Improvement in flow-sheet of extraction chromatography for trivalent minor actinides recovery

Journal of Radioanalytical and Nuclear Chemistry - Extraction chromatography flow-sheet employing octyl(phenyl)-N,N-diisobutylcarbonoylmethylphosphine oxide and bis(2-ethylhexyl) hydrogen phosphate...     

Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

D3h‐Symmetric Porphyrin‐Based Rigid Macrocyclic Ligands for Multicofacial Multinuclear Complexes in a One‐Nanometer‐Sized Cavity

The one‐step synthesis of D_3h‐symmetric cyclic porphyrin trimers 1 composed of three 2,2′‐[4,4′‐bis(methoxycarbonyl)]bipyridyl moieties and three porphyrinatozinc moieties was achieved from a nickel‐mediated reductive coupling of meso‐5,15‐bis(6‐chloro‐4‐methoxycarbonylpyrid‐2‐yl)porphyrinatozinc. Although cyclic trimers 1 were obtained as a mixture that included other cyclic and acyclic porphyrin oligomers, an extremely specific separation was observed only for cyclic trimers 1 when using columns of silica gel modified with pyrenylethyl, cyanopropyl, and other groups. Structural analysis of cyclic trimers 1 was carried out by means of NMR spectroscopy and X‐ray crystallography. Treatment of an η³‐allylpalladium complex with a cyclic trimer gave a tris(palladium) complex containing three η³‐allylpalladium groups inside the space, which indicated that the bipyridyl moieties inside the ring could work as bidentate metalloligands.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

Discrimination of carbonyl groups of meso-α-diketones with Horner-Wadsworth-Emmons reagent of chiral binaphthyl esters

Asymmetric Horner-Wadsworth-Emmons reactions of selected meso-α-dicarbonyl compounds with chiral phosphonate reagents, which possessed axially dissymmetric 1,1′-bi-2- or 8-naphthol at the carboxylate moiety as a chiral auxiliary, were examined. The reactions proceeded smoothly with good chemical yields as well as with high diastereoselectivities. Z-olefins were preferentially formed, and it was found that the free hydroxy group at the 2′- or 8′-position on the naphthalene ring plays a crucial role in the high diastereoselectivity, probably due to a complex-induced proximity effect. Mechanistic considerations are also described.     

FMS scheduling based on timed Petri Net model and reactive graph search

This paper presents a new scheduling method for manufacturing system based on the Timed Petri Net model and a reactive fast graph search algorithm. The following two typical problems are addressed in this paper. (1) Minimization of the maximum completion time. (2) Minimization of the total tardiness. As for the problem (1), a new search algorithm which combines the RTA^∗ and a rule-based supervisor is proposed. As for problem (2), the original Petri Net model is converted to its reverse model and the algorithm developed for the problem (1) is applied, regarding the due date as the starting time in the reverse model. Some numerical experiments are carried out to demonstrate usefulness of our algorithm.