Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

D3h‐Symmetric Porphyrin‐Based Rigid Macrocyclic Ligands for Multicofacial Multinuclear Complexes in a One‐Nanometer‐Sized Cavity

The one‐step synthesis of D_3h‐symmetric cyclic porphyrin trimers 1 composed of three 2,2′‐[4,4′‐bis(methoxycarbonyl)]bipyridyl moieties and three porphyrinatozinc moieties was achieved from a nickel‐mediated reductive coupling of meso‐5,15‐bis(6‐chloro‐4‐methoxycarbonylpyrid‐2‐yl)porphyrinatozinc. Although cyclic trimers 1 were obtained as a mixture that included other cyclic and acyclic porphyrin oligomers, an extremely specific separation was observed only for cyclic trimers 1 when using columns of silica gel modified with pyrenylethyl, cyanopropyl, and other groups. Structural analysis of cyclic trimers 1 was carried out by means of NMR spectroscopy and X‐ray crystallography. Treatment of an η³‐allylpalladium complex with a cyclic trimer gave a tris(palladium) complex containing three η³‐allylpalladium groups inside the space, which indicated that the bipyridyl moieties inside the ring could work as bidentate metalloligands.     

Development of a Simulation Model for Solid Objects Suspended in a Fluctuating Fluid

We introduce a new scheme for the future application of Real-coded Lattice Gas (RLG) to the numerical simulation of suspended solid objects in a fluctuating fluid environment. The reproduction of Brownian motion for a single solid object is verified through the Gaussian distribution of its displacements. The effectiveness of the solid–solid interaction model is also confirmed in an N-body simulation.     

Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Direct observation of chemical oscillation at a water/nitrobenzene interface with a sodium-alkyl-sulfate system.

The oscillation of the interfacial tension and electrical potential at a water/nitrobenzene interface was observed with homologous anionic surfactant molecules, sodium-alkyl-sulfates. Concerning small molecules with a short hydrophobic carbon chain, the oscillation period and amplitude decreased with a decrease of the length of the alkyl chain. On the other hand, when surfactant molecules with a long hydrophobic carbon chain were used, no remarkable periodic oscillation occurred after the first oscillation. In all systems, an interfacial flow by Marangoni convection was observed when the oscillation took place. By monitoring the movement of carbon powder scattered on the liquid/liquid interface with a CCD camera, we could observe that the liquid/liquid interface expanded outward from the area on which the surfactant molecules adsorbed when the oscillation occurred. When the small molecule was used, the speed of expansion of the interface (flow speed) was small and shrinkage followed by expansion of the interface repeatedly occurred. However, when the large molecule was used, the flow speed was large and expansion occurred only one time. These results show that hydrodynamic factors and surface activities are important in chemical oscillation systems.     

Arithmetic expressions of Selberg's zeta functions for congruence subgroups

In [P. Sarnak, Class numbers of indefinite binary quadratic forms, J. Number Theory 15 (1982) 229-247], it was proved that the Selberg zeta function for SL₂(Z) is expressed in terms of the fundamental units and the class numbers of the primitive indefinite binary quadratic forms. The aim of this paper is to obtain similar arithmetic expressions of the logarithmic derivatives of the Selberg zeta functions for congruence subgroups of SL₂(Z). As applications, we study the Brun-Titchmarsh type prime geodesic theorem and the asymptotic formula of the sum of the class number.