Derivatives of (2R)-N-Glyoxylbornane-10,2-sultam and Their Use as auxiliaries in the diastereoselective spirocyclization of 2-substituted tryptamines

A crude hydrate 6 and a crystalline hemiacetal 7 of glyoxylamide 4 were prepared from crotonamide 5 (Scheme 2). Particularly hemiacetal 7 , but also 6 and the ‘dimer’ 8 (obtained from 7 ) may serve as homochiral auxiliaries. The structure of 8 was determined by X-ray analysis. By arenesulfonyl halides, tryptimines 12–14 of 4 were diastereoselectively transformed into spirotricycles 15–17 and 19 .     

On the continuation for variational inequalities depending on an eigenvalue parameter

In this paper we generalize recent theoretical results on the local continuation of parameter-dependent non-linear variational inequalities. The variational inequalities are rather general and describe, for example, the buckling of beams, plates or shells subject to obstacles. Under a technical hypothesis that is satisfied by the simply supported beam, we obtain the existence of a continuation of both the solution and the eigenvalue with respect to a local parameter. A numerical continuation method is presented that easily overcomes turning points. Numerical results are presented for the non-linear beam.     

Microwave-accelerated Claisen rearrangements of allyl tetronates and tetramates

[3,3]-Sigmatropic rearrangements of allyl tetronates and allyl tetramates to give 3-allyltetronic or -tetramic acids, respectively, proceed within 20-60 min under microwave irradiation (300 W, 130-190 °C). Consecutive (homo)sigmatropic [1,5] H-shifts such as oxa-ene reactions are promoted less effectively, which allows the isolation of Claisen intermediates of sigmatropic domino sequences, in contrast to conventional heating.     

Analysis of semiconducting materials by high-resolution radiofrequency glow discharge mass spectrometry

The analytical capabilities of a high-resolution mass spectrometer in combination with a 13.56 MHz glow discharge ion source for the analysis of semiconducting materials (silicon carbide and gallium arsenide) were studied. It was shown that single positively charged ions of sample material have about 10 eV higher average energy than the ions of the discharge and residual gas. Therefore effective energy separation of the ions of analyte from the ions of the discharge and residual gas was achieved by adjusting the ion transfer optics (breadth and position of energy slit), which improves the analytical capabilities of the developed method.Some analytical applications are presented to illustrate the performance of r.f. GDMS for the bulk analysis of semiconducting materials. The results of the trace element analysis of gallium arsenide and silicon carbide samples are compared with data of independent methods (LIMS, ICP-AES, SIMS).Dedicated to Professor Dr. rer. nat. Dr. h.c. Hubertus Nickel on the occasion of his 65th birthdayOn leave from the Institute of Inorganic Chemistry, 630090 Novosibirsk, Russia     

Standardization of Methods for Characterizing the Surface Geometry of Solids

Since a comprehensive survey published in 1999 [1] much work was done in standardizing measuring methods to characterize the surface geometry of dispersed and/or porous solids and to certify reference materials. The present paper is an extension of a short communication [2]. It gives a survey on existing standards and reports on new drafts and proposals.     

The use of an atomizer for chemical pleurodesis

Summary An atomizer had been designed that could create an aerosol of a liquid with high viscosity. The amount of additional driving gas that had to be used was very low. In a cooperation with the University Hospital in Zurich the atomizer was miniaturized and used for treating six patients.