied based on the model of the growth units of anion coordination polyhedra. The { 001} face has two apex links, so it shows higher stability and has high growth rate and forms the arm of dendrite, whereas the {010} face has only one apex link, and thus shows relative slower growth rate and firstly forms the branches.     

Eucaglobulin, A New Complex of Gallotannin and Monoterpene from Eucalyptus globulus

EucalyPtusgl0bulusLabill.(Myrtaceae)isakindofmedicinalplantwidelydistributedintheYunnanpr0vinceofChina.ItSleaves,rootSandffoitShavebeenusedastraditionalremediesforthetreatmentofinfluenza,dysentery,enteritis,rheumatalgiaandbleeding.BesidesvolatileterpenoidconstituentSintheessential0iloftheleavesandfruits,theoccurrenceofanumber0fphloroglucinol-sesquiterpene-or-m0n0terpene-c0upledcomPoundsnamedmacrocarpals'andeugl0bals'intheleavesandbudshasbeenrepofted.Inordertostudythechendcalandbioactivecon…     

高固含量聚合物乳液制备方法新进展

高固含量一直是聚合物乳液制备追求的目标 ,本文将高固含量 (>6 0 % )聚合物乳液的制备方法按机理分为控制乳胶粒直径分布 ,增大乳胶粒直径和使乳胶粒发生形变三类 ,详细评述了各种制备方法的研究进展 ,并对高固含量乳液制备的发展进行了展望。     

A new anode material LiMoS2 for use in rechargeable Lithium Ion Batteries

The novel applications of molybdenum disulfide in recent research were reviewed, such as in lubricant, catalyst and photoelectrochemical solar cells. Recently, we found that LiMoS2 is a good candidate for new anode materials for lithium ion batteries with high lithium storage capacity.Here, the anode material LiMoS2 was synthesized by a hydrothermal method at 150℃ and the electrochemical characterization as an anode material for lithium ion batteries was examined.put in Teflon-lined stainless steel autoclaves of capacity 40 mL. Distilled water was used to fill the autoclaves to 70 % of the total volume. The autoclaves were maintained at 150℃ for 24 h and then cooled naturally. The resulting dark-gray powders were filled and washed with distilled water,diluted hydrochloric acid and ethanol, successively. The final products were dried at 80℃ for 24 h.The powder X-ray diffraction pattern showed the prepared LiMoS2 was amorphous structure. A test cell using LiMoS2 as the active material was discharged and charged between 3 and 0.01 V with respect to Li metal at a constant current density of C/5 (that is, one lithium per formula unit in 5 hours). During the first discharge, the potential rapidly drops to reach a large plateau at 2.2 V, then slowly drops to the other plateau at 0.8 V, and then continuously decreases down to 0.01V. There is only a plateau at 1.35 V in the subsequent discharge curves. The plateaus of charge potential appear at about 1.9 V.The irreversible loss was 41% in the first cycle. The ratio of discharge and charge is more than 99%in the subsequent cycles. Moreover, the ratio of discharge and charge almost reaches 100% after thedemonstrated that LiMoS2 has a very high capacity and a good cycle-ability as an anode material forlithium ion batteries.     

两种气相色谱固定相的研究

使用硫杂冠醚、穴醚[2.2.2]作气相色谱固定相制备毛细管柱,考察两种固定相的使用比例、极性、热稳定性,并对甲苯-苯、乙苯-甲苯、甲基苯酚（o/p）、二氯苯（o/p,m）、硝基氯化苯（m,o）、苯-环己烷、庚醇-辛醇、苯胺-N,N二甲基苯胺等混合样品进行色谱分离.实验结果表明：两种固定相在OV-1701中的比例均为15%时有较好的分离效果,都属于中等极性的固定相.硫杂冠醚、穴醚[2.2.2]的平均极性分别为815、832,其中硫杂冠醚固定相的热稳定性较好,有较高的使用温度（185℃）,而穴醚[2.2.2]的最高使用温度为120℃,因此穴醚[2.2.2]的使用温度受到一定的限制.从它们较好的分离性能看,固定相硫杂冠醚、穴醚[2.2.2]均具有较好的应用前景.     

光度法测定奶粉中铁

1-(2-吡啶偶氮)-2-萘酚(PAN)是用作金属指示剂和显色剂的常用试剂。由于其水溶性较差,在检测过程中常加入有机溶剂或表面活性剂[1-3]。本文采用非离子表面活性剂OP作增溶剂,研究了铁(Ⅱ)与PAN的显色条件,在760 nm测定波长附近试剂及大多数金属离子的配合物无吸收,无须进行掩蔽可直接测定微量铁。该方法选择性高,操作简便,快速,用于奶粉中铁的测定,铁(Ⅱ)的质量浓度在0~60μg/25 mL范围内符合比耳定律,配合物的表观摩尔吸光率为1.5×104L·mol-1·cm-1。1试验部分1.1仪器与试剂721型分光光度计;pHS-3C型pH计。铁(Ⅱ)标准溶液:10 mg·L-…     

Current Reversal Due to Coupling Between Asymmetrical Driving Force and Ratchet Potential

Transport of a Brownian particle moving in a periodic potential is investigated in the presence of an asymmetric unbiased external force. The asymmetry of the external force and the asymmetry of the potential are the two ways of inducing a net current. It is found that the competition of the spatial asymmetry of potential with the temporal asymmetry of the external force leads to the phenomena like current reversal. The competition between the two opposite driving factors is a necessary but not a sufficient condition for current reversals.     

缓冲层ZnPc对有机电致发光器件特性的影响

本文研究了酞菁锌(ZnPc)薄膜的表面形貌及ZnPc薄膜作为缓冲层对有机电致发光器件(OLEDs)光电特性的影响.对比两组样品的AFM图像,ZnPc薄膜相比于ITO薄膜,其表面的岛面积较大,薄膜表面更连续平整,基本上覆盖了ITO膜表面针孔,减少了表面的缺陷.另外,ZnPc薄膜的岛分布均匀有序.使用ZnPc作为缓冲层的器件性能明显好于未使用ZnPc修饰的器件,在7.42V的驱动电压下的最大发光亮度达到1.428kcd/m2,在4.3V电压驱动下时,最大光功率效率为1.411m/W;而未使用缓冲层的器件在8V的驱动电压下达到最大发光亮度达到1.212kcd/m2,在5.5V电压驱动下时,最大光功率效率为0.931m/W.     

In situ observation of NaBi(WO4)2 dendrite growth and the study on microstructure of solidification

The dendrite growth process of transparent NaBi(WO4)2 with small prandtl and high melting point was studied by using the in-situ observation system. According to the dynamic images and detailed information, there are two kinds of restriction effect on the dendrite growth, the competition between arms and branches and the convection in the melt. The dendrite growth rate was time dependent, and the rate of arm growth reached the maximum 5.8 mm/s in the diffusive-advective region and rapidly decreased in the diffusive-convective region. The growth rate of branch had the same change trends as the arm's. Based on the EPMA-EDS data of solidification structure of quenched NaBi(WO4)2 melt, it was found that there were component differences from stoichiometric concentration in the melt near the interface during the growth process.