Method for Preparation of Semiconductor Quantum‐Rod Lasers in a Cylindrical Microcavity

An efficient method for preparation of semiconductor quantum rod films for robust lasing in a cylindrical microcavity is reported. A capillary tube, serving as the laser cavity, is filled with a solution of nanocrystals and irradiated with a series of intense nanosecond laser pulses to produce a nanocrystal film on the capillary surface. The films exhibit intense room‐temperature lasing in whispering‐gallery modes that develop at the film–capillary interface as corroborated from the spacing detected for the lasing modes. Good lasing stability is observed at moderate pump powers. The method was applied successfully to several quantum‐rod samples of various sizes.     

Ozone measurement in visible region: an optical fibre sensor system

Ozone measurement based on the optical absorption of visible light at 603 nm using polymer optical fibres is investigated and tested. Comparisons with a commercial UV based sensor demonstrate the ability of the visible based sensor to measure high concentrations over a range 27-127 mg/litre. A resolution of 5 mg/litre is also demonstrated for this sensor.     

The Transmogrifier-2: a 1 million gate rapid-prototyping system

This paper describes the Transmogrifier-2 (TM-2), a second-generation multifield programmable gate array (FPGA) rapid-prototyping system. The largest version of the system will comprise 16 boards that each contain two Altera 10K50 FPGA's, four I-Cube interconnect chips, and up to 8 Mbytes of memory. The inter-FPGA routing architecture of the TM-2 uses a novel interconnect structure, a nonuniform partial crossbar, that provides a constant delay between any two FPGA's in the system. The TM-2 architecture is modular and scalable, meaning that systems of various sizes can be constructed from copies of the same board, while maintaining routability and the constant delay feature. Other features include a system-level programmable clock that allows single-cycle access to off-chip memory, and programmable clock waveforms with edge resolution of 10 ns. The first Transmogrifier-2 boards have been manufactured and are functional. They have recently been used successfully in some simple graphics acceleration applications     

Spherical-wave source-scattering matrix analysis of coupled antennas; A general system two-port solution

Expressions are given for the coupling between two antennas in terms of each antenna's spherical-wave source-scattering matrix. A comparison with the "classical" scattering matrix representation is given in sufficient detail to permit conversion back and forth between the source-scattering matrix and the classical scattering matrix. Expressions for the transmission formulas, showing two different expressions corresponding to reversing the direction of propagation are given. However, if both antennas are reciprocal with equal characteristic waveguide impedances, then the two-port scattering matrix is a symmetric matrix.     

A short synthesis of (±)-tecomanine via a Pauson-Khand-based route

The N-carboethoxy precursor to (±)-tecomanine has been prepared in 11 steps from 2-methyl-1-buten-3-yne. The key step, Pauson-Khand cyclization of a methylated 5-aza-6-nonen-1-yne succeeds, but only in low yield, a consequence of the dialkyl substitution about the azaenyne framework. Nevertheless, the overall sequence to that point is one of the more efficient to be described.     

Extending trouble ticket systems to fault diagnostics

Network management in large heterogeneous communication environments requires the incorporation of more advanced tools than are currently available, especially in the area of fault management. By providing an informational infrastructure for documenting network behavior and maintenance activities, TTSs (trouble ticket systems) have provided some relief for the fault management problem. Researchers have recognized TTSs as a means for realizing more advanced functions in network management platforms to effect automatic trouble ticket generation, fault diagnostics, and the correlation of multiple views network problems and behavior. The authors describe current research trends towards understanding and implementing these advanced functions in a TTS framework     

Silicon-substrate microelectrode arrays for parallel recording ofneural activity in peripheral and cranial nerves

A new process for the fabrication of regeneration microelectrode arrays for peripheral and cranial nerve applications is presented. This type of array is implanted between the severed ends of nerves, the axons of which regenerate through via holes in the silicon and are thereafter held fixed with respect to the microelectrodes. The process described is designed for compatibility with industry-standard CMOS or BiCMOS processes (it does not involve high-temperature process steps nor heavily-doped etch-stop layers), and provides a thin membrane for the via holes, surrounded by a thick silicon supporting rim. Many basic questions remain regarding the optimum via hole and microelectrode geometries in terms of both biological and electrical performance of the implants, and therefore passive versions were fabricated as tools for addressing these issues in on-going work. Versions of the devices were implanted in the rat peroneal nerve and in the frog auditory nerve. In both cases, regeneration was verified histologically and it was observed that the regenerated nerves had reorganized into microfascicles containing both myelinated and unmyelinated axons and corresponding to the grid pattern of the via holes. These microelectrode arrays were shown to allow the recording of action potential signals in both the peripheral and cranial nerve settings, from several microelectrodes in parallel