Improvement in flow-sheet of extraction chromatography for trivalent minor actinides recovery

Journal of Radioanalytical and Nuclear Chemistry - Extraction chromatography flow-sheet employing octyl(phenyl)-N,N-diisobutylcarbonoylmethylphosphine oxide and bis(2-ethylhexyl) hydrogen phosphate...     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

An ASE Reduction Filter Using Cascaded Optical Fiber Grating Couplers in EDFA Repeater

A new configuration for an ASE reduction filter in EDFA repeaters for WDM optical transmission systems using optical fiber grating couplers (FGCs) was proposed and first demonstrated. The filtering characteristics of the proposed filter for amplified single wavelength signal and 2-channel WDM signals using EDFA were identified. It was found that the filter was effective to improve SNR in optical domain by reducing ASE noise. The required FGC characteristics for the filter were theoretically predicted under the condition that the total filter loss did not exceed 3 dB. More than 70% of drop efficiency was required in each FGC for the application of the proposed filter to an 8-channel WDM system using EDFA repeaters.     

Discrimination of carbonyl groups of meso-α-diketones with Horner-Wadsworth-Emmons reagent of chiral binaphthyl esters

Asymmetric Horner-Wadsworth-Emmons reactions of selected meso-α-dicarbonyl compounds with chiral phosphonate reagents, which possessed axially dissymmetric 1,1′-bi-2- or 8-naphthol at the carboxylate moiety as a chiral auxiliary, were examined. The reactions proceeded smoothly with good chemical yields as well as with high diastereoselectivities. Z-olefins were preferentially formed, and it was found that the free hydroxy group at the 2′- or 8′-position on the naphthalene ring plays a crucial role in the high diastereoselectivity, probably due to a complex-induced proximity effect. Mechanistic considerations are also described.     

FMS scheduling based on timed Petri Net model and reactive graph search

This paper presents a new scheduling method for manufacturing system based on the Timed Petri Net model and a reactive fast graph search algorithm. The following two typical problems are addressed in this paper. (1) Minimization of the maximum completion time. (2) Minimization of the total tardiness. As for the problem (1), a new search algorithm which combines the RTA^∗ and a rule-based supervisor is proposed. As for problem (2), the original Petri Net model is converted to its reverse model and the algorithm developed for the problem (1) is applied, regarding the due date as the starting time in the reverse model. Some numerical experiments are carried out to demonstrate usefulness of our algorithm.     

Application of novel SIMS technique for imaging the active sites of oxygen reduction at the SOFC cathode/electrolyte interfaces

The oxygen reduction active sites were visualized around the O₂/SOFC cathode/electrolyte triple phase boundaries (TPB) by the¹⁶O/¹⁸O exchange techniques and secondary ion mass spectrometry (SIMS) analysis. The higher¹⁸O concentration is observed on the cathode top surfaces (La_0.9Sr_0.1MnO₃-mesh, Au-mesh, and Ag-porous), which suggested the promotion of oxygen adsorption and oxygen surface exchange at the cathode. The oxygen diffusion through the bulk of cathode occurred at the La_0.9Sr_0.1MnO₃-mesh and the Ag-porous cathodes, not at the Au-mesh cathode. On the YSZ surfaces after removing the cathode, the active sites for oxygen incorporation were analyzed by SIMS. The active sites for oxygen incorporation were at the La_0.9Sr_0.1MnO₃/YSZ interface as well as the TPB. On the other hand, the active sites for oxygen incorporation are limited to the TPB in the case of the Au-mesh removed YSZ surface. From the SIMS analysis, the expansion of the active sites for oxygen incorporation is less than a few μm from the TPB lines. Paper presented at the 8th EuroConference on Ionics, Carvoeiro, Algarve, Portugal, Sept. 16–22, 2001.     

Lattice path combinatorics and asymptotics of multiplicities of weights in tensor powers

We give asymptotic formulas for the multiplicities of weights and irreducible summands in high-tensor powers V_λ^⊗N of an irreducible representation V_λ of a compact connected Lie group G. The weights are allowed to depend on N, and we obtain several regimes of pointwise asymptotics, ranging from a central limit region to a large deviations region. We use a complex steepest descent method that applies to general asymptotic counting problems for lattice paths with steps in a convex polytope.     

Size distribution of fractured areas in one-dimensional systems

We study a one-dimensional model for fracture, identifying fractured areas with intervals on which a stress field exceeds a threshold value. When is a diffusion process, the cumulative numberN(l) of fractured areas whose length is greater thanl obeys a power lawCl ^–p asl0 with probability one. The exponentp and the constantC are determined. The exponentp agrees with the Hausdorff dimension of the end points of fractured areas, i.e., ^–1(). Even if is self-similar with parameterH>0, i.e.,(cx)– is equivalent toc ^H {(x)–} for anyc>0, the exponentp does not depend solely onH;p=H, where(0, 1/H) is another parameter characterizing. Non-diffusion processes are given whereN(l) does not follow a power law.