Ozonolysis of a Series of Methylated Alkenes: Reaction Rate Coefficients and Gas‐Phase Products

The gas‐phase ozonolysis of three methylated alkenes, i.e., trans‐2,2‐dimethyl‐3‐hexene (22dM3H), trans‐2,5‐dimethyl‐3‐hexene (25dM3H), and 4‐methyl‐1‐pentene (4M1P), has been investigated in the presence of sufficient hydroxyl radical scavenger in a laminar flow reactor at ambient temperature (296 ± 2 K) and P = 1 atm of dry air (RH ≤ 5%). Ozone levels in the reactor were monitored by an automatic analyzer. Alkene and gas‐phase product concentrations were determined via online sampling either on three‐bed adsorbent cartridges followed by thermodesorption and GC/FID‐MS analysis or on 2,4‐dinitrophenylhydrazine (DNPH) cartridges for subsequent HPLC/UV analysis. Reaction rate coefficients of (3.38 ± 0.12) × 10^?17 for 22dM3H and (2.71 ± 0.26) × 10^?17 for 25dM3H, both in cm³ molecule^?1 s^?1 units, have been obtained under pseudo–first‐order conditions. Primary carbonyl products have been identified for the three investigated alkenes, and branching ratios are reported. In the case of 4M1P ozonolysis, the yield of a Criegee intermediate was indirectly determined. Kinetics and product study results are compared to those of literature when available. This work represents the first investigation of reaction products in the ozonolysis of 22dM3H, 25dM3H, and 4M1P in a flow reactor.     

On the use of 2-D coding techniques for ECG signals.

This paper discusses the convenience of using two-dimensional (2-D) coding techniques for the compression of electrocardiogram (ECG) signals. These signals present a very clear periodicity that can be exploited by the use of a 2-D time/frequency transform to decorrelate it as much as possible. A brief theoretical approach is given to justify the use of this technique, and a comparison is made between a 2-D and a one-dimensional (1-D) uniform quantization scenarios. The influence of the error as well as the frame size on the estimation of the fundamental period is studied.     

Inverted Solution Processable OLEDs Using a Metal Oxide as an Electron Injection Contact.

A new type of bottom‐emission electroluminescent device is described in which a metal oxide is used as the electron‐injecting contact. The preparation of such a device is simple. It consists of the deposition of a thin layer of a metal oxide on top of an indium tin oxide covered glass substrate, followed by the solution processing of the light‐emitting layer and subsequently the deposition of a high‐workfunction (air‐stable) metal anode. This architecture allows for a low‐cost electroluminescent device because no rigorous encapsulation is required. Electroluminescence with a high brightness reaching 5700 cd m^–2 is observed at voltages as low as 8 V, demonstrating the potential of this new approach to organic light‐emitting diode (OLED) devices. Unfortunately the device efficiency is rather low because of the high current density flowing through the device. We show that the device only operates after the insertion of an additional hole‐injection layer in between the light‐emitting polymer (LEP) and the metal anode. A simple model that explains the experimental results and provides avenues for further optimization of these devices is described. It is based on the idea that the barrier for electron injection is lowered by the formation of a space–charge field over the metal‐oxide–LEP interface due to the build up of holes in the LEP layer close to this interface.