Influence of device engineering on the analog and RF performances of SOI MOSFETs

This work presents a systematic comparative study of the influence of various process options on the analog and RF properties of fully depleted (FD) silicon-on-insulator (SOI), partially depleted (PD) SOI, and bulk MOSFET's with gate lengths down to 0.08 /spl mu/m. We introduce the transconductance-over-drain current ratio and Early voltage as key figures of merits for the analog MOS performance and the gain and the transition and maximum frequencies for RF performances and link them to device engineering. Specifically, we investigate the effects of HALO implantation in FD, PD, and bulk devices, of film thickness in FD, of substrate doping in SOI, and of nonstandard channel engineering (i.e., asymmetric Graded-channel MOSFETs and gate-body contacted DTMOS).     

Bei der Zuckerbestimmung

Ohne Zusammenfassung     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

Standardization of Methods for Characterizing the Surface Geometry of Solids

Since a comprehensive survey published in 1999 [1] much work was done in standardizing measuring methods to characterize the surface geometry of dispersed and/or porous solids and to certify reference materials. The present paper is an extension of a short communication [2]. It gives a survey on existing standards and reports on new drafts and proposals.     

Optical and structural properties of MOVPE grown GaxIn1−xAs/InP strained multiple quantum well atructures

This paper presents a study of the structural and optical properties of strained GaInAs/ InP multiple quantum well (MQW) structures fabricated by LP-MOVPE. The composition of the Ga _x In_1−x As films ranged fromx = 0.17 tox = 1.0 and was determined by sputtered neutral mass spectrometry (SNMS) on thick layers. The structures of the MQW samples with well widths from 1.5 to 5 nm were investigated by high resolution x-ray diffraction (HR-XRD). Simulations of the diffraction patterns showed that transition layers of approximately 2 monolayer (ML) thickness with high lattice mismatch exist at the interfaces. Photoluminescence (PL) measurements indicate well widths of a multiple of a monolayer with local variations of one monolayer. The PL peak energies vary smoothly with the Ga concentration. These results were confirmed by optical absorption measurements.     

Correction: Phytol-based novel adjuvants in vaccine formulation: 1. assessment of safety and efficacy during stimulation of humoral and cell-mediated immune responses

This is a correction article.     

Improved quantitation of 13-cis- and all-trans-acitretin in human plasma by normal-phase high-performance liquid chromatography.

A reliable analytical method has been developed for measurement of 13-cis- and all-trans-acitretin (Neotigason) in human plasma by normal-phase high-performance liquid chromatography, with ultraviolet detection. Human plasma was obtained after centrifugation of whole blood samples and deproteinized by ethanolic denaturation. After liquid-liquid extraction with water-n-hexane, and aliquot ws chromatographed on a silica column using isocratic elution with n-hexane-methylsalicylate-acetic acid (200:18:0.6, v/v). The wavelength was set at 360 nm, and for plasma samples a limit of quantification of 3-4 ng/ml was obtained. All manipulations were carried out under dim light conditions to prevent photoisomerization.     

Raman spectroscopy of carbon fibres

Investigations of coated carbon fibres are reported using Raman spectroscopy. Relationships between different process parameters (for example precursor concentration, reactor temperature and various precursors) and the resulting types of carbon fibres are discussed.