Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

Evaluation of atomic fluorescence, absorption and emission techniques for the determination of mercury

Summary Atomic fluorescence (AFS), absorption (AAS) and emission (AES) systems were evaluated for the determination of inorganic mercury. Identical vapour generation and amalgamation procedures were used to permit direct comparison of the performance of a commercial long-path AAS instrument to laboratory constructed non-dispersive AFS as well as He-MIP based AES instruments. Instrumental noise-limited detection limits (LOD) were 0.94, 2.4, 2.8 pg for AAS, AES and AFS techniques, respectively. Methodological LOD's were found to be blank controlled and similar for all three instruments, viz. 9, 25 and 16 pg for AAS, AFS and AES, respectively. All three systems produced accurate results at the low ng/l concentration, as verified by the analysis of a certified river water reference material (NRCC ORMS-1).     

Synthetic studies on (−)-FR182877: construction of the ABCD ring system via the intramolecular cycloadditions (2)

Construction of the ABCD ring system of (−)-FR182877 via the intramolecular Diels-Alder (IMDA) reaction and the highly diastereoselective intramolecular hetero-Diels-Alder (IMHDA) reaction is described. The IMHDA reactions of the substrates incorporating the oxabutadiene with the E- or Z-alkene were examined, revealing that the sole product was obtained from both substrates and the E-alkene geometry was found to be crucial to obtaining the desired product.     

Absolute stereochemistry of citrinadins a and B from marine-derived fungus

[Structure: see text]. Citrinadin A (2) is a pentacyclic indolinone alkaloid isolated from the cultured broth of a fungus, Penicillium citrinum, which was separated from a marine red alga. The absolute stereochemistry of the pentacyclic core in 2 and its new congener, citrinadin B (1), was elucidated by analysis of the ROESY spectrum for the chlorohydrin derivative (3) of 1 as well as comparison of the electronic circular dichroism (ECD) spectra for 1 and 2 with those of known spirooxiindole alkaloids. On the other hand, the absolute configuration at C-21 bearing an epoxide ring was assigned as S by comparison of the vibrational circular dichroism (VCD) spectra of 1 with those of model compounds 2S- and 2R-2,3-epoxy-3,3-dimethyl-1-phenylpropan-1-one (4a and 4b, respectively).     

Amphidinolide X,a novel 16-membered macrodiolide from dinoflagellate Amphidinium sp

A novel cytotoxic 16-membered macrodiolide, amphidinolide X (1), has been isolated from a marine dinoflagellate Amphidinium sp. (strain Y-42). The gross structure of 1 was elucidated on the basis of spectroscopic data including one-bond and long-range (13)C-(13)C correlations. The relative and absolute stereochemistries were determined by combined analyses of NOESY data and (1)H-(1)H and (1)H-(13)C coupling constants of 1 and NMR data of the degradation products. Amphidinolide X (1) is the first macrodiolide consisting of polyketide-derived diacid and diol units from natural sources. The biosynthetic origins of 1 were investigated by means of feeding experiments with (13)C-labeled acetates.     

Determination of magnesium and calcium ions in seawater by capillary zone electrophoresis

Capillary zone electrophoresis is proposed for the determination of magnesium and calcium ions in seawater. A carrier solution containing EDTA was adopted for the complexation of these ions and the effect of sodium chloride concentration in the sample solutions on the results was examined. It was found that magnesium and calcium ions could be determined without any pretreatment by injecting 100-fold diluted seawater samples. Linear calibration graphs were obtained for standard solutions containing up to 10.0 mg/l of calcium ion when both peak area and peak height were used. On the other hand, a linear calibration graph was obtained for standard solutions containing up to 20.0 mg/l of magnesium ion when the peak area was used, while a curved one was obtained when the peak height was used. Relative standard deviations were 0.8 and 1.2% when a standard solution containing 5.0 mg/l of magnesium and 8.0 mg/l of calcium ions was analysed 8 times using the peak area. Limits of detection for magnesium and calcium ions were 0.13 and 0.26 mg/l, respectively. The proposed method was applied to the determination of magnesium and calcium ions in surface and bottom seawater samples.     

Simultaneous determination of bromide and iodide ions by capillary isotachophoresis using quaternary ammonium salts

Bromide and iodide ions were determined simultaneously by capillary isotachophoresis using an aqueous electrolyte system; the separation principle was based on the ion-pairing equilibria between tetradecyldimethylbenzylammonium ion and these anions in the leading electrolyte. The interaction between iodide ion and tetradecyldimethylbenzylammonium ion was stronger than that for bromide ion. Thus complete separation of bromide and iodide ions could be obtained by using a leading electrolyte containing 1.5 mM tetradecyldimethylbenzylammonium ion. The pH of the leading electrolyte was adjusted to 5.0. The relative standard deviations of the zone length for bromide and iodide ions were 1.1 and 1.2%, respectively, when mixture of 3.0 mM of these ions was analysed. A 150-μl volume could be injected for the simultaneous determination of low concentrations of bromide and iodide ions.     

Gamma-ray spectra of 201Tl-radiopharmaceuticals with a scintillation camera--crosstalk of contaminating nuclides of 200Tl and/or 202Tl onto 201Tl-photopeaks

In cardiac imaging with 201Tl, the collimator for low energy high resolution is generally used, and also the energy window, which is set on the spectral display of a pulse height analyzer of a scintillation camera, is chosen 70 +/- 12.5 keV. The purpose of this study is to discuss those conditions in 201Tl imaging with the scintillation camera. Two types of collimators for HR (high resolution) and ME (medium energy) were used in this experiment, and we measured the pulse height spectra of 201TlCl radiopharmaceuticals in air and in a cuboid phantom, connecting a multi-channel pulse height analyzer to the scintillation camera. As a result of measuring of the pulse height spectra, two different energies of gamma rays which are not supposed to emit from 201Tl nuclide were observed, and we also identified the presence of a small amount of 202Tl (with 439 keV) and/or 200Tl (with 368 keV) from their half-life measurements. Thus, the use of the HR-collimator with 201Tl imaging is not suitable, because the shielding effects of its septa is poor to 439 keV gamma-rays, and the scattered radiation produced by the Compton interaction contributes to the principal photopeak on the pulse height spectrum. Here, we recommend the use ME-collimator instead of the HR-one, and of the window width of 76 +/- 25 keV for increasing the count rate.     

Structural confirmation of oligosaccharides newly isolated from sugar beet molasses

ABSTRACT: BACKGROUND: Sugar beet molasses is a viscous by-product of the processing of sugar beets into sugar. The molasses is known to contain sucrose and raffinose, a typical trisaccharide, with a well-established structure. Although sugar beet molasses contains various other oligosaccharides as well, the structures of those oligosaccharides have not been examined in detail. The purpose of this study was isolation and structural confirmation of these other oligosaccharides found in sugar beet molasses. RESULTS: Four oligosaccharides were newly isolated from sugar beet molasses using high-performance liquid chromatography (HPLC) and carbon-Celite column chromatography. Structural confirmation of the saccharides was provided by methylation analysis, matrix-assisted laser desorption/ionaization time of flight mass spectrometry (MALDI-TOF-MS), and nuclear magnetic resonance (NMR) measurements. CONCLUSION: The following oligosaccharides were identified in sugar beet molasses: beta-D-galactopyranosyl-(1- > 6)-beta-D-fructofuranosyl-(2 <-> 1)-alpha-D-glucopyranoside (named beta-planteose), alpha-D-galactopyranosyl-(1- > 1)-beta-D-fructofuranosyl-(2 <-> 1)-alpha-D-glucopyranoside (named1-planteose), alpha-D-glucopyranosyl-(1- > 6)-alpha-D-glucopyranosyl-(1 <-> 2)-beta-D-fructofuranoside (theanderose), and beta-D-glucopyranosyl-(1- > 3)-alpha-D-glucopyranosyl-(1 <-> 2)-beta-D-fructofuranoside (laminaribiofructose). 1-planteose and laminaribiofructose were isolated from natural sources for the first time.