Asymmetric synthesis of homo-apioneplanocin A from d-ribose

Homo-apioneplanocin A was efficiently synthesized via stereoselective hydroxymethylation, regio- and chemoselective hydroboration, and chemoselective oxidation as key steps from d-ribose.     

A 0.9 V 92 dB Double-Sampled Switched-RC Delta-Sigma Audio ADC

A 0.9 V third-order double-sampled delta-sigma audio ADC is presented. A new method using a combination of a switched-RC technique and a floating switched-capacitor double-sampling configuration enabled low-voltage operation without clock boosting or bootstrapping. A three-level quantizer with simple dynamic element matching was used to improve linearity. The prototype IC implemented in a 0.13 CMOS process achieves 92 dB DR, 91 dB SNR and 89 dB SNDR in a 24 kHz audio signal bandwidth, while consuming 1.5 mW from a 0.9 V supply. The prototype operates from 0.65 V to 1.5 V supply with minimal performance degradation.     

Cellulose dimethylphenylcarbamate-bonded carbon-clad zirconia for chiral separation in high performance liquid chromatography.

Porous zirconia particles are very robust material and have received considerable attention as a stationary phase support for HPLC. We prepared cellulose dimethylphenylcarbamate-bonded carbon-clad zirconia (CDMPCCZ) as a chiral stationary phase (CSP) for separation of enantiomers of a set of 14 racemic compounds in normal phase (NP) and reversed-phase (RP) liquid chromatography. Retention and enantioselectivity on CDMPCCZ were compared to those on CDMPC-coated zirconia (CDMPCZ) to see how the change in immobilization method of the chiral selector affects the retention and chiral selectivity. In NPLC, retention was longer and the number of resolved racemates was smaller on CDMPCCZ than on CDMPCZ. However, chiral selectivity factors for some resolved racemates were better on CDMPCCZ than on CDMPCZ. The longer retention on CDMPCCZ is likely due to strong, non-chiral discriminating interactions with the carbon layer on CDMPCZ. In RPLC only two racemates were resolved on CDMPCCZ, but retention times were shorter than, and resolutions were comparable to, those in NPLC, indicating a potential for improving chromatographic performance of the CDMPCCZ column in RPLC with optimized column preparation and separation conditions.     

Investigation of the chemical state of ultrathin Hf-Al-O films during high temperature annealing

Al₂O₃ incorporated HfO₂ films grown by atomic layer deposition (ALD) were investigated by high-resolution X-ray photoelectron spectroscopy (HRXPS). The core level energy state of a 15 Å thick film showed a shift to higher binding energy, as the result of a silicate formation and Al₂O₃ incorporation. The incorporation of Al₂O₃ into the HfO₂ film had no effect on silicate formation at the interface between the film and Si, while the ionic bonding characteristics and hybridization effects were enhanced compared to a pure HfO₂ film. The dissociation of the film in an ultrahigh vacuum (UHV) is effectively suppressed compared to a pure HfO₂ film, indicating an enhanced thermal stability of Hf-Al-O. Any dissociated Al₂O₃ on the film surface was completely removed into the vacuum by vacuum annealing treatment over 850 °C, while HfO₂ contributed to Hf silicide formation on the film surface.     

Vertex-based inter-frame boundary encoding scheme

The boundary is approximated by a polygon which can be encoded with the smallest number of bits for maximum distortion. The temporal redundancy between two successive frames is efficiently removed with the proposed scheme, resulting in a lower bit rate than the conventional algorithms     

On-line dead-time compensation method using disturbance observer

A new on-line dead-time compensation method for a permanent magnet (PM) synchronous motor drive is proposed. Using a simple disturbance observer without any additional circuit and off-line experimental measurement, disturbance voltages in the rotor reference dq frame caused by the dead time and nonideal switching characteristics of power devices are estimated in an on-line manner and fed to voltage references in order to compensate the dead-time effects. The proposed method is applied to a PM synchronous motor drive system and implemented by using software of a digital signal processor (DSP) TMS320C31. Simulations and experiments are carried out for this system and the results well demonstrate the effectiveness of the proposed method.     

A 0.8-V accurately tuned linear continuous-time filter

An accurately tuned low-voltage linear continuous-time filter is presented in this paper. Accurate tuning is achieved using time-constant matched master-slave tuning combined with power-up mismatch calibration. A low-pass biquad designed for a corner frequency of 115 kHz achieves better than -80-dB total harmonic distortion with a 250-mV/sub pp/ 10-kHz input signal. The prototype implemented in 0.18-/spl mu/m CMOS process occupies an area of 0.4 mm/sup 2/ and dissipates 4.6 mW (2.6 mW for the filter and 2 mW for tuning) of power.