Room-Temperature,Metal-Free,and One-Pot Preparation of 2H-Indazoles through a Mills Reaction and Cyclization Sequence

The Mills reaction and cyclization of readily available 2-aminobenzyl alcohols and nitrosobenzenes using thionyl bromide provided 2H-indazoles in up to 88 % yields. In the metal-free process, acetic acid played a crucial role for the both Mills reaction and cyclization. A brominated 2H-indazole could also be obtained through the one-pot sequence.     

Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Temporal analysis of products (TAP) study on oxygen storage properties over Pt−Rh/CeO2 catalyst

The oxygen storage capacity of CeO₂, Ce_0.9Pr_0.1O₂, Pt?Rh/CeO₂ and Pt?Rh/Ce_0.9Pr_0.1O₂ was investigated by conventional GC pulse method and transient pulse techniques. It is shown that incorporation of PrO_y into CeO₂ matrix strongly promotes oxygen storage capacity (OSC) measured using the transient pulse technique. The improvement of OSC at low temperature is observed in Pt?Rh loaded onto CeO₂ and Ce?Pr catalysts.     

THE FIRST EXPERIMENT OF A THz GYROTRON WITH A PULSE MAGNET

A THz gyrotron with a pulse magnet has been designed, constructed and operated in FIR FU. It is developed as one of high frequency gyrotrons included in Gyrotron FU Series. The gyrotron has already achieved the first experimental result for high frequency operations whose radiation frequency exceeds 1 THz. In this paper, the design detail and the operation test results for sub-terahertz to terahertz range are described. The second harmonic operation is confirmed experimentally at the expected frequency of 1.005 THz due to TE_6,11 cavity mode at the magnetic field intensity of 19.0 T.     

The C-N Stretching Vibronic Bands of the MgNC ÃΠ-X?Σ Transition

We have generated MgNC in supersonic free jet expansions and measured the laser-induced fluorescence excitation spectra of the C-N stretching vibronic bands of the òΠ-X?²Σ⁺ transition. Rotational analysis yields the molecular constants of the vibronic levels, (1,0,0) and (1,0,1), in the Ã²Π state. We cannot find any anomalies in the constants of these vibronic levels, while they are predicted to lie above the barrier of the isomerization reaction pathway, MgNC↔MgCN, on the Ã²Π state. On the basis of the molecular constants obtained, we discuss the fine structures of both the ground X?²Σ⁺ and excited Ã²Π states.     

Bis(pentafluorophenyl) disulfide as a hydrogen abstractor and an electron acceptor from the resulting radical intermediate

The pentafluorobenzenethiyl radical is an efficient hydrogen abstractor from an activated methylene or methine group and bis(pentafluorophenyl) disulfide is an efficient electron acceptor from the resulting radical intermediate. Thus benzyl-OTBS ether was easily converted into the corresponding pinacol, and 2-phenyl-1,3-dioxanes are converted into the monobenzoates of diols.     

Melting behavior of poly(oxytetramethylene)-<Emphasis Type="Italic">alt</Emphasis>-(aromatic oligoamide) block copolymers

Using temperature-modulated differential scanning calorimetry, the melting behaviour of poly(oxytetramethylene)-alt-(aromatic oligoamide) (POTM-alt-AOA) has been studied in comparison with that of polyoxytetramethylene glycohols (POTMGs). The apparent melting temperature of the block copolymers is found to be less than that of the corresponding POTMGs by approximately 30°C. The relaxation time of melting of a POTM segment has been estimated and compared with that of POTMG. The relaxation time of POTM-alt-AOA is slightly shorter than that of POTMG when the molar mass of the POTM segment is 2900; however, it is longer when the molar mass is 1400.     

TG of polytetrahydrofuran/ isophoronediisocyanate reaction products

TG, swelling, and viscometric studies are presented for the residues, PTHF/IPDI polymer networks, and the extracts, the linear polymers and unreacted IPDI, after Soxhlet extraction of PTHF/IPDI reaction products. The products are obtained by reacting PTHF with 650, 1400, (2×650+1×2900), or 2900 of molecular mass with IPDI at various concentrations in bulk. The results on the swelling and the viscosity experiments suggest that the PTHF/IPDI reaction products have a usual expectable structure. All the TG curves are a double stage curve. The initial stage and the last stage seem to reflect decomposition of PTHF chains and vaporization of the remainder, IPDI, respectively. These are analyzed by a trial-and-error construction, supposing double event behavior. The values of ratio of mass loss associated with the initial event, W0₁, to the mass loss associated with the last event, W0₂, are smaller than the expectable those. This suggests that Event 2 involves vaporization of the decomposition products of PTHF moieties bonded to IPDI in addition to vaporization of IPDI. This revised version was published online in July 2006 with corrections to the Cover Date.     

Strain analysis of Si by FEM and energy-filtering CBED.

Lattice strains around a platelet oxygen precipitate in Si wafer is studied by energy filtering convergent-beam electron diffraction (CBED) and calculations based on the finite element method (FEM). Local lattice strains are measured from CBD patterns obtained with a probe size less than 2 nm in a specimen thicker than 450 nm. Strains measured are compressive along a direction normal to a plate of the precipitation and tensile along a direction parallel to the plate. Two-dimensional stress fields near the precipitate are obtained with FEM computer analyses by fitting the measured strains. It appears that shear stresses are concentrated at the end of the precipitate edge and the maximum shear stress at an interface between the precipitate and the Si-matrix is 1.9 GPa. It is demonstrated that a combination of the energy filtering CBED and FEM is very useful for the study of local strains near interfaces in semiconductor devices, in particular for the study of stress fields that are too steep for application of the conventional CBED technique.