Elastic instability of the nano-structured state as an intrinsic probe to study the early formation stages of sol–gel derived (Pb<Subscript>1-x</Subscript>Ca<Subscript>x</Subscript>)TiO<Subscript>3</Subscript> thin films

A novel method to investigate the early formation stages of polycrystalline (Pb_1-xCa_x)TiO₃ (PCT) perovskite films by means of traditional Brillouin and micro-Brillouin spectroscopy (BS, mBS) is described in the present work. The films were prepared by chemical solution deposition (CSD) onto oxidized (100)Si substrates and treated at temperatures between 350–650 °C by rapid thermal processing (RTP). The elastic instability observed by Brillouin spectroscopy at the nano-structured state of the PCT films was used here to determine their crystallization temperatures. Coexistence of different nanocrystalline phases (e.g., pyrochlore, perovskite) in the films could also be detected by this technique. The reliability of these results is demonstrated by complementary information obtained by X-ray diffraction (XRD) and scanning force microscopy (SFM). The effects of the annealing temperature and of the Ca²⁺ content on the crystallization process of these films are also discussed. PACS 78.35.+c; 77.84.-s; 61.82.Rx     

An improved injector bunching geometry for ATLAS

The bunching system of the ATLAS positive ion injector (PII) has been improved by relocating the harmonic buncher to a point significantly closer to the second stage sine-wave buncher and the injector LINAC. The longitudinal optics design has also been modified and now employs a virtual waist from the harmonic buncher feeding the second stage sine-wave buncher. This geometry improves the handling of space charge for high-current beams, significantly increases the capture fraction into the primary rf bucket and reduces the capture fraction of the unwanted parasitic rf bucket. Total capture and transport through the PII has been demonstrated as high as 80% of the injected dc beam while the population of the parasitic, unwanted rf bucket is typically less than 3% of the total transported beam. To remove this small residual parasitic component a new traveling-wave transmission-line chopper has been developed reducing both transverse and longitudinal emittance growth from the chopping process. This work was supported by the U.S. Department of Energy under contract W-31-109-ENG-38.     

The benzene ring as a dipolarophile: Reactions of monosubstituted benzenes with tetracyanoethylene oxide

Summary The reaction of tetracyanoethylene oxide on one hand and toluene, chlorobenzene, fluorobenzene, anisole, and nitrobenzene, on the other, has been studied. Toluene and the halogenobenzenes yield mixtures of monoadducts, anisole yieldp-methoxyphenylmalononitrile and its dimer and nitrobenzene does not react. These results are discussed with the help of a qualitative orbital model.¹H-NMR analysis of some monoadducts has been carried out.

---

Der Benzolring als Dipolarophil: Reaktionen monosubstituierter Benzole mit Tetracyanoethylenoxid

Zusammenfassung Es wurden die Reaktionen von Tetracyanoethylenoxid mit Toluol, Chlorbenzol, Fluorbenzol, Anisol und Nitrobenzol untersucht. Toluol und die Halogenbenzole ergaben Mischungen von Monoaddukten, Anisol ergabp-Methoxyphenylmalononitril und sein Dimer, Nitrobenzol zeigte keine Reaktion. Diese Resultate werden mit Hilfe eines qualitativen Orbitalmodells diskutiert. Die Analyse einiger Monoaddukte erfolgte mittels¹H-NMR-Analyse.

     

Thermodynamic excess quantities in the adsorption of sodium alkylsulfonates at the air-solution interface

Colloid and Polymer Science - Data on the surface tension of sodium alkylsulfonate solutions at different temperatures and surfactant concentrations are presented. By applying the thermodynamic...     

The C(2)1pi(u) state of Na2 molecule studied by polarization labelling spectroscopy method

The C1pi(u) <-- X1sigma(g)+ system of Na2 is studied by the polarization labelling spectroscopy technique. Accurate molecular constants are derived for the observed levels nu = 0-12, J = 12-100 in the C1pi(u) state.     

Electron beam crosslinking of non-lead PVC formulations

PVC samples with lead-free and lead-base stabilizer, containing TMPTMA (trimethylolpropane trimethacrylate) as a crosslinker and DOP (2-ethylhexyl phthalate) as a plasticizer, were electron beam treated at different doses (2–200 kGy) and characterized to evaluate crosslinking and other several properties, as a continuation of our previously reported paper, where these PVC formulations, typical for wire and cable applications, underwent gamma irradiation. The PVC was formulated with two different stabilizing systems: Ca/Zn and dibasic lead phthalate for comparison, to use them as jackets for a 22 wire gage (AWG). Small samples of the jacketed wires were irradiated in an industrial Dynamitron electron accelerator for the corresponding doses, along with two dosimetric systems: radiochromic thin film and alanine pellets dosimeters. The maximum dose applied was decided as the crosslinking increased, until the gel content was stable. The dose of 200 kGy was the condition for the highest crosslinking, so most of the wire was irradiated at such dose. Chemical and mechanical evaluations were carried out to the irradiated wire. The results show that 200 kGy was too high dose for the materials, since an important degradation is observed for the Ca/Zn systems. Unfortunately, such dose affects basically to CaZn formulations, which showed much poorer performance than classical lead-containing compositions. The results also indicate that gel content is not the best way of deciding the optimum condition for irradiation.     

Synthesis of fluorinated drimanes. Preparation of 9αF-drimenin

A stereoselective approach to the 9α-fluorinated analogue of the natural drimane sesquiterpene drimenin starting from β-ionone is described. β-Ionone is transformed into a bicyclic β-cetoester from which 9αF-drimenin is prepared through stereoselective electrophilic fluorination at the C-9 with N-fluorobenzenesulfonimide followed by Wittig methylenation, allylic bromination, bromine-hydroxyl exchange and γ-lactonization.     

Structural researches on the chelating behaviour of the biguanide ligand. The crystal structures of Co(C2H6N5)3 · 2H2O and Cu(C2H7N5)2CO3·4H20

Summary Crystals of the title compounds are both monoclinic, with unit cell dimensions:a = 9.293(5),b = 10.122(5),c = 16.737(7) Å. = 103.44(3)°,Z = 4, space groupP2₁/c for the cobalt derivative;a = 13.1ß5(7),b = 17.546(ß),c = 6.871(3) Å, = 107.01(4)°Z = 4, space groupP2₁/n for the copper derivative. The structures were solved from diffractometer data by the heavy-atom technique for the first compound and by direct methods for the second compound. Refinement by block diagonal least-squares gaveR = 5.9% for 3511 independent reflections andR = 8.8% for 2885 independent reflections for the cobalt and copper compound respectively. In both compounds the biguanide moiety behaves as a bidentate chelating ligand in a symmetrical tautomeric form, but it is deprotonated in the octahedral cobalt compound and neutral in the square planar copper compound.     

The molecular structure of 2-methylbenzotriazole (2MeBzTr) in connection with the x-ray structure of 2MeBzTr.HBF4.H2O

The fluoroborate of 1H-2-methylbenzotriazolium monohydrate crystallizes in the Pbca space group [Z = 8, a = 16.734(3), b = 19.153(9), c = 6.937(1) Å], The hydrogen bond network between the three molecules, 2MeBzTr, HBF₄ and H₂O, corresponds to a situation intermediate between the fluoroborate of a protonated benzotriazole (BF4^?.2MeBzTrH⁺) and a neutral benzotriazole hydrogen-bonded to fluoroboric acid (HBF₄,2MeBzTr). The behaviour of the title compound in solution is also intermediate between these two extreme situations. Thus, the present compound is one of the rare examples of a proton solvated only by very weak hydrogen bond acceptors.