Heterodienophiles—V : A stereochemical study of aldimine-diene cycloadditions

A study has been made of exo/endo ratios in the formation of azabicyclics via cycloadditions of cyclopenta- or cyclohexa-1,3-diene with N-carbethoxy and N-p -toluenesulfonyl trichloromethyl imines, N-p-toluenesulfonyl trifluoromethyl imine, and N-phenyl-5-methoxyhydantoin. For N-carbethoxy imines both thermal and acid catalyzed cycloadditions were investigated with acid catalysis being notably evident. Cyclic Z-imines afford endo adducts while acyclic imines afford exo/endo mixtures.     

铅离子辐照注碳4H—SiC的红外光谱特性研究

主要研究了铅离子辐照注碳4H—SiC样品在3个不同退火温度下傅立叶变换红外光谱的变化。从红外谱的变化可以知道铅辐照注碳4H-SiC样品在一定深度内出现了非晶层,波数在960—1450cm^-1范围内出现了干涉带,干涉带强度随着退火温度的升高而 变弱。1373K退火后样品的卢瑟福背散射分析结果显示,一定深度内硅原子的背散射产额明显减少。4H-SiC specimens were implanted with C-ions and then irradiated with Pb-ions, and subsequently annealed at three different temperatures. The samples were investigated by using Fourier transformation infrared spectrum（FTIR） and Rutherford backward scattering（RBS）. The obtained FTIR spectra showed that there is a buried amorphous layer close to the ion-incident surface and there are several interference fringes in the range from 960 to 1 450 cm ^-1. The intensity of fringes decreases with the increase of annealing temperature. The obtained RBS spectra showed that the yield of Si atoms in 4H-SiC crystal decreases in a well-defined depth region after annealing at 1 373 K.     

退火对Pb辐照Al2O3单晶发光特性的影响

研究了230MeV的²⁰⁸Pb²⁷⁺辐照Al₂O₃样品及随后在600,900,1100K高温条件下退火后的光致发光特性。从辐照样品的测试结果可以清楚地看到在波长为390,450nm处出现了强的发光峰。辐照量为1×10¹³ions/cm²时,样品的发光峰最强。经过600K退火2h后测试结果显示,380nm发光峰剧烈增强,而其他发光峰显示不明显。在900K退火条件下,380nm的发光峰开始减弱,而在360,510nm出现了明显的发光峰,至到1100K退火完毕后380nm的发光峰完全消失,而360,510nm的发光峰相对增强。从被辐照样品的FTIR谱中看到,波数在460~510cm^-1间的吸收是振动模式,经过离子辐照后,吸收带展宽,随着辐照量的增大,Al₂O₃振动吸收峰消失,说明Al₂O₃振动模式被完全破坏。1000~1300cm^-1之间为Al—O—Al桥氧的伸缩振动模式,辐照后吸收带向高波数方向移动,说明其振动模式受到影响。辐照剂量较小的样品,损伤程度相对较低,经退火晶化后,振动模式基本恢复到单晶状态;辐照剂量较高的样品,损伤程度大,退火处理后表面变得较粗糙,振动模式并未出现,说明结构破坏严重。     

He注入单晶Si表面形貌的变化研究

沿Si的（100）面注入He离子, 能量为30 keV、 剂量为5×1016 ions/cm2。 注入后样品切成几块, 在真空炉中分别做退火处理, 退火温度从600 ℃到1 000 ℃, 退火时间均为30 min。 利用原子力显微镜研究了各个样品表面形貌的演化。 发现样品表面形貌与退火温度相关联。 假设在气泡中He原子与空位的比值很高, 导致样品内部存在高压的He泡, 从而使样品表面形貌发生变化。 探讨了在Si中He泡随退火温度的演化和He原子在材料中的释放机制及其对表面的影响。     

注氦尖晶石的红外光谱研究

利用傅立叶变换红外光谱仪对注He尖晶石样品随退火温变化而引起光吸收性能的变化进行了研究。 发现尖晶石样品在626.4 cm-1附近的吸收峰随注入剂量的增加向小波数方向移动, 而在随后退火过程该吸收峰随退火温度的增加而向大波数方向回复。 该吸收峰的回复行为依赖于注入剂量和退火温度。 认为在626.4 cm-1附近吸收峰随注入剂量和退火温度的这种变化与尖晶石中He的俘获以及释放有关。 The infrared absorption behavior of helium implanted spinel with annealing temperature was studied by Fourier transformed infrared (FTIR) spectroscopy. It was found that the absorbance peak at 626.4 cm-1 shifted to smaller wave numbers with the increase of implantation fluence, while on subsequent annealing the absorbance peak shifted back to larger wave numbers with the increase of annealing temperature. The shift of the peak at 626.4 cm-1 with He implantation/annealing is considered to be related with the trapping and release of helium atoms in lattice sites in the spinel crystal.     

Effects of applied anodic potential and pH on the repassivation kinetics of pure aluminium in aqueous alkaline solution

The repassivation kinetics of pure aluminium have been explored in aqueous alkaline solutions as functions of applied anodic potential and pH by using an abrading electrode technique and a rotating disc electrode. The repassivation rate of the abraded bare surface of pure aluminium increased with increasing applied anodic potential in aqueous alkaline solutions, while it decreased with increasing pH. These results revealed that the growth rate of the passivating oxide film is enhanced by an applied electric field, but it is lowered due to the chemical attack by hydroxyl ions. A potentiostatic anodic current decay transient obtained from the abraded electrode surface showed a constant repassivation rate in neutral and weakly alkaline solutions. In contrast, in concentrated alkaline solutions it was observed to consist of three stages: a high repassivation rate in the initial stage due to a high formation rate of the oxide film on the abraded bare surface; a zero value of the repassivation rate in the second stage due to the dissolution of the oxide film by the attack of OH⁻; a high repassivation rate in the third stage due to a lowered dissolution rate of the oxide film. The dissolution rate of the passivating oxide film was observed to depend on the removal rate of aluminate ions from the oxide/solution interface. Received: 1 April 1998 / Accepted: 3 July 1998     

On the Fundamental Polymer Chemistry of Inverse Vulcanization for Statistical and Segmented Copolymers from Elemental Sulfur

In this concept review, the fundamental and polymerization chemistry of inverse vulcanization for the preparation of statistical and segmented sulfur copolymers, which have been actively developed and advanced in various applications over the past decade is discussed. This concept review delves into a discussion of step-growth polymerization constructs to describe the inverse vulcanization process and discuss prepolymer approaches for the synthesis of segmented sulfur polyurethanes. Furthermore, this concept review discusses the advantages of inverse vulcanization in conjunction with dynamic covalent polymerization and post-polymerization modifications to prepare segmented block copolymers with enhanced thermomechanical and flame retardant properties of these materials.     

Hydrogen transport through Pd-Ni alloy electrodeposited on Pd substrate

Hydrogen transport through a Pd-Ni alloy electrodeposited on a Pd substrate (Pd-Ni/Pd bilayer symmetric electrode) has been investigated using cyclic voltammetry and a.c. impedance spectroscopy combined with the electrochemical hydrogen permeation method. The permeation build-up current transients and the measured impedance spectra were analyzed using the time-lag method for the bilayer electrode and a complex non-linear least squares data-fitting method based upon the derived Faradaic admittance for the hydrogen absorption into and diffusion through the bilayer electrode under the permeable boundary condition, respectively. The value of the hydrogen diffusivity in the Pd-Ni layer was lower than that in the Pd layer. Furthermore, the values of the charge transfer resistance and equilibrium absorption constant for the Pd-Ni/Pd bilayer electrode were higher than those for the Pd single layer electrode. From the experimental results, the role of the thin Ni(OH)₂ film formed on the Pd-Ni layer surface in the hydrogen transport through the Pd-Ni/Pd bilayer electrode is discussed in terms of its passivating effect and extremely large hydrogen solubility. Received: 22 January 1997 / Accepted: 15 April 1997     

Syntheses of 1beta-methylcarbapenems bearing 5-methyl-4-hydroxypyrrolidinone

A new series of 1beta-methylcarbapenems 1a-d bearing 5-methyl-4-mercaptopyrrolidinone rings has been prepared and evaluated for in vitro antibacterial activity and pharmacokinetic parameters. Most compounds showed excellent antibacterial activity and high stability to dehydropeptidase-1. We have synthesized optically active 5-methyl-4-hydroxypyrrolidinones from enantiomerically pure aziridine esters.