Characterization of Metallo Bis(terpyridine) Diblock Polymers by Nonaqueous Capillary Zone Electrophoresis

A method of nonaqueous capillary zone electrophoresis (CZE) has been developed to characterize block (co)polymers of poly(ethylene oxide) and poly(styrene) containing metallo bis(terpyridine) complexes as bridging units. Specific CZE separation conditions had to be applied, with barium perchlorate dissolved in N-methylformamide (NMF) as background electrolyte and OV-1701-OH deactivated capillaries. For detection UV absorption was measured at a wavelength of 316 nm. Metallo diblock polymers with molecular weights up to 30,000 Da could be analyzed by the proposed nonaqueous CZE method. Experiments performed with polymeric compounds containing Fe, Ni or Ru as central metal ions showed that their electrophoretic mobilities were independent of the type of metal ion. Therefore, the data on the size of the polymeric compounds could be obtained using just one set of calibration standards. Polydispersities of the samples calculated from the experimental results were in correlation with the polydispersities of the polymers used in the synthesis of the metallo diblock polymers. Several polymeric samples contained metallo mono(terpyridine) complexes as impurities. These by-products could be separated from the main product. With symmetrical diblock polymers only one by-product was detected, while with an asymmetric diblock polymer two types of mono-complexes were found. The amount of the mono-complexes present as impurities was dependent on the type of central metal ion (Ni > Fe >> Ru).     

Mössbauer and infrared spectroscopic studies of novel mixed valence states in cobaltous ferrocyanides and ferricyanides

Novel mixed valence states have been obtained by the treatment of cobaltous ferrocyanides (Co⁺²Fe^II) and ferricyanides (Co⁺²Fe^III) in an ozone flow. The CN stretching bands occur at 2085 cm^–1 for Co⁺²Fe^II and at 2160 cm^–1 for Co⁺²Fe^III. After the ozonization process of Co⁺²Fe^II, an intense band approximately at 2125 cm^–1 is detected. This intermediate band must correspond to a mixed valence state of the type: Fe^II–CN–Co²⁺–NC–Fe^III Mössbauer spectra recorded in situ during the ozonization of Co⁺²Fe^II show the presence of two components: a doublet with isomer shift and quadrupole splitting values close to the cobalti ferricyanide and a very broad line for the mixed valence state. From the Mössbauer and infrared spectra of the aged samples of the Co⁺²Fe^II after ozonization, a relaxation process to the initial state of the samples is observed but the mixed valence state is stable.     

Topology evolution and gelation mechanism of agarose gel

Kinetics as well as the evolution of the agarose gel topology is discussed, and the agarose gelation mechanism is identified. Aqueous high melting (HM) agarose solution (0.5% w/v) is used as the model system. It is found that the gelation process can be clearly divided into three stages: induction stage, gelation stage, and pseudoequilibrium stage. The induction stage of the gelation mechanism is identified using an advanced rheological expansion system (ARES, Rheometric Scientific). When a quench rate as large as 30 deg C/min is applied, gelation seems to occur through a nucleation and growth mechanism with a well-defined induction time (time required for the formation of the critical nuclei which enable further growth). The relationship between the induction time and the driving force which is determined by the final setting temperature follows the 3D nucleation model. A schematic representation of the three stages of the gelation mechanism is given based on turbidity and rheological measurements. Aggregation of agarose chains is promoted in the polymer-rich phase and this effect is evident from the increasing mass/length ratio of the fiber bundles upon gelation. Continuously increasing pore size during gelation may be attributed to the coagulation of the local polymer-rich phase in order to achieve the global minimum of the free energy of the gelling system. The gel pore size determined using turbidity measurements has been verified by electrophoretic mobility measurements.     

Filamentous growth in activated sludge

Applied Biochemistry and Biotechnology - Bulking and foaming in activated sludge have been associated with filamentous overgrowth. FilamentousNocardia amarae and nonfilamentousPseudomonas...     

High-speed liquid and thin-layer chromatography of polychlorinated biphenyls.

High-speed liquid chromatography in the system silica gel/dry n-hexane and ultraviolet spectrometry have been used to study the composition of various types of commercially available mixtures of chlorinated biphenyls. Special attention has been paid to the analysis of highly chlorinated products. In addition to data previously published, retention times are recorded for 11 individual polychlorinated biphenyls. The results of high-speed liquid chromatography are compared with those obtained in several normal and reversed-phase thin-layer chromatographic systems.     

Liquid-liquid extraction of cadmium(II) from aqueous thiocyanate solutions with liquid anion-exchangers

An investigation has been made on the system liquid anion-exchanger-Cd(II)-NCS⁻. The influence of the acidity and thiocyanate concentration of the aqueous phase on the extraction has been studied. Using various methods of analysis, it has been shown that the complex anion present in the organic extracts is Cd(NCS) ₄ ²⁻ . Details are given concerning the removal of traces of Zn(II) from Cd(II)-containing solutions, and the quantitative separation of Cd(II) from Cr(III).