Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Ultrahigh‐molecular‐weight‐polyethylene‐fiber surface treatment by electron‐beam‐irradiation‐induced graft polymerization and its effect on adhesion in a styrene–butadiene rubber matrix

Aiming to develop a high‐performance fiber‐reinforced rubber from styrene–butadiene rubber (SBR), we applied a special technique using electron‐beam (EB)‐irradiation‐induced graft polymerization to ultrahigh‐molecular‐weight‐polyethylene (UHMWPE) fibers. The molecular interaction between the grafted UHMWPE fibers and an SBR matrix was studied through the evaluation of the adhesive behavior of the fibers in the SBR matrix. Although UHMWPE was chemically inert, two monomers, styrene and N‐vinyl formamide (NVF), were examined for graft polymerization onto the UHMWPE fiber surface. Styrene was not effective, but NVF was graft‐polymerized onto the UHMWPE fibers with this special method. A methanol/water mixture and dioxane were used as solvents for NVF, and the effects of the solvents on the grafting percentage of NVF were also examined. The methanol/water mixture was more effective. A grafting percentage of 16.4% was the highest obtained. This improved the adhesive force threefold with respect to that of untreated UHMWPE fibers. These results demonstrated that EB irradiation enabled graft polymerization to occur even on the inert surface of UHMWPE fibers. However, the mechanical properties of the fibers could be compromised according to the dose of EB irradiation. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2595–2603, 2004     

Direct observation of chemical oscillation at a water/nitrobenzene interface with a sodium-alkyl-sulfate system.

The oscillation of the interfacial tension and electrical potential at a water/nitrobenzene interface was observed with homologous anionic surfactant molecules, sodium-alkyl-sulfates. Concerning small molecules with a short hydrophobic carbon chain, the oscillation period and amplitude decreased with a decrease of the length of the alkyl chain. On the other hand, when surfactant molecules with a long hydrophobic carbon chain were used, no remarkable periodic oscillation occurred after the first oscillation. In all systems, an interfacial flow by Marangoni convection was observed when the oscillation took place. By monitoring the movement of carbon powder scattered on the liquid/liquid interface with a CCD camera, we could observe that the liquid/liquid interface expanded outward from the area on which the surfactant molecules adsorbed when the oscillation occurred. When the small molecule was used, the speed of expansion of the interface (flow speed) was small and shrinkage followed by expansion of the interface repeatedly occurred. However, when the large molecule was used, the flow speed was large and expansion occurred only one time. These results show that hydrodynamic factors and surface activities are important in chemical oscillation systems.     

Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Linear and Nonlinear Optical Properties Of Racemic (±)2-(α-Methylbenzylamino)-5-Nitropyridine Single Crystals

Linear and nonlinear optical properties of racemic (±)2-(α-methylbenzylamino)-5-nitropyridine ((±)MBANP) single crystals have been comprehensively investigated and compared with those of the enantiomorph (–)2-(α-methylbenzylamino)-5-nitropyridine ((–)MBANP) crystals. (±)MBANP crystal exhibits very high chemical and physical stability, but relatively small nonlinear optical coefficients (d₃₁ = 6.8 pm/V, d₃₂ = 4.7 pm/V, d₃₃ = 0.84 pm/V). A comparison between the nonlinear optical coefficients of (±)MBANP and (–)MBANP demonstrates the validity of the oriented-gas model in molecular crystals that neglects all the contributions from intermolecular interaction.     

Validation of a method for predicting the precision, limit of detection and range of quantitation in competitive ELISA.

The mathematical model for predicting the precision, limit of detection (LOD) and range of quantitation (ROQ) in a competitive enzyme-linked immunosorbent assay (ELISA) proposed by Hayashi et al. (Anal. Chem., 2004, 76, 1295) was validated. The model describes the relative standard deviation (RSD) of concentration estimates by the RSDs of pipetting volumes of analyte, enzyme-conjugated antigen, antibody and substrate solutions, and the standard deviation (SD) of inherent absorbances between the wells in an ELISA plate. For 6 kinds of direct competitive ELISA kits, the LOD and ROQ predicted by the model agreed well with those obtained by experiments with real samples. It was also confirmed that the model is applicable to the prediction of uncertainty that depends on the pipetting error of the viscous antiserum solution. The model was demonstrated to be useful for estimating the LOD and ROQ of competitive ELISA.     

Different acute effects of oral and intratracheal administration of disodium arsenate and gallium arsenide on heme synthesis in rats

The acute influences of arsenic compounds on the metabolism of porphyrins and heme in various organs of rats after oral or intratracheal administration of disodium arsenate (Na₂HAsO₄) and gallium arsenide (GaAs) were examined and compared. For the oral administration experiments, 21 or 84 mg of Na₂HAsO₄, or 2 or 4 g of GaAs, per cm³ saline per kg body weight of each animal was administered to Jcl: Wistar male rats and the organs were removed after exsanguination from the vein of the right axilla under anesthesia with ether, 16 h after administration. In the case of intratracheal administration, rats given 8.2 or 16.4 mg of Na₂HAsO₄, or 0.2 or 0.4 g GaAs per cm³ saline per kg body weight were examined under the same experimental conditions as for the administration route. Increase in the body weight of rats was suppressed after intratracheal administration of the two arsenic compounds. In these rats the hematocrit value increased significantly. These changes were not shown by the orally administered rats. Elevation in δ-aminolevulinate synthase (ALA-S, EC 2.3.1.37) activity in erythroblasts by Na₂HAsO₄ was much higher after intratracheal administration than after oral administration. Suppression in the activities of δ-aminolevulinate dehydratase (ALA-D, EC 4.2.1.24) and porphobilinogen deaminase (PBG-D, EC 4.3.1.8) in peripheral erythrocytes by Na₂HAsO₄ and GaAs were stronger by intratracheal administration than by the oral route. Influences of GaAs on the activity of PBG-D in rat liver were shown to be more effective by oral administration than by the intratracheal route. Oral administration of Na₂HAsO₄ and GaAs had a stronger suppression effect on the activities of ALA-D and PBG-D in rat kidney. It seems from these results that the different extents of the influence of arsenic compounds might depend on the routes of intake.