Mössbauer and infrared spectroscopic studies of novel mixed valence states in cobaltous ferrocyanides and ferricyanides

Novel mixed valence states have been obtained by the treatment of cobaltous ferrocyanides (Co⁺²Fe^II) and ferricyanides (Co⁺²Fe^III) in an ozone flow. The CN stretching bands occur at 2085 cm^–1 for Co⁺²Fe^II and at 2160 cm^–1 for Co⁺²Fe^III. After the ozonization process of Co⁺²Fe^II, an intense band approximately at 2125 cm^–1 is detected. This intermediate band must correspond to a mixed valence state of the type: Fe^II–CN–Co²⁺–NC–Fe^III Mössbauer spectra recorded in situ during the ozonization of Co⁺²Fe^II show the presence of two components: a doublet with isomer shift and quadrupole splitting values close to the cobalti ferricyanide and a very broad line for the mixed valence state. From the Mössbauer and infrared spectra of the aged samples of the Co⁺²Fe^II after ozonization, a relaxation process to the initial state of the samples is observed but the mixed valence state is stable.     

Hydrous ferric oxide: evaluation of Cd-HFO surface complexation models combining Cd(K) EXAFS data,potentiometric titration results,and surface site structures identified from mineralogical knowledge

The surface properties of ferrihydrite were studied by combining wet chemical data, Cd(K) EXAFS data, and a surface structure and protonation model of the ferrihydrite surface. Acid-base titration experiments and Cd(II)-ferrihydrite sorption experiments were performed within 3<-log[H(+)]<10.5 and 0.5<[Cd(t)]<12 mM in 0.3 M NaClO(4) at 25 degrees C, where [Cd(t)] refers to total Cd concentration. Measurements at -5.5triple bond Fe-OH(-1/2),logk((int))=-8.29, assuming the existence of a unique intrinsic microscopic constant, logk((int)), and consequently the existence of a single significant type of acid-base reactive functional groups. The surface structure model indicates that these groups are terminal water groups. The Cd(II) data were modeled assuming the existence of a single reactive site. The model fits the data set at low Cd(II) concentration and up to 50% surface coverage. At high coverage more Cd(II) ions than predicted are adsorbed, which is indicative of the existence of a second type of site of lower affinity. This agrees with the surface structure and protonation model developed, which indicates comparable concentrations of high- and low-affinity sites. The model further shows that for each class of low- and high-affinity sites there exists a variety of corresponding Cd surface complex structure, depending on the model crystal faces on which the complexes develop. Generally, high-affinity surface structures have surface coordinations of 3 and 4, as compared to 1 and 2 for low-affinity surface structures.     

Search for color singlet technicolor particles in p&pmacr; collisions at radicals = 1.8 TeV

We search for color singlet technirho and technipion production in p&pmacr; collisions at sqrt[s] = 1.8 TeV recorded with the Collider Detector at Fermilab. These exotic technimesons are present in a model of walking technicolor. The signatures studied are lepton plus two jets plus E(T) and multijet final states. No excess of events is seen in either final state. We set an upper limit on the technirho production cross section and exclude a region in the technipion mass versus technirho mass plane.     

Diffractive dijets with a leading antiproton in &pmacr;p collisions at sqrt

We report results from a study of events with a leading antiproton of beam momentum fraction 0.9057 GeV. Using the dijet events, we evaluate the diffractive structure function of the antiproton and compare it with expectations based on results obtained in diffractive deep inelastic scattering experiments at the DESY ep collider HERA.     

Thermo-cleavable polymers: Materials with enhanced photochemical stability

Photochemical stability of three thermo-cleavable polymers was investigated as thin films under atmospheric conditions. A significant increase in lifetime was observed once the side-chain was cleaved emphasizing the detrimental effect of solubilizing groups on the photochemical stability of conjugated polymers. In addition to their ease of processing, thermo-cleavable polymers thus also offer a greater intrinsic stability under illumination.