Path to achieving molecular dispersion in a dense reactive mixture

A uniform dispersion of reactants is necessary to achieve a complete reaction involving multicomponents. In this study, we have examined the role of plasticizer in the reaction of two seemingly unlikely reactants: a highly crystalline hexamethylenetetramine (HMTA) and a strongly hydrogen bonded phenol formaldehyde resin. By combining information from NMR, infrared spectroscopy and differential scanning calorimetry, we were able to determine the role of specific intermolecular interactions necessary for the plasticizer to dissolve the highly crystalline HMTA and to plasticize the phenol formaldehyde resin in this crosslinking reaction. The presence of the plasticizer increased the segmental mobility, disrupted the hydrogen bonded matrix, and freed the hydroxyl units, which further increased the solubility of the HMTA. Both the endothermic and exothermic transitions are accounted for in the calorimetric data obtained. For the first time, it is possible to obtain the effective molar ratio of each component needed to complete the crosslinking reaction efficiently. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1519–1526     

Application of pressure sensitive paint measurement to a low-solidity cascade diffuser of a transonic centrifugal compressor

A pressure sensitive paint (PSP) measurement has been known as a pressure field measurement technique based on the oxygen quenching phenomenon of luminescence of specific luminophores. A PSP measurement was applied for pressure field measurement in a low-solidity circular cascade diffuser of a single-stage transonic centrifugal compressor with 5 in pressure ratio for HFC134a gas. The oxygen concentration was about 500 ppm. Ru (bath-phen) was adsorbed on a silica-gel thinlayer chromatography sheet, and the sheet was pasted onto the side-wall between the cascade vanes. A drastic change in luminescent intensity was recognized during a surge condition. Also the pressure variations based on luminescent intensity agreed well with the pressure fluctuations measured using a semiconductor pressure sensor with high-frequency-response. It was shown that a PSP measurement worked well to investigate the unsteady pressure fields in a circular cascade diffuser of a transonic centrifugal compressor. Moreover, the time response of PSP becomes clear as a problem to be overcome for the present.     

Dynamic and subjective responses of seated subjects exposed to simultaneous vertical and fore-and-aft whole-body vibration: The effect of the phase between the two single-axis components

Subjective and dynamic responses of seated subjects exposed to simultaneous vertical and fore-and-aft sinusoidal whole-body vibration were investigated. The effect of the phase difference between the vertical and the fore-and-aft vibration on the responses was of a particular interest in this study. Fifteen subjects were exposed to dual-axis vibrations at six frequencies (2.5-8 Hz) and at eight phases between the two single-axis components (0-315°). The magnitude of vibration in each axis was constant at 0.7 m s⁻² rms. Discomfort caused by vibration was measured by the method of magnitude estimation. The motion of the body were measured at the head and three locations along the spine with accelerometers attached to the body surface. The most significant effect of the phase between the two single-axis components on the discomfort was observed at 5 Hz: about 40% difference in the median discomfort estimate caused by changing the phase. The transmissibilities from vertical seat vibration to vertical motions of the spine varied from 0.5 to 2.0 by changing the phase between the two single-axis components at frequencies from 2.5 to 5 Hz. The effect of the phase observed in the dynamic response was not predicted by the superposition of the responses to each single-axis vibration. The discomfort caused by the dual-axis vibration tended to be correlated better with the combinations of the dynamic responses measured in the two axes than with the dynamic responses in a single axis.     

Characteristics of thermally expanded core fiber

Thermally expanded core (TEC) fiber is expected to reduce fiber-to-fiber and fiber-to-laser diode connection loss. This paper describes the characteristics of TEC fiber theoretically and experimentally. We reveal theoretically that when fabricating TEC fiber the mode field diameter (MFD) is enlarged more effectively by increasing the heating temperature rather than the heating time. In the 1300-1600°C temperature range with heating times between 0 and 60 min, it is necessary to control the temperature accurately so that no deviation from the target temperature is more than ±30°C. This is in order to ensure that any connection loss caused by MFD mismatch is less than 0.1 dB. We show experimentally that the propagation loss of TEC fiber is dependent on the heating region and wavelength by using a micro burner with a propane/oxygen flame. Based on the relationship between the loss characteristics and the expanded MFD, we suggest a method for nondestructively measuring the MFD in TEC fibers     

High-throughput characterization of local conductivity of Nd0.9Ca0.1Ba2Cu3O7−δ thin film by the low-temperature scanning microwave microscope

We developed a scanning microwave microscope (SμM) designed for high-throughput electric-property screening as well as for rapid construction of electronic phase diagrams at low temperatures. As a sensor probe, we used a high-Qλ/4 coaxial cavity resonator to which a thin needle with ball-tip end was attached. The sensor module was mounted on the low-temperature XYZ stage, which allowed us to map out the change of resonance frequency and quality factor due to the local tip-sample interaction at low temperatures. From the measurements of combinatorial thin films, such as Ti_1−xCo_xO_2−δ and Nd_0.9Ca_0.1Ba₂Cu₃O_7−δ (NCBCO), it was demonstrated that this SμM system has enough performance for the high-throughput characterization of sample conductance under variable temperature conditions.     

Novel dinucleoside phosphotriester unit conjugated with an intercalative moiety in a stereospecific manner enhances thermal stability of an alternate-stranded triple helix

A novel phosphoramidite synthon of a dinucleoside phosphotriester unit bearing an intercalative moiety at its internucleotide linkage in a stereospecific manner was prepared and successfully incorporated into the middle portion of α-β chimeric oligoDNA. One of the resulting stereoisomeric chimera DNAs strongly enhances the thermal stability of an alternate-stranded triplex formed between the chimera and a double-stranded DNA.     

Soft decision decoding of block codes using received signalenvelope in digital mobile radio

The codeword error rate (WER) performance of noncoherent frequency-shift keying with soft decision decoding of block codes using Chase's second algorithm (1972) is investigated in a Rayleigh fading channel. The received signal envelope is sampled and used as channel measurement information. The theoretical upper and lower bounds of the WER are derived, assuming independent Rayleigh envelope samples in a received block. When the Golay (23, 12, 7) code is used, soft decision decoding with 6-bit error correction capability (3-bit error and 3-bit erasure) requires an average signal-to-noise power ratio about 5 dB lower than that for minimum distance decoding with 3-bit error correction to obtain a WER=10^-3. The effects of bit interleaving on the WER performance when fading envelope variation is slow compared to the bit rate are investigated through computer simulations     

Preparation and evaluation of oral dosage form using acylglycerols. II. Effect of food ingestion on dissolution and absorption of aspirin from the granules prepared by acylglycerols in human subjects.

The dissolution behavior of the aspirin enteric granule prepared using acylglycerols, glyceryl monostearate (GMS) and glyceryl trilaurate (GTL), was investigated in vitro and in human subjects in a fasting or non-fasting state. Aspirin was slowly released from the granule in vitro at pH 1.2. No acceleration of the aspirin dissolution rate in the medium without lipase and cholic acid was observed when the pH level of the medium increased to a neutral region (pH 6.4). However, the dissolution of aspirin was significantly increased by increasing the concentrations of lipase and cholic acid in the medium. Lipase appears to play an essential role in the dissolution process of aspirin granules. In human subjects, the average levels of the cumulative amount of total salicylate excreted in a urine-time curve, and the mean residence time (MRT) obtained after oral administration of a granule in the fasting state were markedly delayed in comparison with the results observed using an aqueous solution and a crystalline form of aspirin. In comparing the fasting condition with the non-fasting condition (after food ingestion), no significant difference was recognized in the total amount of salicylate excreted in urine to an infinite time (Ae(infinity)), whether the MRT was obtained by granule, crystalline form or aqueous solution. It can be concluded that aspirin granule prepared by GMS and GTL has a property of pancreatic lipase-sensitive dissolution, and its bioavailability is unaffected by food intake.