2‐connected 7‐coverings of 3‐connected graphs on surfaces

An m‐covering of a graph G is a spanning subgraph of G with maximum degree at most m. In this paper, we shall show that every 3‐connected graph on a surface with Euler genus k ≥ 2 with sufficiently large representativity has a 2‐connected 7‐covering with at most 6k ? 12 vertices of degree 7. We also construct, for every surface F² with Euler genus k ≥ 2, a 3‐connected graph G on F² with arbitrarily large representativity each of whose 2‐connected 7‐coverings contains at least 6k ? 12 vertices of degree 7. © 2003 Wiley Periodicals, Inc. J Graph Theory 43: 26–36, 2003     

Study of the winter and summer changes of the air composition in the church of Szalowa, Poland, related to conservation

The St. Michael Archangel’s Church in Szalowa, Poland, was selected for closer investigation with respect to the indoor/outdoor air exchange and its influence on the air quality and work arts preservation. Chemical composition, size and abundance of particulate matter and concentration of gases NO₂, SO₂, O₃ inside and outside the church were determined. To study seasonal variation of the weather condition (temperature, inversion level, wind direction) and the influence of seasonal sources of the air pollution (like heating of the nearby houses), samples were collected in winter and summer time. It was stated that suspended particulate matter inside the wooden church has in general an outdoor source. Several groups of particles were distinguished such as the organic ones, soil dust, nitrates and sulphates. In case of organic and soil dust particles, the concentration inside was higher than outside. From the results, in comparison to literature data, one can conclude that accumulation of particulate suspended matter in the church is more intense than in other types of buildings. Gaseous pollutants were detected but their concentration was negligible.     

Parathyroid hormone and bone mineral content in male and female patients receiving hemodialysis

Relative bone mineral content in the lumbar spine was measured by phantom B-MAs with the apparatus of computerized tomography in order to study the relationships between bone mineral content with age and parathyroid hormone in sera of randomized out- and in-patients and the hemodialysis patients. There exists a significant difference between male and female in the loss of bone mineral content of three groups.     

Clinical evaluation of osteocalcin in sera of the patients with neoplasms of bone

The clinical significance of osteocalcin in sera of bone tumors were measured in sera of various kinds of bone tumors. The levels of osteocalcin were higher in bone tumors than those in normal subjects. Serum osteocalcin levels in hypercalcemic groups of bone metastasis and myeloma showed a remarkable increase in a parallelism with serum ALP and LDH levels. These results suggested to be directly or indirectly activated on osteoblast by bone tumors and to be synthesized osteocalcin in osteoblast.     

The study in the relationship between serum calcium and serum parathyroid hormone (PTH) by employing the various kits of PTH assay

In order to evaluate the influences of serum PTH assay in the various concentrations of serum calcium, we divided into three groups which serum calcium had below 8.0 mg/dl, 8.2 mg/dl to 9.8 mg/dl and above 10.0 mg/dl at random samples and assayed PTH in serum sample, using various kits of PTH assay obtained from commercial sources. Our results suggested that the measurement of serum PTH influenced by the concentration of serum calcium and therefore, should be taken an attention of serum calcium in each sample.     

Solvent effect on the radical polymerization of di-n-butyl itaconate

Solvent effect on the polymerization of di-n-butyl itaconate (DBI) with dimethyl azobisisobutyrate (MAIB) was investigated at 50 and 61°C. The solvents used were found to affect significantly the polymerization. The polymerization rate (R_p) and the molecular weight of the resulting polymer are lower in more polar solvents. The initiation rate (R_i) by MAIB, however, shows a trend of being rather higher in polar solvents. The stationary state concentration of propagating poly(DBI) radical was determined by ESR in seven solvents. The rate constants of propagation (k_p) and termination (k_t) were evaluated by using R_p, R_i, and the polymer radical concentration observed. The k_p value decreases fairly with increasing polarity of the solvent used, whereas k_t is not so influenced by the solvents. The solvent effect on k_p is explained in terms of a difference in the environment around the terminal radical center of the growing chain. Copolymerization of DBI with styrene (St) was also examined in three solvents with different physical properties. The poly(DBI) radical shows a lower reactivity toward St in a more polar solvent.     

Theoretical investigation of CO interaction with copper sites in zeolites: periodic DFT and hybrid quantum mechanical/interatomic potential function study

Periodic DFT and combined quantum mechanics/interatomic potential function (QM-pot) models were used to describe the interaction of CO with the Cu+ sites in FER. The CO stretching frequencies were calculated using omega(CO)(CCSD(T))/r(CO)(DFT) scaling method relating frequencies determined using a high-level quantum-chemical (coupled clusters) method for simple model carbonyls to CO bond lengths calculated using periodic DFT and QM-pot methods for the Cu+-zeolite system. Both periodic DFT and QM-pot models together with omega(CO)/r(CO) scaling describe the CO stretching dynamics with the "near spectroscopic accuracy", giving nu(CO) = 2156 cm(-1) in excellent agreement with experimental data. Calculations for various Cu+ sites in FER show that both types of Cu+ sites in FER (channel-wall sites and intersection sites) have the same CO stretching frequencies. Thus, the CO stretching frequencies are not site-specific in the CO/Cu+/FER system. The convergence of the results with respect to the model size was analyzed. When the same exchange-correlation functional is used the adsorption energies from periodic DFT and QM-pot are in good agreement (about 2 kcal/mol difference) but substantially larger than those of the experiment. The adsorption energy calculated with the B3LYP functional agrees with available experimental data. The overestimation of the adsorption energy in DFT calculations (periodic or QM-pot) is related to a red-shift of the CO stretching mode, both result from an underestimation of the HOMO(5sigma)-LUMO(2pi) gap of CO and the consequent overestimation of the Cu(+)(d)-CO(2pi*) back-donation. For the adsorption energy, this can be overcome by the use of hybrid B3LYP exchange-correlation functional. For the frequency calculations, the DFT problem can be overcome by the use of the omega(CO)(CCSD(T))/r(CO)(DFT) correlation.     

A synthesis, including asymmetric synthesis, of α-quaternary α-amino aldehydes from ketones and chloromethyl p-tolyl sulfoxide via sulfinylaziridines

Treatment of 1-chlorovinyl p-tolyl sulfoxides, prepared from ketones and chloromethyl p-tolyl sulfoxide, with N-lithio arylamines resulted in the formation of sulfinylaziridines in good to high yields. The sulfinylaziridines were treated with N-lithio aniline or N-lithio p-chloroaniline to afford α-quaternary α-amino aldehydes in good yields. From α-quaternary α-amino aldehydes, α-quaternary α-amino acid esters and β-quaternary β-amino alcohols were obtained. When optically active chloromethyl p-tolyl sulfoxide was used in this procedure, a method for the synthesis of optically active α-quaternary α-amino aldehydes was realized. The reaction mechanism, including asymmetric induction, for the formation of the sulfinylaziridines is described.     

Kinetic and ESR studies on the radical polymerization of Di-n-butyl itaconate in benzene

The polymerization of di-n-butyl itaconate (DBI) intiated with AIBN was kinetically investigated in benezene. The polymerization rate (R_p) was expressed by: R_p = k[AIBN]^0.5[DBI]^1.7. The polymerization showed a considerably low overall activation energy of 15.3 kcal/mol. The initiator efficiency of AIBN in this system decreased with increasing DBI concentration, ranging from 0.34 to 0.55°C, which is ascribable to viscosity effect due to the monomer. From an ESR study, the polymerization system was found to involve two kinds of persistent radicals, namely, primary propagating ( III ) and propagating ( I ) radicals. The relative concentration of III to I increased with decreasing monomer concentration. Azo-nitrile initiators such as AVN and ACN similarly produced two persistent radicals, while MAIB, DBPO, and PBO yielded only propagating radical I as persistent. The MAIB-initiated polymerization of DBI was also performed in benzene. Similar kinetic features were observed, that is, a higher dependence of R_p on the DBI concentration and a low overall activation energy (14.4 kcal/mol). The following rate equation was obtained at 50°C:R_p = k[MAIB]^0.5[DBI]^1.6. The initiator efficiency of MAIB decreased with increasing DBI concentration, ranging from 0.32 to 0.53 at 50°C. The concentration of propagating radical I was determined by ESR at 50 and 61°C, from which k_p and k_t were estimated. The k_p value increased with increasing monomer concentration, while the k_t one decreased with the DBI concentration. These values are much lower compared with those of MMA.     

Single-Round DNA Aptamer Selection by Combined Use of Capillary Electrophoresis and Next Generation Sequencing: An Aptaomics Approach for Identifying Unique Functional Protein-Binding DNA Aptamers

In DNA aptamer selection, existing methods do not discriminate aptamer sequences based on their binding affinity and function and the reproducibility of the selection is often poor, even for the selection of well-known aptamers like those that bind the commonly used model protein thrombin. In the present study, a novel single-round selection method (SR-CE selection) was developed by combining capillary electrophoresis (CE) with next generation sequencing. Using SR-CE selection, a successful semi-quantitative and semi-comprehensive aptamer selection for thrombin was demonstrated with high reproducibility for the first time. Selection rules based on dissociation equilibria and kinetics were devised to obtain families of analogous sequences. Selected sequences of the same family were shown to bind thrombin with high affinity. Furthermore, data acquired from SR-CE selection was mined by creating sub-libraries that were categorized by the functionality of the aptamers (e. g., pre-organized aptamers versus structure-induced aptamers). Using this approach, a novel fluorescent molecular recognition sensor for thrombin with nanomolar detection limits was discovered. Thus, in this proof-of-concept report, we have demonstrated the potential of a “DNA Aptaomics” approach to systematically design functional aptamers as well as to obtain high affinity aptamers.