Scalability and performance of an agent‐based network management middleware

Rapid growth of computer network sizes and uses necessitate analysis of network application middleware in terms of its scalability as well as performance. In this paper we analyze a distributed network management middleware based on agents that can be dispatched to locations where they can execute close to the managed nodes. The described middleware operates between the network protocol layer and the application layer and uses standard TCP protocol and SNMP probes to interface the network. By aggregating requests from many users into a single agent, our system allows multiple managers to probe problem areas with minimal management traffic overhead. We discuss and quantify the benefits of the described middleware by implementing real‐time network managers using our system. The main result of this paper is a comparison of scalability and efficiency of our agent‐based management middleware and traditional SNMP‐based data collection. To this end, we measured traffic in both real and simulated networks. In the latter case, we designed, used and described here a method of separating simulated application flow into separate subflows to simplify design of simulations. Copyright © 2004 John Wiley & Sons, Ltd.     

Uncooled DBR laser directly Modulated at 3.125 gb/s as athermal transmitter for low-cost WDM systems

An uncooled three-section tunable distributed Bragg reflector laser is demonstrated as an athermal transmitter for low-cost uncooled wavelength-division-multiplexing (WDM) systems with tight channel spacing. A /spl plusmn/0.02-nm thermal wavelength drift is achieved under continuous-wave operation up to 70/spl deg/C. Dynamic sidemode suppression ratio of greater than 35 dB is consistently obtained under 3.125-Gb/s direct modulation over a 20/spl deg/C-70/spl deg/C temperature range, with wavelength variation of as low as /spl plusmn/0.2 nm. This indicates that more than an order of magnitude reduction in coarse WDM channel spacing is possible using this source.     

Photodiffraction in InGaAs/InGaAsP multiple quantum wells enclosed in a microcavity

We report new results on the diffraction properties of photoinduced gratings in InGaAs/InGaAsP MQW structures. The original feature of this device is that the QWs are enclosed in an asymmetric Fabry–Perot microcavity in order to increase the diffraction efficiency. We observe oscillations in the diffraction efficiency due to resonant effects in the microcavity. The experimental spectra are compared with theory. Diffraction efficiency at 1.55 μm attains a maximum value of 2.7% at a write beam fluence of 260 μ J cm⁻², and then decreases at higher fluences. We explain this phenomenon by an absorption saturation at high excitation.     

Octave-tunable miniature RF resonators

The development and testing of a miniaturized, high-Q, broadly tunable resonator is described. An exemplary device, with a center frequency that is continuously tunable from 1.2 to 2.6GHz, was tested in detail. Experimental results demonstrated a resonator Q of up to 380, and typical insertion loss of -1.9dB for a 25MHz 3-dB bandwidth. These resonators have been used to stabilize a broadly-tunable oscillator with phase noise of -132dBc/Hz at 100-kHz offset, with a center frequency tunable from 1.2-2.6GHz, and a tuning speed of 1GHz/ms.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Gigabit pulse position bistability in semiconductor lasers

The paper briefly reviews the major forms of optical bistability in active optical devices compatible for use in gigabit optical communication systems, and reports an entirely new optical bistability for the first time. Unlike previous devices, the two bistable states of the optical device are each a series of picosecond optical pulses at 1 GHz or greater repetition rates, and are distinguished by a half period temporal shift between their temporal positions in relation to a clock pulse. The bistable device is based on a gain switched semiconductor laser. Theoretical studies suggest 100-ps switching speeds might be achieved, and experimental results are reported indicating optically triggered switching times of 500 ps.