The First Template‐Free Growth of Crystalline Silicon Microtubes

A simple template‐free high‐temperature evaporation method was developed for the growth of crystalline Si microtubes for the first time. As‐grown Si microtubes were characterized using X‐ray diffraction, scanning electron microscopy, transmission electron microscopy, and room‐temperature photoluminescence. The lengths of the Si tubes can reach several hundreds of micrometers; some of them have lengths on the order of millimeters. Each tube has a uniform outer diameter along its entire length, and the typical outer diameter is ≈ 2–3 μm. Most of the tubes have a wall thickness of ≈ 400–500 nm, though a considerable number of them exhibit a very thin wall thickness of ≈ 50 nm. Room‐temperature photoluminescence measurement shows the as‐synthesized Si microtubes have two strong emission peaks centered at ≈ 589 nm and ≈ 617 nm and a weak emission peak centered at ≈ 455 nm. A possible mechanism for the formation of these Si tubes is proposed. We believe that the present discovery of the crystalline Si microtubes will promote further experimental studies on their physical properties and smart applications.     

激光熔覆Ni基SiC合金涂层组织与性能的研究

利用5kWCO2连续波激光器在16Mn钢基材表面对含20%(体积比)SiC陶瓷粉末的镍基自熔性合金粉末进行激光熔覆得到Ni基SiC合金涂层(NiSiC)。研究了合金涂层的组织形貌及相结构,并用单纯的镍基合金涂层(Ni60)进行了显微硬度及滑动磨损性能的对比试验。结果表明,NiSiC合金涂层由γ枝晶及其间的共晶组织组成,主要组成相为γ-Ni,γ-(Ni,Fe)固溶体和(Cr,Fe)7C3,Cr23C6及(Cr,Si)3Ni3Si等化合物。添加SiC的镍基合金涂层NiSiC比单纯的镍基合金涂层Ni60具有较高的硬度和耐磨性。     

Hamiltonian N2‐locally connected claw‐free graphs

A graph G is N₂‐locally connected if for every vertex ν in G, the edges not incident with ν but having at least one end adjacent to ν in G induce a connected graph. In 1990, Ryjá?ek conjectured that every 3‐connected N₂‐locally connected claw‐free graph is Hamiltonian. This conjecture is proved in this note. © 2004 Wiley Periodicals, Inc. J Graph Theory 48: 142–146, 2005     

Modeling wireless fading channels via stochastic differential equations: identification and estimation based on noisy measurements

This paper is concerned with modeling and identification of wireless channels using noisy measurements. The models employed are governed by stochastic differential equations (SDEs) in state space form, while the identification method is based on the expectation-maximization (EM) algorithm and Kalman filtering. The algorithm is tested against real channel measurements. The results presented include state space models for the channels, estimates of inphase and quadrature components, and estimates of the corresponding Doppler power spectral densities (DPSDs), from sample noisy measurements. Based on the available measurements, it is concluded that state space models of order two are sufficient for wireless flat fading channel characterization.     

高功率LDA紧密侧面抽运Nd:YLF两级双程离轴放大系统实验研究

 介绍了一台10mm口径两级双程离轴放大系统，实现了对5mm×5mm口径光束的激光放大，耦合系统采用高功率LDA紧密侧面直接抽运棒状Nd:YLF方式。分析并实验研究了在不同抽运电流、放大脉冲与放大器LDA抽运时刻的不同延时及不同注入能量条件下，放大系统及光束每次放大时放大特性的规律。实验得到：在放大系统5mm×5mm软光阑处注入1.58mJ能量时，放大系统可输出129.2mJ能量，能量提取效率达到19.5%，满足该系统的设计指标。     

智能工作站主机的MMPIS实验模型研究──一个全互连式结构MMPIS硬件环境的设计与实现

本文介绍中日国际合作开发研究的Ａ１型智能网（Ａ１型ＩＮ）智能工作站（ＩＷ）主机的并行推理硬件结构的实验模型设计与实现，给出了一种并行推理硬件支持环境实现方案和该方案在实现中若干问题的解决方法。     

大功率CO_2激光器非平衡态合成WO_3／Fe_2O_3新型陶瓷催化剂──Ⅱ．WO_3／Fe_2O_3烯烃歧化反应催化剂的催化活性

用大功率ＣＯ２激光器熔制ＷＯ３／Ｆｅ２Ｏ３新型烯烃歧化反应催化剂。考查了催化剂组成、激光功率及熔炼时间与丙烯歧化反应催化活性之间的关系。     

分子振动态及其跃迁的激光相干控制

讨论了激光合成相干叠加态的原理及其性质 ,针对 XY2 型分子 ,证明了合成局域模振动的可行性 ,然后给出相干叠加态的跃迁几率特征 ,发现它仍表现出相干的特性 ,对之进行分析研究表明 ,分子的振动态具有可控性 ,态跃迁几率具有可控性。     

漫谈金属探测器

提起金属探测器（Metal Detector），人们就会联想到探雷器，工兵用它来探测掩埋的地雷．金属探测器是一种专门用来探测金属的仪器，除了用于探测有金属外壳或金属部件的地雷之外，还可以用来探测隐蔽在墙壁内的电线、埋在地下的水管和电缆，甚至能够地下探宝，发现埋藏在地下的金属物体．目前还广泛应用于各种大型会议中心、会展场馆、体育场馆、公检法、监狱系统及娱乐场所的安全检查和工厂企业的防偷窃检查，甚至用于对高考禁带物品的检查．本文就来谈谈金属探测器的发展历史和工作原弹．     

Lorentz-Compton佯谬与一个双赢判决性散射实验设计

通过对“可见光区域是否存在Compton效应”的讨论而进一步深化到经典条件下“光的量子理论能否包含光的经典电磁理论”的实验验证,发现了Lorentz-Compton佯谬,并基于逆Compton散射设计了一个敏感而又可行的双赢判决性散射实验来解决此佯谬。