Local thermodynamics of KS black hole

We study the thermodynamics of the KS black hole which is an asymptotically flat solution of the HL gravity. In particular, we introduce a cavity to describe the thermodynamics at a finite isothermal surface on general ground and to get a well-defined thermodynamics. We show that there exists a locally stable small black hole which tunnels to the hot flat space below the critical temperature and to the large black hole above the critical temperature. Moreover, it turns out that the remnant decays into the vacuum through a quantum tunneling.     

Analysis of Single‐RF MIMO Receiver with Beam‐Switching Antenna

This paper proposes a single‐RF MIMO receiver that adopts a beam‐switching antenna (BSA) instead of a conventional array antenna. The beauty of the proposed single‐RF MIMO receiver with BSA is that it can be deployed in a very small physical space while achieving a full spatial multiplexing gain. Our analysis has revealed that the use of a BSA inevitably results in the spectrum spreading effect at the RF output, which in turn causes an SNR decrease and adjacent channel interference (ACI). Two novel receiver techniques are proposed to mitigate the issues of redundant sub‐band suppression and ACI avoidance. Numerical analysis results verify the performance improvement from the proposed receiver techniques.     

Regeneration of kidney tissue using in vitro cultured fetal kidney cells

Transplanting fetal kidney cells (FKCs) can regenerate kidney. This requires in vitro expansion in cell number to acquire enough cells for transplantation. However, FKCs may change their cellular characteristics during expansion and, thus, may not regenerate kidney tissue upon transplantation. We investigated how cell culture period affects cellular characteristics and in vivo regenerative potential of FKCs. As the passage number increased, cell growth rate and colony forming ability decreased while senescence and apoptosis increased. To examine in vivo regenerative potential, FKCs cultured through different numbers of passages were implanted into the parenchyma of kidneys of immunodeficient mice using fibrin gel for 4 wk. Histological analyses showed passage-dependent kidney tissue regeneration, and the regeneration was better when cells from lower number of passages were implanted. This result shows that in vitro culture of FKCs significantly affects the cell characteristics and in vivo tissue regenerative potential.     

Formation of double front detonations of a condensed-phase explosive with powdered aluminium

The performance characteristics of aluminised high explosive are considered by varying the aluminium (Al) mass fraction in a hybrid non-ideal detonation model. Since the time scales of the characteristic induction and combustion of high explosives and Al particles differ, the process of energy release behind the leading detonation wave front occurs over an extended period of time. Two cardinal observations are reported: a decrease in detonation velocity with an increase in Al mass fraction and a double front detonation (DFD) feature when anaerobic Al reaction occurs behind the front. In order to simulate the performance characteristics due to the varying Al mass fraction, the tetrahexamine tetranitramine (HMX) is considered as a base high explosive when formulating the multiphase conservation laws of mass, momentum, and energy exchanges between particles and HMX product gases. While experimental studies have been reported on the effect of Al mass fraction on both gas-phase and solid-phase detonations, the numerical investigations have been limited to only gas-phase detonation for the varying Al particles in the mixture. In the current study, a two-phase model is utilised for understanding the volumetric effects of Al mass fraction in condensed phase detonations. A series of unconfined and confined rate sticks are considered for characterising the performance of aluminised HMX with a maximum Al mass fraction of 50%. The simulated results are compared with the experimental data for 5–25% mass fractions, and the higher mass fraction behaviours are consistent with the experimental observations.     

Novel fabrication route for carbon-free and dense CuInSe2 (CIS) thin films via a non-vacuum process for solar cell application

Carbon-free CuInSe₂ (CIS) thin film with a dense microstructure has been prepared using a novel non-vacuum based fabrication route. Cu_xS_y and In₂Se₃ binary nanoparticles, approximately 10 nm in size, were synthesized by a low temperature colloidal process. The precursor film was deposited using the coating ink formulated with the binary nanoparticles and pyridine, and then annealed in the rapid thermal annealing (RTA) chamber at 540 °C for 15 min under selenium (Se) atmosphere. Scanning electron micrographs, X-ray diffraction patterns and Raman spectra showed a phase pure carbon-free and dense CIS thin film was prepared in this method. A solar cell device fabricated using this CIS thin film showed the following photovoltaic characteristics: V_OC = 350 mV, J_SC = 24.72 mA cm⁻², FF = 38.73% and η = 3.36% under standard AM 1.5 condition.     

Work‐Function Engineering of Graphene Anode by Bis(trifluoromethanesulfonyl)amide Doping for Efficient Polymer Light‐Emitting Diodes

Graphene has been considered to be a potential alternative transparent and flexible electrode for replacing commercially available indium tin oxide (ITO) anode. However, the relatively high sheet resistance and low work function of graphene compared with ITO limit the application of graphene as an anode for organic or polymer light‐emitting diodes (OLEDs or PLEDs). Here, flexible PLEDs made by using bis(trifluoromethanesulfonyl)amide (TFSA, [CF₃SO₂]₂NH) doped graphene anodes are demonstrated to have low sheet resistance and high work function. The graphene is easily doped with TFSA by means of a simple spin‐coating process. After TFSA doping, the sheet resistance of the TFSA‐doped five‐layer graphene, with optical transmittance of ≈88%, is as low as ≈90 Ω sq^?1. The maximum current efficiency and power efficiency of the PLED fabricated on the TFSA‐doped graphene anode are 9.6 cd A^?1 and 10.5 lm W^?1, respectively; these values are markedly higher than those of the PLED fabricated on pristine graphene anode and comparable to those of an ITO anode.     

Quantitative determination of aceclofenac and its three major metabolites in rat plasma by HPLC-MS/MS

We developed a method for the simultaneous quantification of aceclofenac and its three major metabolites in rat plasma. After protein precipitation with acetonitrile including flufenamic acid as an internal standard (IS), aceclofenac, diclofenac, 4'-hydroxyaceclofenac, 4'-hydroxydiclofenac, and the IS were chromatographed on a reverse-phase C18 analytical column. The isocratic mobile phase of acetonitrile/0.1% formic acid (aq; 9:1 [v/v]) was eluted at 0.3 mL/min. Quantification was performed on a triple-quadrupole mass spectrometer using electrospray ionization, and the ion transitions were monitored in selective reaction-monitoring mode. The coefficient of variation in the assay precision was less than 8%, and the accuracy was 92-103%. This method was successfully used to measure the concentrations of aceclofenac and its three major metabolites in rat plasma following the oral administration of a single 20 mg/kg oral dose of aceclofenac.     

Thermodynamics of warped anti-de Sitter black holes under scattering of scalar field

We investigate the thermodynamics and stability of the horizons in warped anti-de Sitter black holes of the new massive gravity under the scattering of a massive scalar field.Under scattering,conserved quantities can be transferred from the scalar field to the black hole,thereby changing the state of the black hole.We determine that the changes in the black hole are well coincident with the laws of thermodynamics.In particular,the Hawking temperat-ure of the black hole cannot be zero in the process as per the third law of thermodynamics.Furthermore,the black hole cannot be overspun bevond the extremal condition under the scattering of any mode of the scalar field.