Experimental investigation and numerical simulation of the influence of resonator-length detuning on the output power,pulse duration and spectral width of a cw mode-locked picosecond optical parametric oscillator

We report on a cw mode-locked non-critically phase matched KTP optical parametric oscillator synchronously pumped by a picosecond Ti:Sapphire laser. High average signal output power of up to 950 mW over a large tuning range has been achieved. For this OPO the influence of resonator-length detuning on the output power, pulse duration and spectral bandwidth has been investigated. The measured data are in good agreement with the results of a numerical simulation using a split-step Fourier method which considers the group-velocity mismatch, the group-velocity dispersion and the self-phase modulation. The numerical simulation also describes the measured strong pump depletion and its influence on the OPO output and efficiency.     

Continuous Preparation of Calcite,Aragonite and Vaterite,and of Magnesium‐Substituted Amorphous Calcium Carbonate (Mg‐ACC)

The three water‐free calcium carbonate polymorphs calcite, aragonite and vaterite were prepared from aqueous solutions without additives using standard laboratory equipment in a continuous process. Variation parameters were the way of mixing, the solution concentrations, and the reactor residence time. The samples were crystallographically and chemically pure, but a thorough elemental analysis revealed the presence of small amounts of sodium carbonate which was not detectable by X‐ray powder diffraction. The continuous process avoids the inherent variability of batch syntheses. By adapting the crystallization parameters, magnesium‐substituted amorphous calcium carbonate (molar ratio of Mg:Ca of 1:2.68) was prepared in this continuous process.     

Direct electrochemistry of cytochrome c on nanotextured diamond surface

Nanotextured diamond surfaces with geometrical properties close to protein dimensions were used for the realization of direct electron transfer of cytochrome c (cyt c) without any covalent bonding. The peroxidase activity of native and denatured cyt c was also investigated. Cyclic voltammograms of native cyt c show quasi-reversible electron transfer reactions, while no heme redox activity is detected for denatured cyt c. Unfolding (denaturation) of cyt c can be achieved in the presence of hydrogen peroxide. Partially or fully denatured cyt c showed higher peroxidase activity than native cyt c. This is because denatured cyt c loses its tertiary structure and hydrogen peroxide is easier to access the heme redox center. The apparent Michaelis–Menten constant K_m for native and denatured cyt c has been determined to be 0.23 mM and 0.08 mM.     

111 W, 110 MHz repetition-rate, passively mode-locked TEM00Nd:YVO4 master oscillator power amplifier pumped at 888 nm

We report on an 888 nm pumped passively mode-locked TEM(00)Nd:YVO(4) oscillator providing 56 W of average power at a repetition rate of 110 MHz with 33 ps pulse duration, further amplified to 111 W in a 52% optical efficiency single-pass amplifier stage, maintaining beam quality at M(2)=1.05. Frequency doubling in a LiB(3)O(5) crystal generated up to 87 W at 532 nm, while a third harmonic power of 35 W was achieved in a nonoptimized tripling configuration, corresponding to 80% and 33% conversion efficiency.     

A Synthetic Adenylation‐Domain‐Based tRNA‐Aminoacylation Catalyst

The incorporation of non‐proteinogenic amino acids represents a major challenge for the creation of functionalized proteins. The ribosomal pathway is limited to the 20–22 proteinogenic amino acids while nonribosomal peptide synthetases (NRPSs) are able to select from hundreds of different monomers. Introduced herein is a fusion‐protein‐based design for synthetic tRNA‐aminoacylation catalysts based on combining NRPS adenylation domains and a small eukaryotic tRNA‐binding domain (Arc1p‐C). Using rational design, guided by structural insights and molecular modeling, the adenylation domain PheA was fused with Arc1p‐C using flexible linkers and achieved tRNA‐aminoacylation with both proteinogenic and non‐proteinogenic amino acids. The resulting aminoacyl‐tRNAs were functionally validated and the catalysts showed broad substrate specificity towards the acceptor tRNA. Our strategy shows how functional tRNA‐aminoacylation catalysts can be created for bridging the ribosomal and nonribosomal worlds. This opens up new avenues for the aminoacylation of tRNAs with functional non‐proteinogenic amino acids.     

DYNGA: a general purpose QM-MM-MD program. I. Application to water

We present a general purpose QM-MM-MD engine (DYNGA) designed to test alternative hybrid Hamiltonians geared towards the treatment of problems of interest in structural biology including the use of experimental data constraints. In this first presentation we use DYNGA to explore the behaviour of a traditional QM-MM approach in the treatment of the water—water interaction. We find the potential energy hypersurface for the water dimer computed with the HF 4–31G*/TIP3P hybrid Hamiltonian tends to be too flat. We also explore the effect of using traditional QM-MM techniques on proton wires and conclude there is a need for improvement, possibly addressed by using polarizable force fields.     

PAST AND FUTURE MANAGEMENT OF A COLLAPSED FISHERY: THE BAY OF BISCAY ANCHOVY

Abstract We analyze the efficiency of the international management of the Bay of Biscay anchovy. While a sharing agreement between France and Spain has been in place since 1992, the fish stock collapsed in 2005 and the fishery closed from 2005 to spring 2010. We consider differences in production technologies between both countries and calibrate our model using data from 1987 to 2009. Our results suggest two sources of rent dissipation under the existing sharing agreement: inefficient quota allocation and production inefficiencies due to inflexible national regulations. We discuss several alternatives to improve management.