The polar ionosphere at Zhongshan station on May 11, 1999, the day the solar wind almost disappeared

The solar wind almost disappeared on May 11, 1999: the solar wind plasma density and dynamic pressure were less than 1cm⁻³ and 0.1 nPa respectively, while the interplanetary magnetic field was northward. The polar ionospheric data observed by the multi-instruments at Zhongshan Station in Antarctica on such special event day was compared with those of the control day (May 14). It was shown that geomagnetic activity was very quiet on May 11 at Zhongshan. The magnetic pulsation, which usually occurred at about magnetic noon, did not appear. The ionosphere was steady and stratified, and the F₂ layer spread very little. The critical frequency of day-side F₂ layer, f₀F₂, was larger than that of control day, and the peak of f₀F₂ appeared 2 hours earlier. The ionospheric drift velocity was less than usual. There were intensive auroral E_s appearing at magnetic noon. All this indicates that the polar ionosphere was extremely quiet and geomagnetic field was much more dipolar on May 11. There were some signatures of auroral substorm before midnight, such as the negative deviation of the geomagnetic H component, accompanied with auroral E_s and weak Pc3 pulsation.

     

光纤白光干涉仪等臂长技术研究

介绍了几种光纤干涉仪等臂长技术,比较了各自的优缺点和适用范围,对光纤干涉仪的平衡有较大的参考价值。     

SiOx纳米管的制备及其发光特性

以液态金属镓为媒介,利用热蒸发法合成大量非晶SiOx纳米管,这些纳米管管径均匀分布,平均约80 nm,长度大于10μm,且管内外径比例较小．分析发现,在实验过程中,熔入金属镓液滴中的硅元素和氧元素结合并从液滴的表面饱和析出,形成以镓为中心的非晶SiOx纳米管状结构．在室温中,利用260 nm的激发光源激发SiOx纳米管,发现在蓝光波段附近发出强而稳定的PL谱线,这可能与样品中的氧缺陷和空位有关．     

Fiber-optic reflex sensor for in-line production measurement

The paper describes experiments concerning distance measurement with fiber-optic sensor and improvement of the measurement principle. The sensor probe was well-designed with a small structure and multi-function. The novel optical fiber probe arrangement as well as the possibilities of use for complex measurement problems are explained using the measurement of an internal screw thread as an example. The experimental results show that the measurement uncertainty of the thread minor diameter can reach ±10 μm, and the stability of the measurement system is better than 0.07%.     

Efficient microwave induced direct α-halogenation of carbonyl compounds

A novel and direct method for the synthesis of α-halocarbonyl compounds using sequential treatment of carbonyl compounds with [hydroxy(tosyloxy)iodo]benzene followed by magnesium halides under solvent-free microwave irradiation conditions is described.     

The Design for Automation of Pellet-Forming Process in HL-2A Pellet Fueling System

In the ever fusion experiments in SWIP, pellet forming process was carried out through adjusting relative devices by staff member in site, which will make every pellet-forming process slight distinction and will result in pellet difference in shape, size and intensity. In the intervals of HL-2A discharges, staff member have to go site to accomplish the pellet-forming process, this wastes human power and increase the potential danger. So it is necessary to develop a remote control system to perform the pellet-forming process. The control system needs have the features of real-time, reliability and be easy to operate and maintain.     

Solid-state Electrochemistry of Gadolinium Hexacyanoferrate Modified Electrode and Electrocatalytic Properties of Gadolinium Hexacyanoferrate

A new electroactive polynuclear inorganic compound of rare earth metal, gadolinium hexacyanoferrate (GdHCF), was prepared and characterized using the techniques of FTIR spectroscopy, thermogravimetric analysis (TG), UV-Vis spectrometry, X-ray photoelectron spectroscopy (XPS), ICP atomic emission spectroscopy, and EDX. The results of ICP atomic emission spectroscopy, EDX, and TGA indicated that the prepared GdHCF sample had a stoichiometry of NaGdFe(CN)₆·12H₂O (when GdHCF was prepared in NaCl solution). The FTIR spectrum of GdHCF showed that there were two types of water molecules in the structure of GdHCF: one was the interstitial water (5 H₂O), which resulted from the association of water due to H-bonding, and the other was water coordinated with Gd (7 H₂O). The results obtained using XPS showed that the oxidation state of Fe and Gd in the GdHCF sample was +2 and +3, respectively. GdHCF was immobilized on the surface of spectroscopically pure graphite (SG) electrode forming the GdHCF/SG electrode, and the solid-state electrochemistry of the resultant electrode was studied using cyclic voltammetry. The cyclic voltammetric results indicated that the GdHCF/SG electrode exhibited a pair of well-defined and stable redox peaks with the formal potential of E^0′=(197±3) mV. The effects of the concentration of the supporting electrolyte on the electrochemical characteristics of GdHCF were studied, and the results showed that the value of E^0′ increased linearly with the activity of the cationic ion of the supporting electrolyte (lga_Na⁺), with a slope of 54.1 mV, which may become a novel method for determining the activity of Na⁺ in solution. Further experimental results indicated that GdHCF had electrocatalytic activities toward the oxidation of dopamine (DA) and ascorbic acid (AA), and the electrocatalytic current increased linearly with the concentration of DA (or AA) in the range of 1.0–10.0 mmol·L^?1 (for DA) or 0.5–20.0 mmol·L^?1 (for AA).     

Crystallographic report: Bis{[diacetyl‐bis(2,6‐isopropylphenylimine)]nickel(I)(µ‐chloro)}

The first α‐diimine nickel(I) complex having a chloro bridge is reported. The centrosymmetric dinuclear structure of {[ArN?C(Me)C(Me)?NAr]NiCl}₂[Ar?2,6?C₆H₃(i‐Pr)₂] features two chelating α‐diimine ligands and two bridged chlorine atoms, so that a distorted tetrahedral N₂Cl₂ coordination geometry for nickel results. Copyright © 2004 John Wiley & Sons, Ltd.     

Synthesis and characterization of a polyfluorene containing carbazole and oxadiazole dipolar pendent groups and its application to electroluminescent devices

We have synthesized a blue‐light‐emitting polyfluorene (PF) derivative ( PF‐CBZ‐OXD ) that presents bulky hole‐transporting carbazole and electron‐transporting oxadiazole pendent groups functionalized at the C‐9 positions of alternating fluorene units. The results from photoluminescence and electrochemical measurements indicate that both the side chains and the PF main chain retain their own electronic characteristics in the copolymer. An electroluminescent device incorporating this polymer as the emitting layer was turned on at 4.5 V; it exhibited a stable blue emission with a maximum external quantum efficiency of 1.1%. Moreover, we doped PF‐CBZ‐OXD and its analogue PF‐TPA‐OXD with a red‐light‐emitting iridium phosphor for use as components of phosphorescent red‐light emitters to investigate the effect of the host's HOMO energy level on the degree of charge trapping and on the electrophosphorescent efficiency. We found that spectral overlap and individual energy level matching between the host and guest were both crucial features affecting the performance of the electroluminescence devices. Atomic force microscopy measurements indicated that the dipolar nature of PF‐CBZ‐OXD , in contrast to the general nonpolarity of polydialkylfluorenes, provided a stabilizing environment that allowed homogeneous dispersion of the polar iridium triplet dopant. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2925–2937, 2007