Structural and electrical characterization of SxSe100−x thin films

Thin films of samples of the glassy S_xSe_100−x system with 0 ≤ x ≤ 7.28 have been prepared by thermal evaporation technique at room temperature (300 K). X-ray investigations show that the structure of pure selenium (Se) does change seriously by the addition of small amount of sulphur S ≤7.28%. The lattice parameters were determined as a function of sulphur content. Results of differential thermal analysis (DTA) of the glassy compositions of the system S_xSe_100−x were discussed. The characteristic temperatures (T_g, T_c and T_m) were evaluated. Dark electrical resistivities, ρ, of S_xSe_100−x thin films with different thicknesses from 100 to 500 nm, were measured in the temperature range from 300 to 423 K. Two distinct linear parts with different activation energies were observed. The variation of electrical resistivity of examined compositions has been discussed as a function of the film thickness, temperature and the sulphur content. The application of Mott model for the phonon assisted hopping of small polarons gave the same two activation energies obtained from the resistivity temperature calculations.     

Transient creep during transformation in Cd-Zn alloys

Transient creep of Cd-2 wt. % Zn and Cd-17·4 wt. % Zn alloys has been studied under different constant stresses ranging from 6·4 MPa to 12·7 MPa near the transformation temperature. The results of both compositions showed two transient deformation regions, the low temperature region (below 483 K) and the high temperature region (above 483 K). From the transient creep described by the equation _tr=Bt ⁿ, where _tr andt are the transient creep strain and time. The parametersB andn were calculated. The parameterB was found to change with the applied stress from 0·3×10^–4 to 3×10^–4 and from 0·6×10^–4 to 18×10^–4 for Cd-2 wt. % Zn and Cd-17·4 wt. % Zn, respectively. The exponentn was found to change from 0·8 to 0·95 for both alloys. The parameterB was related to the steady state creep rate through the equation , the exponent was found to be 0·5 for Cd-2 wt. % Zn and 0·6 for the eutectic composition. The activation energies of transient creep in the vicinity of the transformation regions (above 483 K) were found to be 50·2 kJ/mole for Cd-2 wt. % Zn and 104·7 kJ/mole for the eutectic composition characterizing the mechanisms of grain boundary diffusion and volume diffusion in Cd, respectively.     

Reaction of some coumarin and 4,6-diaryl-2H-pyran derivatives with secondary amines

The reaction of piperidine, morpholine, piperazine or dimethylamine with several coumarins, 3-bromocoumarin, 4,6-diaryl-2H-pyran-2-ones and 3-bromo-4,6-diaryl-2H-thiopyran-2-ones gave o-hydroxycinnamic acid amides, benzofurans, open-chain δ-oxoamides and thiophene derivatives, respectively.     

Shift to Pseudomonic acid B production in P. fluorescens NCIMB10586 by mutation of mupirocin tailoring genes mupO, mupU, mupV, and macpE

Mupirocin, a polyketide-derived antibiotic from Pseudomonas fluorescens NCIMB10586, is a mixture of pseudomonic acids (PA) that target isoleucyl-tRNA synthase. The mup gene cluster encodes both type I polyketide synthases and monofunctional enzymes that should play a role during the conversion of the product of the polyketide synthase into the active antibiotic (tailoring). By in-frame deletion analysis of selected tailoring open-reading frames we show that mupQ, mupS, mupT, and mupW are essential for mupirocin production, whereas mupO, mupU, mupV, and macpE are essential for production of PA-A but not PA-B. Therefore, PA-B is not simply produced by hydroxylation of PA-A but is either a precursor of PA-A or a shunt product. In the mupW mutant, a new metabolite lacking the tetrahydropyran ring is produced, implicating mupW in oxidation of the 16-methyl group.     

Structure and Magnetic Properties of Nickel–Zinc Ferrite Nanoparticles Prepared by Glass Crystallization Method

Summary. The magnetic and microstructure properties of Fe₂O₃–0.4NiO–0.6ZnO–B₂O₃ glass system, which was subjected to heat treatment in order to induce a magnetic crystalline phase (Ni_0.4Zn_0.6-Fe₂O₄ crystals) within the glass matrix, were investigated. DSC measurement was performed to reveal the crystallization temperature of the prepared glass sample. The obtained samples, produced by heat treatment at 765°C for various times (1, 1.5, 2, and 3 h), were characterized by X-ray diffraction, IR spectra, transmission electron microscopy, and vibrating sample magnetometer. The results indicated the formation of spinel Ni–Zn ferrite in the glass matrix. Particles of the ferrite with sizes ranging from 28 to 120 nm depending on the sintering time were observed. The coercivity values for different heat-treatment samples were found to be in the range from 15.2 to 100 Oe. The combination of zinc content and sintering times leads to samples with saturation magnetization ranging from 12.25 to 17.82 emu/g.     

Membranes obtained by preirradiation grafting of acrylic acid onto poly(tetrafluoroethylene–perfluorovinyl ether)

Some properties of the membranes obtained by preirradiation grafting of acrylic acid onto poly(tetrafluoroethylene-perfluorovinyl ether) copolymer (PFA) films have been investigated. The dimensional change caused by grafting and swelling behavior, water uptake, electrical conductivity, and mechanical properties of the grafted films were found to increase as the grafting proceeds. The influence of the preparation conditions (such as preirradiation dose, monomer concentration, grafting temperature, and film thickness) on those properties was studied. These properties were found to be dependent mainly on the degree of grafting regardless of grafting conditions, except at higher monomer concentration (>40 wt %). The electric conductivity and mechanical properties for the membranes obtained at higher AAc concentrations were lower than those obtained at lower ones. Analysis by x-ray microscopy of the grafted films revealed that the grafting begins at the part close to the film surface and proceeds into the central part with progressive diffusion of monomer to give finally homogeneous distribution of the electrolytes in the whole bulk of the polymer. The membranes show good electrochemical and mechanical properties which make them acceptable for practical use as cation-exchange membranes.     

Catalytic kinetic determination of ultratrace amounts of ruthenium(III) based on the oxidation of hematoxylin by hydrogen peroxide

A new catalytic method was described for the determination of ruthenium(III) based on its catalytic effect on the oxidation of hematoxylin by hydrogen peroxide in weakly acidic medium. The reaction was followed spectrophotometrically by measuring the absorbance of hematoxylin at 440 nm. Under the optimum conditions, ruthenium(III) can be determined in the range 5–120 ng/ml with a relative standard deviation of 1.1%. The mean value of reaction rate constant was 0.012±0.04 min^–1 and the activation energy was 10.45 kJ/mol. The method was tested for the determination of ruthenium(III) in some synthetic mixtures.     

Thermal and electrical behaviour of nickel(II) and copper(II) complexes of 4-acetylamino-2-hydroxy-5-methylazobenzene

The thermal behaviour of the entitled nickel(II) and copper(II) complexes of ¯4-acetylamino-2-hydroxy-5-methyl azobenzene has been studied by means of differential thermal analysis (DTA), thermogravimetry (TG), X-ray powder diffraction, IR and electrical conductivity. A light has been thrown on the nature of interaction of the solvents of crystallization with the host complex. Some of the kinetic parameters are calculated and discussed.     

Comparative Studies on the Behavior of 3-Amino-2-phenyl-4(3 H )-quinazolinone Towards Some Organophosphorus Reagents

The reaction of 3-amino-2-phenyl-4(3H)-quinazolinone with oxovinylidenetriphenylphosphorane afforded 5-phenylpyrazolo[1,5-c] quinazoline-2(3H)-one and triphenylphosphine oxide. On the other hand, when quinazolinone reacts with phosphorus ylides, the corresponding phosphorane adducts were obtained. Moreover, quinazolinone reacts with trisdialkylaminophosphines to give the new (dialkylamino)oxophosphonium dipolar products. Possible reaction mechanisms are considered and the structural assignments are based on analytical and spectroscopic results.     

Benzimidazole condensed ring systems. 7. An entry to substituted 1h,6h-2,6a,10b-triazafluoranthene-1,3,6-(2h)-triones and related systems as possible chemotherapeutic agents

The syntheses of some derivatives of three new benzimidazole condensed ring systems; namely, 1H,6H-2,6a,10b-triazafluoranthene-1,3,6(2H)-trione ( 3 ), 1H,8H,11H-12-oxa-2,3a,7b-triazabenz[e]acephenanthrylene-1,3,8,11(2H)-tetrone ( 4 ) and 1H,4H-2,5,6a,10b-tetrazafluoranthene-1,3,4,6(2H,5H)-tetrone ( 10 ) are described. Two compounds exhibited in vitro antibacterial activity. Four compounds were screened for in vitro anti-HIV activity and three compounds were evaluated for antileukemic potency but were inactive.