Analysis method of the angiotensin-I converting enzyme inhibitory activity based on micellar electrokinetic chromatography.

A micellar electrokinetic chromatography (MEKC) method was developed for estimating the angiotensin-I converting enzyme (ACE) inhibitory activity by separating the hippuric acid liberated in the ACE reaction mixture in the presence of an inhibitor, captopril. The hippuric acid was successfully separated and detected by MEKC with a 25 mM sodium dodecyl sulfate solution in a 25 mM phosphate-50 mM borate buffer at pH 7.0; the total analysis took about 5 min. A good linear relationship was observed between the inhibitor and the peak area of hippuric acid release. No significant difference in the ACE inhibitory activity (IC50) of captopril (an antihypertensive medicine) or autolyzed-mushrooms (functional foods) was observed between the conventional method and the MEKC method. The MEKC method was found to be a useful technique for a rapid assay of the ACE inhibitory activity.     

Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Photo-Absorption and photochemical decomposition of copper and alkaline-earth ß-diketonates as source gases of high-Tc superconducting films

For low-temperature deposition of oxide films relating to Bi-Sr-Ca-Cu-O superconductors, photo-absorption and -decomposition properties were examined with respect to copper and alkaline-earth ß-diketonates. It was confirmed that all ß-diketonates examined were promising as source materials for photochemical vapour deposition (photo-CVD) using a low-pressure mercury lamp, in view of their large light absorption coefficients at wavelength 254 nm. The light irradiation was effective for the formation of highly crystalline oxide films at temperatures below 600 °C. By combining two sources, Ca₂CuO₃ and SrCuO₂ films were prepared. Photo-CVD of c-axis oriented Bi₂Sr₂CuO_x film was achieved by the irradiation of ternary sources of Bi(C₆H₅)₃ and strontium and copper ß-diketonates at 500 °C.     

Major-to-ultratrace elements in bone-marrow fluid as determined by ICP-AES and ICP-MS.

The major-to-ultratrace elements in human bone-marrow fluid were determined by ICP-AES (inductively coupled plasma atomic emission spectrometry), and ICP-MS (inductively coupled plasma mass spectrometry). The bone-marrow fluid sample was centrifuged prior to acid digestion to exclude the bone piece from bone marrow, and then digested with nitric acid. As a result, 20 elements could be determined over the concentration range from 1610 microg g(-1) for Na to 0.00043 microg g(-1) for W. It was found that Fe, Zn and Sb were enriched by ca. 264-, 7- and 15-fold, respectively, in bone-marrow fluid, compared to those in human blood serum. Alkali metals (K, Rb, Cs), except for Na, were also significantly enriched in bone-marrow fluid. Furthermore, the concentrations of various elements, such as Fe, P, Al, Zn, Cu, Se, Zr, Sn, Ag and W, were significantly higher than those in open seawater.     

Spontaneous ignition temperature for the compacted mixture of Ni–Al system: Experiment,theory, and comparisons

Spontaneous ignition of compacted mixture has been examined not only experimentally but also theoretically, relevant to materials synthesis for Ni–Al system. Spontaneous ignition temperature, determined from the inflection-point of the temporal variation of surface temperature, is found to decrease at first, reach the minimum, and then increase gradually, with increasing size ratio, being defined as the ratio of compact and particle diameters and reported to be useful in correlating experimental results. The lowest temperature observed is as low as that, more than 200 K below the melting point 934 K of Al, at the size ratio of c.a. 700. While its decrease is attributed to the increase in the particle surface per unit spatial volume of compacted mixture, as reported in the literature, its increase found in the course of the present study can fairly be correlated to an enhancement of heat loss from each particle in the compacted mixture, by conducting a theoretical consideration. As for the dependence of spontaneous ignition temperature on the mixture ratio, a shifting occurs from a decreasing trend with increasing mixture ratio at small size ratios, less than about 700, to an insensitive trend to the mixture ratio, had not been reported in the literature. In addition, a fair degree of agreement, shown in experimental comparisons with theoretical results, indicates that the present formulation has captured the essential features of the spontaneous ignition of compacted mixture, especially for size ratios with large values. Since this kind of particle size effects, relevant to the spontaneous ignition of the compacted mixtures, has not been captured in the previous studies, its elucidation can be considered not only notable but also useful, in manipulating combustion process in materials synthesis, especially, in choosing a specific condition for the lowest spontaneous ignition temperature by varying the size ratio.     

MJ and collision energy dependent attenuation of Rg (3P2) by CF3Br

The total attenuation cross-section of Rg (³P₂) (Rg = Ar, Kr) by the collision with CF₃Br is measured as a function of the magnetic sub level M_J of Rg (³P₂) and the collision energy. For Ar (³P₂), the attenuation process indicates a M_J dependence, in particular, the cross-section of the M_J = 0 state is lower compared with that for other states. On the other hand, Kr (³P₂) shows no M_J dependent attenuation.     

Fermi-surface reconstruction without breakdown of Kondo screening at the quantum critical point

Motivated by recent Hall-effect experiment in YbRh(2)Si(2), we study ground state properties of a Kondo lattice model in a two-dimensional square lattice using variational Monte Carlo method. We show that there are two types of phase transition, an antiferromagnetic transition and a topological one (Fermi-surface reconstruction). In a wide region of parameters, these two transitions occur simultaneously without the breakdown of Kondo screening, accompanied by a discontinuous change of the Hall coefficient. This result is consistent with the experiment and gives a novel theoretical picture for the quantum critical point in heavy-fermion systems.     

Playback performance of perpendicular magnetic recording tape media for over-50-TB cartridge by facing targets sputtering method

Perpendicular magnetic recording tape medium with laminated soft magnetic underlayers was successively formed on a 4.5 μm thin plastic film by the facing targets sputtering method at room temperature. The tape medium showed extremely high SNR values with sharp transitions in playback tests by a drum tester, compared to a linear format commercial tape medium. An areal density of 45.0 Gb/in.² of perpendicular tape medium was confirmed by a high-resolution contact tester. These results suggest that the perpendicular recording tape medium by the facing targets sputtering method is a promising candidate for a tape cartridge of over 50-TB.