NiTi合金中马氏体相的低频力学谱研究

我们用最近研制成功的LMA型低频力学谱测试系统对NiTi合金马氏体相进行了在很大频率范围内（0．003～1Hz）的低频等温力学谱和温度谱的测量．我们研究的形状记忆合金NiTi（Ni50．2at％）试样长34mm，直径1mm细丝．经一定热处理，分别在333K．343K和353K做了内耗随频率的变化的测量。实验表明：频率越小，内耗越大，也就是内耗随频率减少而增大。同时我们采用阶梯升温的方法在八个温度下每个温度测量三种频率（1Hz，0．1Hz，0．01Hz）的内耗，结果清楚地表明：不同频率下，内耗峰都出现在372K（99℃）。而且频率越低，峰高越高。这是具有相变峰的特点：相变峰的峰温不随测量频率不同而变化，相变峰高度随频率减少而增大。我们还测量了在1Hz与0．5Hz频率下内耗随温度的变化。本文用马氏体相的位错理论初步讨论了上述实验结果。     

一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

半导体激光自混频干涉式传感器中的干涉与调制

应用F-P模型，阐述了半导体激光自混频干涉式传感器的干涉与调制过程，同时给出了相应的计算．     

Harmonic beam splitter design and fabrication

Two problems of half-wave hole and high ripples in the transmittance region for a harmonic beam splitter had been pointed out and analyzed. Based on the application of a half-wavelength control and a new admittance matching methods, a harmonic beam splitter was designed and fabricated. The former method eliminated the half-wave hole fundamentally, and the latter smoothed high ripples in the transmittance region effectively. The matching stack consisted of a symmetrically periodic structure and provided a complete matching at the desired wavelength, i.e., both conditions for the equivalent admittance and phase thickness were fulfilled. Furthermore, both the theoretical and the tested curves had been given, and a good agreement between them was obtained.     

Structure and Photoluminescence of Nano-ZnO Films Grown on a Si （100） Substrate by Oxygen- and Argon-Plasma-Assisted Thermal Evaporation of Metallic Zn

Nano-ZnO thin films were prepared by oxygen- and argon-plasma-assisted thermal evaporation of metallic Zn at low temperature, followed by low-temperature annealing at 300℃ to 500℃ in oxygen ambient. X-ray diffraction patterns indicate that the nano-ZnO films have a polycrystalline hexagonal wurtzite structure. Raman scattering spectra demonstrate the existence of interface layers between Zn and ZnO. Upon annealing at 400℃ for i h, the interface mode disappears, and photoluminescence spectra show a very strong ultraviolet emission peak around 381 nm. The temperature-dependent PL spectra indicate that the UV band is due to free-exciton emission.     

神经网络自适应滤波器在故障诊断中的应用

分析了用自适应滤波器进行故障诊断的方法．针对该方法在计算上要花费大量时间、难于完成实时诊断任务的缺点，提出了用神经网络自适应滤波器来完成故障诊断的方法．神经网络有极快的运行速度，能很好地完成实时诊断任务．     

钢管单芯棒圆周剪切法的实验研究

介绍钢管圆周剪切的另一种方法－单芯棒圆周剪切法。通过运动学分析阐述了剪切金属的变形原理；实验研究证明了该方法的可行性并对切口断面质量进行了分析。     

葫芦科几种瓜类植物花粉扫描电镜的研究

本文用扫描电镜观察了11种瓜类植物花粉,其图象清晰,可供开展蜂花粉、分类鉴定及侦破工作参考。     

Interface roughness, surface roughness and soft X-ray reflectivity of Mo/Si multilayers with different layer number

A series of Mo/Si multilayers with the same periodic length and different periodic number were prepared by magnetron sputtering, whose top layers were respectively Mo layer and Si layer. Periodic length and interface roughness of Mo/Si multilayers were determined by small angle X-ray diffraction (SAXRD). Surface roughness change curve of Mo/Si multilayer with increasing layer number was studied by atomic force microscope (AFM). Soft X-ray reflectivity of Mo/Si multilayers was measured in National Synchrotron Radiation Laboratory (NSRL). Theoretical and experimental results show that the soft X-ray reflectivity of Mo/Si multilayer is mainly determined by periodic number and interface roughness, surface roughness has little effect on reflectivity.     

有限长FGM圆筒的热/机应力的解析解

利用微分方程的级数求解方法,分析了两端简支的有限长功能梯度圆筒的轴对称稳态热弹性问题,推导出了稳态温度场与应力场的解析解。分析中采用指数函数模型来描述FGM圆筒中材料性能在厚度方向的连续变化,同时忽略温度对材料性能的影响。另外,论文以金属钼和多铝红柱石制成的功能梯度圆筒为例,给出了稳态温度场和应力场的数值结果。