Room-Temperature,Metal-Free,and One-Pot Preparation of 2H-Indazoles through a Mills Reaction and Cyclization Sequence

The Mills reaction and cyclization of readily available 2-aminobenzyl alcohols and nitrosobenzenes using thionyl bromide provided 2H-indazoles in up to 88 % yields. In the metal-free process, acetic acid played a crucial role for the both Mills reaction and cyclization. A brominated 2H-indazole could also be obtained through the one-pot sequence.     

Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Temporal analysis of products (TAP) study on oxygen storage properties over Pt−Rh/CeO2 catalyst

The oxygen storage capacity of CeO₂, Ce_0.9Pr_0.1O₂, Pt?Rh/CeO₂ and Pt?Rh/Ce_0.9Pr_0.1O₂ was investigated by conventional GC pulse method and transient pulse techniques. It is shown that incorporation of PrO_y into CeO₂ matrix strongly promotes oxygen storage capacity (OSC) measured using the transient pulse technique. The improvement of OSC at low temperature is observed in Pt?Rh loaded onto CeO₂ and Ce?Pr catalysts.     

The C-N Stretching Vibronic Bands of the MgNC ÃΠ-X?Σ Transition

We have generated MgNC in supersonic free jet expansions and measured the laser-induced fluorescence excitation spectra of the C-N stretching vibronic bands of the òΠ-X?²Σ⁺ transition. Rotational analysis yields the molecular constants of the vibronic levels, (1,0,0) and (1,0,1), in the Ã²Π state. We cannot find any anomalies in the constants of these vibronic levels, while they are predicted to lie above the barrier of the isomerization reaction pathway, MgNC↔MgCN, on the Ã²Π state. On the basis of the molecular constants obtained, we discuss the fine structures of both the ground X?²Σ⁺ and excited Ã²Π states.     

Physical properties and phase separation structure of Antheraea pernyi/Bombyx mori silk fibroin blend films

The physical structure and compatibility of solution-cast Antheraea pernyi/Bombyx mori silk fibroin blend films were stuided by differential scanning calorimetry (DSC), thermomechanical (TMA) and thermogravimetric (TGA) analysis, dynamic viscoelastic measurement, infrared spectroscopy, and x-ray diffractometry. The DSC curves of the blend films showed independent endotherms at 280 and 358°C, corresponding to the thermal decomposition of B. mori and A. pernyi silk fibroins with random coil conformation. The intensity was roughly proportionate to the amount of each component in the blend. The thermal behavior corresponding to the conformational transitions induced by heating on A. pernyi and B. mori silk fibroins overlapped in the temperature range 190–230°C. Thermal expansion and contraction properties, as well as weight retention behavior of the blend films were intermediate between the pure components, as shown by the TMA and TGA curves. The onset temperature of the storage modulus curve decreased markedly, approaching that of B. mori silk fibroin film when the amount of this component in the blend increased. The loss modulus curve of the blend films showed two peaks at ca. 190 and 210°C, the former corresponding to B. mori, and the latter to A. pernyi silk fibroin. Infrared spectra of the blends exhibited absorption bands characteristic of the pure components overlapping in the spectral region 2000–400 cm^?1. The x-ray diffraction peaks at 23 and 21.5°, attributed to the crystalline spacings of A. pernyi and B. mori fibroins, respectively, overlapped in the diffraction curves of the blends, while the peak at 11.4°, of A. pernyi, increased as the content of this fibroin in the blend increased. The degree of crystallinity, calculated from the x-ray diffraction curves, diminished as the amount of B. mori silk fibroin decreased. A low degree of compatibility exists between the two fibroins when they are cast from aqueous solution in the experimental conditions adopted in this work. © 1994 John Wiley & Sons, Inc.     

Bis(pentafluorophenyl) disulfide as a hydrogen abstractor and an electron acceptor from the resulting radical intermediate

The pentafluorobenzenethiyl radical is an efficient hydrogen abstractor from an activated methylene or methine group and bis(pentafluorophenyl) disulfide is an efficient electron acceptor from the resulting radical intermediate. Thus benzyl-OTBS ether was easily converted into the corresponding pinacol, and 2-phenyl-1,3-dioxanes are converted into the monobenzoates of diols.     

Heavy element nuclear chemistry at JAERI

The present status of heavy element nuclear chemistry research at JAERI (Japan Atomic Energy Research Institute) is reviewed. Production of the transactinide nuclei ²⁶¹Rf and ²⁶²Db via the reactions of ²⁴⁸Cm(¹⁸O,5n) and ²⁴⁸Cm(¹⁹F, 5n), respectively, at the JAERI tandem accelerator is reported. Study of the aqueous chemistry of Rf is being carried out with a newly developed rapid ion-exchange separation apparatus. Anion-exchange behavior of Rf in acidic solution is briefly discussed. Recent experimental results on decay studies of neutron-deficient actinide nuclei using the gas-jet coupled JAERI-ISOL are given. We also discuss characteristics of nuclear deformation properties at scission in symmetric and asymmetric fission of actinides. Prospects for studies in the near future are briefly considered.     

Holomorphic Maps of Compact Generalized Hopf Manifolds

We investigate holomorphic maps between compact generalized Hopf manifolds (i.e., locally conformal Kähler manifolds with parallel Lee form). We show that they preserve the canonical foliations. Moreover, we study compact complex submanifolds of g.H. manifolds and holomorphic submersions from compact g.H. manifolds.     

Strain analysis of Si by FEM and energy-filtering CBED.

Lattice strains around a platelet oxygen precipitate in Si wafer is studied by energy filtering convergent-beam electron diffraction (CBED) and calculations based on the finite element method (FEM). Local lattice strains are measured from CBD patterns obtained with a probe size less than 2 nm in a specimen thicker than 450 nm. Strains measured are compressive along a direction normal to a plate of the precipitation and tensile along a direction parallel to the plate. Two-dimensional stress fields near the precipitate are obtained with FEM computer analyses by fitting the measured strains. It appears that shear stresses are concentrated at the end of the precipitate edge and the maximum shear stress at an interface between the precipitate and the Si-matrix is 1.9 GPa. It is demonstrated that a combination of the energy filtering CBED and FEM is very useful for the study of local strains near interfaces in semiconductor devices, in particular for the study of stress fields that are too steep for application of the conventional CBED technique.