Cobalt promoted Ni/MgAl2O4 catalyst in lean methane catalytic oxidation

In the present research, magnesium aluminate spinel was prepared as catalyst support using a novel, facile, and efficient mechanochemical method. The Co-promoted catalysts with 20 wt.% of Ni were fabricated using an impregnation route and the samples were analyzed by the X-ray diffraction (XRD), N₂ adsorption/desorption (BET), temperature-programmed reduction and desorption (H₂-TPR and O₂-TPD), and field emission scanning electron microscopy (FESEM) tests. The results confirmed that all samples have a mesoporous structure with a high specific surface area and the presence of cobalt caused complete CH₄ oxidation at low temperatures, and no side reactions were observed. The results indicated that the 3%Co-20%Ni/MgAl₂O₄ catalyst was the optimal sample among the prepared catalysts, owing to the improvement of reduction features and oxygen mobility. The 50 and 90% of methane conversion was obtained at 530 and 600 °C, respectively. Also, the influence of calcination temperature, GHSV, and feed ratio was determined on the catalytic activity. The obtained outcomes revealed that the calcination temperature has a significant effect on the textural properties and catalytic efficiency. The sample calcined at 700 °C showed the weakest performance, which was related to the sintering of particles at high temperatures. The catalytic stability showed that the 3%Co-20%Ni/MgAl₂O₄ has acceptable stability during 600 min time of reaction.

Graphical abstract

     

Some necessary and sufficient conditions for Hypercyclicity Criterion

We give necessary and sufficient conditions for an operator on a separable Hilbert space to satisfy the hypercyclicity criterion. This paper is a part of the second author’s Doctoral thesis, written at Shiraz University under the direction of the first author.     

Headspace solvent microextraction of trihalomethane compounds into a single drop

Headspace solvent microextraction (HSME) into a single drop is developed for the determination of six trihalomethanes, CH2Cl2, CHCl3, C4H9Cl, CCl4, C2HCl3, and C2Cl4, in aqueous solution. A drop of benzyl alcohol containing bromoform, as an internal standard, is used for extraction. The analytes are extracted by suspending a 3-microL drop directly from the needle of a microsyringe. The needle passes through the septum of a vessel, and the needle tip appears above the surface of the solution. After the prescribed extraction time, the drop is drawn back into the syringe. The syringe is then removed, and its content is injected directly into a gas chromatography column for analysis. The main parameters affecting the HSME process, such as stirring speed, microdrop volume, sample solution temperature, microsyringe needle temperature, sample volume, solution pH, extracting solvent, and ionic strength of the solution, are studied. Also, the linear range and precision of the method are examined.     

Radiotracer studies on ion-selective membranes based on poly(vinyl chloride) matrices

Radiotracer studies with (45)Ca, (89)Sr and (133)Ba have provided evidence that the permeation of magnesium, strontium and barium ions through PVC membranes containing Orion 92-20-02 liquid ion-exchanger is inhibited by their low affinity for the liquid ion-exchanger sites. Experiments with (7)Be indicate a strong affinity of the membrane for beryllium ions with corresponding inhibition of permeation. When acid is present in the solution on one side of the membrane, preferential permeation by protons may lead to transport of ions against their concentration gradient in order to maintain the balance of charge.     

Hydrocarbon polymer analysis by external MALDI fourier transform and reflectron time of flight mass spectrometry

The traditional solvent-based matrix-assisted laser desorption ionization (MALDI) preparation method has been used to analyze nonpolar polymers of various molecular weights. High resolution silver cationized oligomers with masses of up to 12 KDa were measured using 9.4 tesla Fourier transform mass spectrometry (FTMS) with an external ionization source. It was observed that when time-of-flight mass spectrometry was used, the spectra of polyethylene polymers showed abundant low mass fragment ions. However, these fragments were absent from the FTMS spectra.     

High performance liquid chromatography method for determination of methyl-5-benzoyl-2-benzimidazole carbamate (mebendazole) and its main degradation product in pharmaceutical dosage forms

Methyl-5-benzoyl-2-benzimidazole carbamate (mebendazole) is a drug used as an anthelmintic. A high performance liquid chromatography method has been developed in this study to determine mebendazole and its degradation product in the pharmaceutical dosage forms (tablets and suspension). The expected major degradation product of mebendazole in the dosage forms has been prepared, and identified as 2-amino-5-benzoylbenzimidazole. The proposed HPLC assay was found to be selective, accurate (% recoveries were in the range of 99.9-100.9) for both, mebendazole and the degradation product, repeatable and reproducible (replicate measurements for short and long term measurements showed % RSD of 相似文献   

Liquid-liquid extraction of some lanthanide metal ions by polyoxyalkylene systems

Polyoxyalkylene systems, namely, polypropylene glycol (PPG-1025), polyethylene glycol (PEG-600) and polybutadieneoxide (PBDO-700) dissolved in either nitrobenzene or 1,2-dichloroethane have been tested as prospective extractants for some lanthanide metal ions (Eu(3+), Pr(3+) and Er(3+)) from their aqueous solutions in the presence of picrate anions. The metal ions were quantified before and after extraction using the inductively coupled plasma emission spectrophotometry technique. The percent extraction and the distribution coefficients have indicated that pH of the aqueous phase, picrate concentration and the organic solvent are the major parameters that affect the extraction efficiency of the metal ions. The optimum pH range was found to be 3.5-5.5 and the picrate concentration should be as high as possible; however, a picrate concentration of about 0.05 M proved to be adequate for a near quantitative extraction. In all cases, nitrobenzene enhanced a higher percent extraction compared to 1,2-dichloroethane. The efficiency of the polyoxyalkylene systems to extract certain lanthanide metal ions was in the order PBDO-700>PPG-1025>PEG-600 when nitrobenzene was the organic solvent and in the order PPG-1025>PBDO-700 approximately PEG-600 when 1,2-dichloroethane used as the solvent in the organic phase. The extractability of PPG-1025 towards the lanthanide metal ions was in the order Pr(3+)>Eu(3+)>Er(3+) irrespective of the organic solvent used. The stoichiometry of the extracted polyoxyalkylene ion-pairs with the lanthanide metal ions has been estimated. Each mole of metal ions is associated with three moles of picrate anions and 13 to 14 moles of propyleneoxide units in the case of PPG-1025, and about 9 to 10 moles of ethyleneoxide units in the case of PEG-600 and 10 moles of butadieneoxide units in the case of PBDO-700.     

Using a new solvation model for thermodynamic study on the interaction of nickel with human growth hormone

Thermodynamics of the interaction between Ni²⁺ and human growth hormone (hGH) were determined at 27 °C in Nail solution by isothermal titration calorimetry. A new method to predict protein penetration and the effect of metal ions on the stability of proteins is introduced. The new solvation model was used to reproduce the enthalpies of Ni²⁺-hGH interaction over the whole range of Ni²⁺ concentrations. The solvation parameters recovered from the new equation, attributed to the structural change of hGH and its biological activity.     

Vapor pressures and osmotic coefficients of the acetone solutions of three bis(tetraalkylammonium)tetrathiomolybdates at 298.15 K measured by head-space gas chromatography

The vapor pressures and osmotic coefficients of solutions of (R₄N)₂[MoS₄] (R = ethyl, n-propyl and n-butyl) in acetone have been measured by head space-gas chromatography (HS-GC). Experimental data for the osmotic coefficients have been expressed by three thermodynamic models including the ionic interaction model of Pitzer, the electrolyte non-random two liquid (e-NRTL) model and the non-random factor (NRF) model. The ability of the models to fit the osmotic coefficient was compared on the basis of the standard deviation of the fittings. The results show that the considered models provide reliable results, but the Pitzer's model gives better results than the NRTL and the NRF methods, especially in the dilute region.     

One‐pot synthesis of 1‐ and 5‐substituted 1H‐tetrazoles using 1,4‐dihydroxyanthraquinone–copper(II) supported on superparamagnetic Fe3O4@SiO2 magnetic porous nanospheres as a recyclable catalyst

An effective one‐pot, convenient process for the synthesis of 1‐ and 5‐substituted 1H‐tetrazoles from nitriles and amines is described using1,4‐dihydroxyanthraquinone–copper(II) supported on Fe₃O₄@SiO₂ magnetic porous nanospheres as a novel recyclable catalyst. The application of this catalyst allows the synthesis of a variety of tetrazoles in good to excellent yields. The preparation of the magnetic nanocatalyst with core–shell structure is presented by using nano‐Fe₃O₄ as the core, tetraethoxysilane as the silica source and poly(vinyl alcohol) as the surfactant, and then Fe₃O₄@SiO₂ was coated with 1,4‐dihydroxyanthraquinone–copper(II) nanoparticles. The new catalyst was characterized using Fourier transform infrared spectroscopy, X‐ray diffraction, transmission electron microscopy, field emission scanning electron microscopy, dynamic light scattering, thermogravimetric analysis, vibration sample magnetometry, X‐ray photoelectron spectroscopy, nitrogen adsorption–desorption isotherm analysis and inductively coupled plasma analysis. This new procedure offers several advantages such as short reaction times, excellent yields, operational simplicity, practicability and applicability to various substrates and absence of any tedious workup or purification. In addition, the excellent catalytic performance, thermal stability and separation of the catalyst make it a good heterogeneous system and a useful alternative to other heterogeneous catalysts. Also, the catalyst could be magnetically separated and reused six times without significant loss of catalytic activity. Copyright © 2016 John Wiley & Sons, Ltd.