两步晶化法合成纳米SAPO-34分子筛及其催化性能

分别以拟薄水铝石、硅溶胶和磷酸为铝源、硅源和磷源,四乙基氢氧化铵为模板剂,采用两步水热晶化法合成出粒径为200～300 nm的纳米级SAPO-34分子筛.采用X射线衍射(XRD)、X射线荧光光谱(XRF)、29Si 、27Al、31P MAS NMR、SEM、BET和NH3-TPD等手段对合成的SAPO-34分子筛进行...     

掺镱大功率光子晶体光纤激光器热效应分析

数值模拟分析了大功率光子晶体光纤(PCF)激光器的温度场和热应力场.通过引入等效热传导率对光子晶体光纤结构进行简化,建立了光子晶体光纤激光器的三维温度场模型.利用有限元方法数值模拟得到了自然对流换热时光子晶体光纤中的温度场及光纤端面的热应力场,并对强制对流换热时光子晶体光纤的冷却效果进行了数值模拟分析.结果表明,对于选取的PCF,通过采取强制对流换热措施可以承受1000 W的抽运功率而不会产生热效应损伤,如果需要通过提高抽运功率以获得更大功率的激光运转,则需要改变光纤的结构.     

高功率光子晶体光纤放大器内超短脉冲的放大传输特性

由速率方程和功率传输方程得到信号脉冲平均功率和增益系数随脉冲传输距离的变化关系.利用Ginzburg-landau方程,在信号脉冲功率的不断增强和增益系数的不断变化的情况下,研究超短脉冲的传输演化特性,发现信号脉冲平均功率、能量和增益系数等参量受到色散和非线性效应的影响相对较小,而信号脉冲的峰值功率、时域和频域特性则易受到色散和非线性效应的影响.探讨了在非线性作用下,脉冲分裂和展宽等所导致的脉宽不稳定性对传输特性的影响,表明研究脉冲传输问题时,引入脉宽不稳定性有利于提高数值模拟准确度.     

基于焦耳热的光纤布喇格光栅电压传感器研究

设计了一种基于焦耳热的新型光纤布喇格光栅电压传感器以用于小电压的精确监测.实验中通过真空蒸镀法在光栅周围镀上一层金属镍,并将光栅密闭封装在充满气凝胶的铜管中.电压传感通过所镀金属镍层在通电过程中产生的焦耳热引起栅区温度升高,导致光纤光栅反射谱中心波长漂移,从而实现电压与光纤光栅中心波长漂移量的变换.实验表明,封装后的直流电压灵敏度达到520pm/V2,并可用于较低频率的交流传感,且系统结构简单、精度高、易于实现.     

全息波导显示系统中输出光栅的优化

全息波导显示系统中输出光栅的衍射效率、位置和长度对整个显示系统的光强输出均匀性及能量利用率有重要的影响.通常输出光强均匀性由输出光栅的衍射效率决定,能量利用率受多重光栅的位置和长度影响.本文以中心视场光束的输出光强均匀为目的,对相应输出光栅衍射效率的位置分布进行优化与曲线拟合,得到输出光栅衍射效率随输出位置连续递增的分布曲线,并应用到所有视场光束.计算结果表明,相比于传统阶梯状衍射效率分布输出光栅,全息波导显示系统中采用具有连续衍射效率分布输出光栅时的光强输出均匀性得到明显提升.针对部分衍射光束未能进入出瞳的现象,提出错位优化法,按照出瞳大小和使用距离优化各重输出光栅的位置和尺寸,减小了光栅的无效衍射区域,提高了出瞳范围内的能量利用率.     

INVESTIGATION OF PHOTOREFRACTIVE TWO-WAVE COUPLING IN Cr-DOPED STRONTIUM BARIUM NIOBATE CRYSTAL

We present here the experimental results of photorefractive two-wave coupling in the congruent strontium barium niobate (SBN:61) crystal doped with 1000ppm Cr. Employing a He－Ne laser (632.8nm), we observed the coupling characteristics under different conditions. The crystal shows excellent photorefractive properties, with a high coupling coefficient nearly 6cm^-1 as the beam intensity ratio m is less than 100. The saturated coupling coefficient of SBN:61:Cr shows a maximum at a certain external beam crossing angle 2θ_peak, which varies with different m, showing a nearly linear dependence on m. The saturated coupling response time τ is measured to be less than 0.8 s. The response time decreased with increasing beam crossing angles no matter how large m is. We also observed the behaviour of the probe beam in reversed experimental procedures. We found that the probe beam shows a bistable state in both procedures.     

Light-induced scattering in SBN：Cr crystal under external electric fields and its suppression

In this paper, the enhancement of light-induced scattering in congruent SBN:Cr (Sr_{0.61}Ba_{0.39}Nb_2O_6:Cr) crystals in the presence of an externally applied electric field and its suppression are studied. If a coherent image is focalized in SBN:Cr crystal without applying external electric field, the output image will remain clear, because of the weak photorefractive effect in the crystal. When a field is applied properly along the crystal axis, markedly enhanced scattering from the signal beam and the output image dispersion can be observed due to the increase of the photorefractive two-beam coupling gain and the light-induced index change in SBN:Cr crystals. By introducing a coherent or incoherent beam with higher intensity the light-induced scattering can be suppressed through the erasure of scattering gratings. The difference between coherent and incoherent beam is that the former can also amplify the signal beam as the scattered light is removed, whereas the latter can only make the signal beam revert to its initial state. The results obtained under different experimental conditions are consistent with theoretical analysis.     

会聚激光扫描铌酸锂晶体写入光波导时的最佳曝光间距

对利用激光精细加工技术在铌酸锂(LiNbO₃)晶体中写入光波导时的最佳曝光间距进行了详细地理论分析和实验研究.通过数值求解简化后的光折变动力学方程组，对会聚激光束沿不同方向扫描晶体时的最佳曝光间距进行了详细的数值模拟.结果表明：最佳曝光间距的选取与写入光束的扫描方向无关；当聚焦激光束平行于光轴扫描晶体时，得不到波导结构，但可以采用“三明治”辐照方式得到对称的折射率分布.采用会聚的绿激光束扫描掺铁铌酸锂(LiNbO₃：Fe)晶体进行了实验研究，晶体中的光致折射率变 关键词： 激光精细加工 最佳曝光间距 光波导 3晶体')" href="#">LiNbO₃晶体     

外电场对SBN：Cr晶体二波耦合特性的影响及应用

对固液同成分SBN：Cr(Sr0.61Ba0.39Nb2O.6：Cr)晶体在外加直流电场作用下的光折变二波耦合特性及其应用进行了实验研究，分析了晶体的二波耦合强度增益 系数随外电场变化的趋势，并给出了实验测量结果.发现在适当的外电场作用下，晶体的光折变二波耦合增益和响 应速度可以得到一定程度的提高.进一步的研究表明，这种电场响应特性有助于改善SBN：Cr晶体的某些应用性能.利用该晶体通过光折变二波耦合非线性放大原理实现光学图像边沿增强时，通过给晶体沿轴向施加适当的外电场，可进一步提高图像边沿增强效果；在基于光 折变边沿增强预处理的联合变换相关器中，适当的外加电场可进一步改善联合变换相关器的相关识别性能. 关键词： SBN：Cr晶体 光折变二波耦合 边沿增强 联合变换相关器     

Visualizations of Light-induced Refractive Index Changes in Photorefractive Crystals Employing Digital Holography

We propose a novel approach to visualize the light-induced refractive index changes in photorefractive crystals employing digital holography. The holograms formed in a Mach-Zehnder interferometer are recorded by a two-dimensional CCD camera. From these holograms, the phase differences, which contain the information of the index changes in photorefractive crystals, are determined by utilizing digital holographic interferometry. Then the two-dimensional visualizations of index changes in the crystals can be obtained. This method is successfully demonstrated in LiNbO3:Fe, KNSBN:Ce and SBN:Cr crystals.