High-performance 4H-SiC p-i-n ultraviolet avalanche photodiodes with large active area

Ultraviolet(UV) detectors with large photosensitive areas are more advantageous in low-level UV detection applications. In this Letter, high-performance 4 H-SiC p-i-n avalanche photodiodes(APDs) with large active area(800 μm diameter) are reported. With the optimized epitaxial structure and device fabrication process,a high multiplication gain of 1.4 × 10~6 is obtained for the devices at room temperature, and the dark current is as low as ～10 p A at low reverse voltages. In addition, record external quantum efficiency of 85.5% at 274 nm is achieved, which is the highest value for the reported Si C APDs. Furthermore, the rejection ratio of UV to visible light reaches about 10~4. The excellent performance of our devices indicates a tremendous improvement for largearea SiC APD-based UV detectors. Finally, the UV imaging performance of our fabricated 4 H-SiC p-i-n APDs is also demonstrated for system-level applications.     

High temperature characteristics of bilayer epitaxial graphene field-effect transistors on SiC Substrate

In this paper,high temperature direct current(DC) performance of bilayer epitaxial graphene device on SiC substrate is studied in a temperature range from 25℃ to 200℃.At a gate voltage of-8 V(far from Dirac point),the drainsource current decreases obviously with increasing temperature,but it has little change at a gate bias of +8 V(near Dirac point).The competing interactions between scattering and thermal activation are responsible for the different reduction tendencies.Four different kinds of scatterings are taken into account to qualitatively analyze the carrier mobility under different temperatures.The devices exhibit almost unchanged DC performances after high temperature measurements at 200℃ for 5 hours in air ambience,demonstrating the high thermal stabilities of the bilayer epitaxial graphene devices.     

Radio-Frequency Performance of Epitaxial Graphene Field-Effect Transistors on Sapphire Substrates

We report dc and the first-ever measured small signal rf performance of epitaxial graphene field-effect transistors （GFETs）, where the epitaxial graphene is grown by chemical vapor deposition （CVD） on a 2-inch c-plane sapphire substrate. Our epitaxial graphene material has a good flatness and uniformity due to the low carbon concentration during the graphene growth. With a gate length Lg = 100 nm, the maximum drain source current Ids and peak transconductance gm reach 0.92 A/mm and 0.143 S/mm, respectively, which are the highest results reported for GFETs directly grown on sapphire. The extrinsic cutoff frequency （fT） and maximum oscillation frequency （fmax） of the device are 12 GHz and 9.5 GHz, and up to 32 GHz and 21.5 GHz after de-embedding, respectively. Our work proves that epitaxial graphene on sapphire substrates is a promising candidate for rf electronics.     

Large-area 4H-SiC avalanche photodiodes with high gain and low dark current for visible-blind ultraviolet detection

In this Letter, we report large-area(600 μm diameter) 4H-SiC avalanche photodiodes(APDs) with high gain and low dark current for visible-blind ultraviolet detection. Based on the separate absorption and multiplication structure, 4H-SiC APDs passivated with SiN_xinstead of SiO_2 are demonstrated for the first time, to the best of our knowledge. Benefitting from the SiN_x passivation, the surface leakage current is effectively suppressed. At room temperature, high multiplication gain of 6.5 × 10~5 and low dark current density of 0.88 μA∕cm~2 at the gain of 1000 are achieved for our devices, which are comparable to the previously reported small-area Si C APDs.     

基于GaN同质衬底的高迁移率AlGaN/GaNHEMT材料

研究了表面预处理对GaN同质外延的影响,获得了高电子迁移率AlGaN/GaN异质结材料.通过NH_3/H_2混合气体与H_2交替通入反应室的方法对GaN模板和GaN半绝缘衬底进行高温预处理.研究结果表明,NH_3/H_2能够抑制GaN的分解,避免粗糙表面,但不利于去除表面的杂质,黄光带峰相对强度较高;H_2促进GaN分解,随时间延长GaN分解加剧,导致模板表面粗糙不平,AlGaN/GaN HEMT材料二维电子气迁移率降低.采用NH_3/H_2混合气体与H_2交替气氛模式处理模板或衬底表面,能够清洁表面,去除表面杂质,获得平滑的生长表面和外延材料表面,有利于提高AlGaN/GaN HEMT材料电学性能.在GaN衬底上外延AlGaN/GaN HEMT材料,2DEG迁移率达到2113 cm~2/V·s,电学性能良好.     

基于三氯硅烷的高质量4H-SiC多片外延生长

使用三氯硅烷(TCS)作为含氯生长源,在多片外延设备生长了高质量的4H-SiC外延材料.研究了原位预刻蚀气体HCl流量和刻蚀时间对SiC外延材料表面三角形缺陷的影响,使用光学显微镜和表面缺陷分析仪对SiC外延材料表面缺陷进行表征测试和统计,使用傅里叶红外测试仪(FTIR)和原子力显微镜(AFM)对外延材料表面形貌进行表征.结果表明,预刻蚀气体体积流量和时间对4英寸SiC外延材料表面三角形缺陷影响明显,随着HCl体积流量和时间的增加,材料表面的三角形缺陷密度先减小后增加,在HCl流量为100 mL/min、刻蚀时间为20 min时,三角形缺陷密度最低达到0.47cm-2.此外,通过调整C/Si比和载气体积流量等参数,使4英寸SiC外延材料掺杂浓度不均匀性和厚度不均匀性均得到有效改善,结果表明该外延片质量满足SiC电力电子器件的应用.     

表面预处理对石墨烯上范德瓦耳斯外延生长GaN材料的影响

基于范德瓦耳斯外延生长的氮化镓/石墨烯材料异质生长界面仅靠较弱的范德瓦耳斯力束缚,具有低位错、易剥离等优势,近年来引起了人们的广泛关注.采用NH_3/H_2混合气体对石墨烯表面进行预处理,研究了不同NH_3/H_2比对石墨烯表面形貌、拉曼散射的影响,探讨了石墨烯在NH_3和H_2混合气氛下的表面预处理机制,最后在石墨烯上外延生长了1.6μm厚的GaN薄膜材料.实验结果表明:石墨烯中褶皱处的C原子更容易与气体发生刻蚀反应,刻蚀方向沿着褶皱进行;适当NH_3/H_2比的混合气体对石墨烯进行表面预处理可有效改善石墨烯上GaN材料的晶体质量.本研究提供了一种可有效提高GaN晶体质量的石墨烯表面预处理方法,可为进一步研究二维材料上高质量的GaN外延生长提供参考.