Hybridization in some macrocyclic polyacetylenes

The hybridization in several cyclic polyacetylene compounds has been calculated by the maximum overlap method, assuming planar and non-planar geometries of the molecules. In the planar configuration the hybrids describing the molecular skeleton deviate from the corresponding bond directions. We have a few “bent” bonds, but in contrast to the situation in small rings, here the deviation angles are negative, i.e., the hybrids point toward the inside of the ring. Non-planar structures in which acetylene groups are kept in a plane and CCH₂ or CH₂ groups are displaced out of the plane show less deviation from the bond directions of bent bonds. Furthermore, the deviation angles decrease with an increase in the out-of-plane displacement of methylene groups. Finally, when the angle of bending of the molecules approaches 50°, the deviation vanishes, predicting a puckered conformation for the molecules. Correlation between CC stretching vibration frequencies and the corresponding CC bond overlap is discussed.     

Synthesis, characterization, and tautomerism of four novel copper(I) complexes from 3-hydroxy-3-(p-R-phenyl)-2-propenedithioic acids

The paper describes the synthesis and structural characterization of four novel copper(I) complexes [CuL(PPh(3))(2)] (L = 3-hydroxy-3-(p-R-phenyl)-2-propenedithioate). In addition, a tautomeric equilibrium in solution was found and Hammett correlations with (13)C NMR parameters were studied. The structure of one complex was fully established by X-ray diffraction analysis.     

Stereochemical analysis of N-cyclohexylidene-N-(1-phenylethyl)amine derivatives

The configurational properties of a series of cyclohexylidene imines are discussed on the basis of their 1H, 13C and 15N NMR spectral data.     

Ring-closing metathesis of chiral allylamines. Enantioselective synthesis of (2S,3R,4S)-3,4-dihydroxyproline

The ring-closing metathesis (RCM) of two types of unsaturated chiral allylamines III, easily available from enantiomerically enriched epoxy alcohols, has been studied. Fully protected allylamines IIIa [(1)R = CH(2)-(CH(2))(n)()-CH=CH(2); (2)R = Boc; (3)R = PMB] have been prepared from unsaturated epoxy alcohols, whereas bis-allylamines IIIb ((1)R = Ph, (2)R = allyl,(3)R = Boc or PMB) have been prepared from 2,3-epoxy-3-phenylpropanol. Both types have been subjected to RCM to provide either cyclic allylamine I or II. The synthetic potential of these intermediates has been demonstrated by the enantioselective synthesis of (2S,3R,4S)-3,4-dihydroxyproline.     

Symmetry numbers and chemical reaction rates

This article shows how to evaluate rotational symmetry numbers for different molecular configurations and how to apply them to transition state theory. In general, the symmetry number is given by the ratio of the reactant and transition state rotational symmetry numbers. However, special care is advised in the evaluation of symmetry numbers in the following situations: (i) if the reaction is symmetric, (ii) if reactants and/or transition states are chiral, (iii) if the reaction has multiple conformers for reactants and/or transition states and, (iv) if there is an internal rotation of part of the molecular system. All these four situations are treated systematically and analyzed in detail in the present article. We also include a large number of examples to clarify some complicated situations, and in the last section we discuss an example involving an achiral diasteroisomer.     

Aquatic degradation of triclosan and formation of toxic chlorophenols in presence of low concentrations of free chlorine

The degradation of 2-(2,4-dichlorophenoxy)-5-chlorophenol (triclosan) in chlorinated water samples was investigated. Sensitive determination of the parent compound and its transformation products was achieved by gas chromatography with mass spectrometry detection after sample concentration, using a solid-phase extraction sorbent and silylation of the target compounds. Experiments were accomplished using ultrapure water spiked with chlorine and triclosan concentrations in the low mg/l and ng/ml ranges respectively. Chlorination of the phenolic ring and cleavage of the ether bond were identified as the main triclosan degradation pathways. Both processes led to the production of two tetra- and a penta-chlorinated hydroxylated diphenyl ether, as well as 2,4-dichlorophenol. The formation of 2,3,4-trichlorophenol was not detected in any experiment; however, significant amounts of 2,4,6-trichlorophenol were noticed. All of these five compounds were also identified when triclosan was added to tap-water samples with free chlorine concentrations below 1 mg/l. Minor amounts of three di-hydroxylated phenols, containing from one to three atoms of chlorine in their structures, were also identified as unstable triclosan chlorination by-products. The analysis of several raw wastewater samples showed the co-existence of important concentrations of triclosan and its most stable by-products (2,4-dichlorophenol and 2,4,6-trichlorophenol), reinforcing the potential occurrence of the described transformations when products containing triclosan are mixed with chlorinated tap water.     

Application of a chemometric method for simultaneous determination of acetaminophen and diclofenac in content-uniformity and drug-dissolution studies

A new, repeatable, and rapid method has been developed for resolution of binary mixtures of acetaminophen and diclofenac with minimum sample pretreatment and without separation of the analytes. The method, based on the PLS1 processing of absorbance data in the UV region, was successfully used for quantification of the drug content of three tablet preparations. The results obtained were in good agreement with HPLC recovery data. The method also enabled determination of drug-dissolution profiles of these commercial tablets, by simultaneous determination of both analytes during the dissolution test.     

Diverse evolution of [[Ph(2)P(CH(2))(n)PPh(2)]Pt(mu-S)(2)Pt[Ph(2)P(CH(2))(n)PPh(2)]] (n = 2, 3) metalloligands in CH(2)Cl(2)

The nucleophilicity of the [Pt(2)S(2)] core in [[Ph(2)P(CH(2))(n)PPh(2)]Pt(mu-S)(2)Pt[Ph(2)P(CH(2))(n)PPh(2)]] (n = 3, dppp (1); n = 2, dppe (2)) metalloligands toward the CH(2)Cl(2) solvent has been thoroughly studied. Complex 1, which has been obtained and characterized by X-ray diffraction, is structurally related to 2 and consists of dinuclear molecules with a hinged [Pt(2)S(2)] central ring. The reaction of 1 and 2 with CH(2)Cl(2) has been followed by means of (31)P, (1)H, and (13)C NMR, electrospray ionization mass spectrometry, and X-ray data. Although both reactions proceed at different rates, the first steps are common and lead to a mixture of the corresponding mononuclear complexes [Pt[Ph(2)P(CH(2))(n)PPh(2)](S(2)CH(2))], n = 3 (7), 2 (8), and [Pt[Ph(2)P(CH(2))(n)PPh(2)]Cl(2)], n = 3 (9), 2 (10). Theoretical calculations give support to the proposed pathway for the disintegration process of the [Pt(2)S(2)] ring. Only in the case of 1, the reaction proceeds further yielding [Pt(2)(dppp)(2)[mu-(SCH(2)SCH(2)S)-S,S']]Cl(2) (11). To confirm the sequence of the reactions leading from 1 and 2 to the final products 9 and 11 or 8 and 10, respectively, complexes 7, 8, and 11 have been synthesized and structurally characterized. Additional experiments have allowed elucidation of the reaction mechanism involved from 7 to 11, and thus, the origin of the CH(2) groups that participate in the expansion of the (SCH(2)S)(2-) ligand in 7 to afford the bridging (SCH(2)SCH(2)S)(2-) ligand in 11 has been established. The X-ray structure of 11 is totally unprecedented and consists of a hinged [(dppp)Pt(mu-S)(2)Pt(dppp)] core capped by a CH(2)SCH(2) fragment.