Faster GC analyses performed by flow programming in short capillary columns

The technique of programming the carrier gas flow rate in gas chromatography, especially in connection with the use of capillary columns shorter than 10 m can significantly accelerate GC analyses. Equations for calculation of the parameters of the exponential flow function and retention data are described. The effects of flow programming in a short capillary column are shown in a few chromatograms. Different programming rates are tested and compared with temperature programming.     

A novel germanate, Cu2Fe2Ge4O13, with a four tetrahedra oligomer

The structure of Cu₂Fe₂Ge₄O₁₃, previously thought to be CuFeGe₂O₆, has been determined from single-crystal X-ray diffraction data to be monoclinic, P2₁/m, a=12.1050(6), b=8.5073(4), c=4.8736(2) Å, β=96.145(1)°, Z=2, with R1=0.0231 and wR2=0.0605. The unique structure has an oligomer of four germanate tetrahedra, cross-linked laterally by square-planar copper ions, joined end-to-end by a zigzag chain of edge-sharing iron oxide octahedra. Running along the a-direction the metal oxide chain consists of alternating Cu-Cu and Fe-Fe dimers. A hypothetical series of homologous structures (Cu_n−2Fe₂Ge_nO_3n+1 with n=3,4,…,∞) with different length germanate oligomers is proposed, where as n increases, the infinite chain of the CuGeO₃ is approached. In this context, Cu₂Fe₂Ge₄O₁₃ is viewed as being built from blocks of CuGeO₃ and the Fe oxide chains. This material has significance to the study of low-dimensional mixed-spin systems.     

High-resolution,imaging TOF-SIMS: novel applications in medical research

The use of high-resolution, imaging TOF-SIMS is described and examples are made to demonstrate the application of the method in medical research. Cytochemistry by TOF-SIMS is shown by localization of diacylglycerol (DG) in cryostat sections of hyaline cartilage and by localization of corticosterone in cryostat sections of the adrenal gland cortex. Quantitative measurements and comparison of groups is shown by comparing the lipid content of adipose tissue from two mouse strains, transgenic mouse expressing the FOXC2 gene and wild-type controls. Finally, biopsies made for histopathological diagnosis of infantile reversible cytochrome c oxidase deficiency myopathy were analyzed in order to define the chemical content of areas showing a pathological structure in the light microscope. The use of high-resolution, imaging TOF-SIMS in medical research allows analysis of intact tissue and probe-free localization of specific target molecules in cells and tissues. The TOF-SIMS analysis is not dependent on penetration of reagents into the sample and also independent of probe reactivity such as cross-reactivity or background staining. The TOF-SIMS method can be made quantitative and allows for analysis of specific target molecules in defined tissue compartments.     

Mobile phase selection for the combined use of liquid chromatography–inductively coupled plasma mass spectrometry and electrospray ionisation mass spectrometry

Four different organic solvents: dimethylformamide, 1,4-dioxane, n-propanol and ethanol were evaluated as alternative organic modifiers to acetonitrile for liquid chromatography (LC) separations. The aim was to establish common sets of chromatographic conditions that could be applied for LC hyphenation to inductively coupled plasma mass spectrometry (ICPMS) as well as to electrospray ionization MS (ESIMS). The approach was to evaluate candidate solvents that, compared to acetonitrile, potentially could give improved analytical performance (low solvent vapor loading, maximized analyte sensitivity and minimized carbon depositions on instrumental parts) in ICPMS analysis while retaining chromatographic and ESIMS performances. The study showed that dimethylformamide, 1,4-dioxane, n-propanol and ethanol all can be advantageous chromatographic modifiers for LC–ICPMS analysis, giving superior performance compared to acetonitrile. For the combined use of LC–ICPMS and LC–ESIMS with a common set of chromatographic conditions, n-propanol gave the best overall performance. The ¹⁹⁵Pt⁺ signal in ICPMS was continuously monitored during a 0–60% organic solvent gradient and at 25% of organic modifier, 100% of the signal obtained at the gradient start was preserved for n-propanol compared to only 35% of the signal when using acetonitrile. Platinum detection limits were 5–8 times lower using n-propanol compared with acetonitrile. Signal-to-noise ratio in continuous ESIMS signal measurements was 100, 90 and 110 for a 100 μg/ml solution of leucine–enkephaline using acetonitrile, ethanol and n-propanol, respectively. Chromatographic efficiency in reversed phase separations was preserved for n-propanol compared to acetonitrile for the analysis of the whole protein cytochrome C and the peptide bacitracin on a column with particle and pore sizes of 5 μm and 300 Å, but slightly deteriorated for the separation of the peptides leucine–enkephaline and bacitracin on a 3 μm and 90 Å column as the peak width at half height for both peptides increased by a factor of two. The performance on the smaller dimensioned column could however be improved by running the separations at 40 °C.     

Microstructural prototyping of ceramics by kinetic engineering: applications of spark plasma sintering

The significance of kinetics on the development of microstructures in connection with sintering of ceramics is well recognized. In practice, however, it still remains a challenge to prepare designed microstructures via engineering the sintering kinetics because of an insufficient understanding of the different operative mechanisms that are in many cases overlapping. In this article the kinetic issues involved in sintering are described and discussed with respect to their potential for prototyping microstructures that yield desired properties. By exploiting and mastering the differences present in the kinetics of grain sliding, densification, chemical reactions, and grain growth, respectively, we have established processing principles for producing bulk ceramics with microstructures consisting of nano-sized grains, aligned grains, and/or non-equilibrium-phase constitutions, and for achieving radically improved superplasticity in brittle ceramics. Although the studies quoted in this article were mainly carried out by spark plasma sintering, more general implications of them are expected, including efficient particle sliding, deformation-induced dynamic ripening, superplastic deformation-induced dynamic ripening, and non-equilibrium integration.     

Visual spatial memory is enhanced in female rats (but inhibited in males) by dietary soy phytoestrogens

Background  

In learning and memory tasks, requiring visual spatial memory (VSM), males exhibit superior performance to females (a difference attributed to the hormonal influence of estrogen). This study examined the influence of phytoestrogens (estrogen-like plant compounds) on VSM, utilizing radial arm-maze methods to examine varying aspects of memory. Additionally, brain phytoestrogen, calbindin (CALB), and cyclooxygenase-2 (COX-2) levels were determined.     

Application of low energy gamma-spectrometry in rapid actinide analysis for emergency preparedness

For preparedness purposes, a fast and reliable method is essential to quickly assess radioactive fallout in the environment. The rapid determination of certain nuclides such as alpha-emitting actinides is necessary to make initial environmental and agricultural advisories. Therefore, a method using a preconcentration resin and low energy gamma-spectrometry was developed to a fast determination of certain nuclides in soil samples. The preconcentration resin allows samples to be partially purified and then directly measured by gamma-spectrometry without further extraction or separation. The initial gamma-measurement provides fast and accurate determination of certain nuclides such as ²⁴¹Am and ²³⁵U which are normally analyzed by alpha-spectrometry, but require additional time-consuming purification and separation steps. After gamma-spectrometry, the sample may be further processed and analyzed by traditional methods to determine actinides or other nuclides more precisely.