In the present research, magnesium aluminate spinel was prepared as catalyst support using a novel, facile, and efficient mechanochemical method. The Co-promoted catalysts with 20 wt.% of Ni were fabricated using an impregnation route and the samples were analyzed by the X-ray diffraction (XRD), N2 adsorption/desorption (BET), temperature-programmed reduction and desorption (H2-TPR and O2-TPD), and field emission scanning electron microscopy (FESEM) tests. The results confirmed that all samples have a mesoporous structure with a high specific surface area and the presence of cobalt caused complete CH4 oxidation at low temperatures, and no side reactions were observed. The results indicated that the 3%Co-20%Ni/MgAl2O4 catalyst was the optimal sample among the prepared catalysts, owing to the improvement of reduction features and oxygen mobility. The 50 and 90% of methane conversion was obtained at 530 and 600 °C, respectively. Also, the influence of calcination temperature, GHSV, and feed ratio was determined on the catalytic activity. The obtained outcomes revealed that the calcination temperature has a significant effect on the textural properties and catalytic efficiency. The sample calcined at 700 °C showed the weakest performance, which was related to the sintering of particles at high temperatures. The catalytic stability showed that the 3%Co-20%Ni/MgAl2O4 has acceptable stability during 600 min time of reaction.
Journal of Fluorescence - Malachite green (MG) is a dye that has been presented to use as photosensitizers for photodynamic therapy (PDT). Nonlinear absorption coefficient (β) and nonlinear... 相似文献
Enthalpies of mixing (mH) aqueous solutions of CoCl2, CuCl2, and MnCl2 with NaCl solutions were measured at constant ionic strengths of 0.5, 1.0, and 3.0 molal at 25°C. The excess enthalpy equations of Pitzer were then fit to the resulting mH data. The resulting parameters are the temperature derivatives of the activity coefficient mixing parameters in the Pitzer system. The heat of mixing data for CoCl2 and CuCl2 were in agreement with earlier isomolal results by other workers. 相似文献
The chemical composition of the essential oils of the flowers and leaves of Anthemis hyalina were analyzed by GC and GC-MS for the first time. The oils were found to contain seventy-two components. cis-Chrysanthenyl acetate (14.9% and 17.8%), camphor (11.6% and 1.7%), terpinen-4-ol (8.3% and 1.2%), germacrene-D (5.1% and
2.1%), β-caryophyllene (4.1% and 5.4%), myrcene (3.6% and 16.9%), bicyclogermacrene (3.5% and 0.9%), α-pinene (2.3% and 4.1%), cis-β-ocimene (2.1% and 4.3%) and isospathulenol (0.4% and 4.3%) were found to be the major constituents of the oils of flowers
and leaves respectively.
Published in Khimiya Prirodnykh Soedinenii, No. 5, pp. 428–429, September–October, 2006. 相似文献
The dependency of adsorption energy (E) and affinity coefficient (beta) of Dubinin equations (Dubinin-Radushkevich (DR) or Dubinin-Astakhov (DA)) on surface chemistry and porosity of activated carbons was investigated by analyzing adsorption of nitrogen, benzene, trichloroethylene (TCE), and water vapor by several surface-modified activated carbons and carbon fibers. For all studied nonpolar adsorbates, carbons with smaller average micropores showed higher adsorption energies independent of their surface chemistry. For water vapor, carbons with higher surface polarities showed higher adsorption energies due to specific adsorbate-adsorbent interactions. Adsorption energies increased with decreasing average micropore widths. betaN2,DR for different carbons were observed to vary in the 0.292-0.539 range. Carbons with higher degrees of mesoporosity had higher betaN2,DR values, while no dependency was observed between betaN2,DR and surface chemistry. A comparison of DR and DA cases indicates that: (1) the average value of betaN2,DA is considerably above the classical value of this parameter; and (2) the range of betaN2,DA values were smaller compared to betaN2,DR, despite a wide range of mesoporosity of carbons examined. Obtained beta(TCE,DR) values varied in the 0.952-1.243 range, with an average value of 1.085+/-0.083, independent of surface chemistry or porosity of activated carbons. A similar result was observed for beta(TCE,DA). betaH2O,DR values of different granular and fibrous activated carbons changed in the range of 0.081-0.271. They depended more on the carbon surface chemistry and less on the porosity. A similar result was obtained when DA equation was considered. 相似文献
In this paper five equations of state are tested for checking their ability to predict the Joule-Thomson inversion curve.These five equations of state are:Mohsennia-Modarres-Mansoori(MMM),Ji-Lemp(JL),modified Soave-Redlich-Kwang(SRK)equation of state by Graboski(MSRK1),modified SRK equation of state by Peneloux and Rauzy(MSRK2),and modified Peng-Robinson (PR)equation of state by Rauzy(PRmr).The investigated equations of state give good prediction of the low-temperature branch of the inversion curve,except for MMM equation of state.The high-temperature branch and the peak of the inversion curve have been observed,in general,to be sensitive to the applied equation of state.The values of the maximum inversion temperature and maximum inversion pressure are calculated for each component used in this work. 相似文献
Addition of phenyl-, alkyl-, alkenyl- and alkinyl-Grignard reagents to pyridine-N-oxide in THF leads to 5-substituted (2Z, 4E)-pentadien-aldoximes 6 having (E) (syn)-configuration of the C, N-double bond. The unsaturated oximes are shown to arise through an electrocyclic ring opening reaction from the primary Grignard adducts 5 . These can be trapped by protonation at low temperature. 相似文献
Hydroxylamine was found to be a mild reagent for conversion of arylboronic acids and their pinacolyl boronate esters into phenols. This procedure works on most arylboronic acids at room temperature, yielding phenols in moderate to good yields, and efficiently on arylboronates also yielding phenols in good yields. 相似文献