Flow-injection determination of 3-hdroxybutyrate in serum with an immobilized 3-hydroxybutyrate dehydrogenase reactor and chemiluminescence detection

A flow-injection system for the determination of 3-hydroxybutyrate in serum is described. 3-Hydroxybutyrate dehydrogenase is immobilized on poly(vinyl alcohol) beads and incorporated in a flow-injection system. 1-Methoxy-5-methylphenazinium methylsulphate reacts with enzymatically generated NADH to give H₂O₂, which is detected chemiluminometrically with the reaction of luminol and hexacynoferrate(III). Serum is diluted and filtered through an ultrafiltration membrane. The system responds linearly to injected samples (80 μl) in the concentration range 0.5–300 μM; the detection limit is 0.1 μM. The within-day relative standard deviation (n = 90) for 58 μM 3-hydroxybutyrate in serum is 0.8%. The maximum throughout is 20 samples per hour. The immobilized enzyme is stable for at least 1 month.     

Crosslinked poly(N-isopropylacrylamide) gel for electrophoretic separation and recovery of substances

Crosslinked poly(N-isopropylacrylamide) gel was tested on the feasibility for a preparative electrophoretic matrix. Horse heart myoglobin and bovine hemoglobin were well separated on the gel matrix electrophoretically by molecular sieving effect of the gel network. Relative mobilities of those proteins in the gel were larger than those in a crosslinked polyacrylamide gel of the same polymer concentration. After the separation, the protein-containing portion of the gel underwent swelling at 4°C and deswelling at 37°C, alternatively. As a result of the deswelling, each protein was recovered in a discharged solution out of the gel at almost 100% yield.     

Structural and electrical properties of crystalline (1−x)Ta2O5−xTiO2 thin films fabricated by metalorganic decomposition

Polycrystalline (1−x)Ta₂O₅−xTiO₂ thin films were formed on Si by metalorganic decomposition (MOD) and annealed at various temperatures. As-deposited films were in the amorphous state and were completely transformed to crystalline after annealing above 600 °C. During crystallization, a thin interfacial SiO₂ layer was formed at the (1−x)Ta₂O₅−xTiO₂/Si interface. Thin films with 0.92Ta₂O₅–0.08TiO₂ composition exhibited superior insulating properties. The measured dielectric constant and dissipation factor at 1 MHz were 9 and 0.015, respectively, for films annealed at 900 °C. The interface trap density was 2.5×10¹¹ cm⁻² eV⁻¹, and flatband voltage was −0.38 V. A charge storage density of 22.8 fC/μm² was obtained at an applied electric field of 3 MV/cm. The leakage current density was lower than 4×10⁻⁹ A/cm² up to an applied electric field of 6 MV/cm.     

The preparation of nano‐scope chitosan‐oligomer copper complexes and their interaction with DNA

Water‐soluble low molecular weight chitosan of nanometer level and its copper complexes were prepared, and characterized by IR spectra, elemental analysis and gel permeation chromatography (GPC). The modes and mechanism of these copper complexes interaction with DNA were studied by a fluorescent probe method and electrophoresis analysis. It is suggested that there are electrostatic and intercalation modes of copper complexes interacting with DNA. At first, the cationic complex electrostaticly binds to the negatively charged phosphate backbone of DNA, and then a portion of the complex intercalates between the base pairs on the DNA duplex strand. Copyright © 2005 John Wiley & Sons, Ltd.     

Photografting of vinyl polymers onto ultrafine inorganic particles: Photopolymerization of vinyl monomers initiated by AZO groups introduced onto these surfaces

The photografting of polymers onto ultrafine inorganic particles, such as silica and titanium oxide, initiated by azo groups introduced onto these surfaces was investigated. The introduction of azo groups onto the particles was achieved by the reaction of 4,4′-azobis(4-cyanopentanoic acid) with surface isocyanate groups, which were introduced by the treatment with tolylene 2,4-diisocyanate. It was found that the photopolymerization of vinyl monomers, such as methyl methacrylate (MMA), styrene, and N-vinylcarbazole, is initiated by ultrafine particles having azo groups. The corresponding polymers were effectively grafted onto these surfaces through the propagation of the polymer from the surface radicals formed by the photodecomposition of the azo groups: e.g., the percentage of grafting of PMMA and polystyrene onto silica was reached to 112 and 176%, respectively. The percentage of grafting onto silica in the graft polymerization initiated by photodecomposition of surface azo groups was much larger than that initiated by thermal decomposition. Polymer-grafted ultrafine particles thus obtained gave a stable colloidal dispersion in good solvents for the grafted chain. © 1994 John Wiley & Sons, Inc.     

Thermolysis of reactive oligo(p-phenylene sulfide) containing disulfide bond

Oligo(phenylene sulfide) (OPS) containing one disulfide bond at the end of the chain, which was obtained by the oxidative polymerization of diphenyl disulfide, had a relatively low Td_10%(temperature for 10% weight loss) of 412 °C because of degradation of the disulfide bond. But this thermal cleavage of the disulfide bond promoted the curing reaction through thiophenoxy radical formation. OPS was allowed to react with diiodobenzene at 220 °C. The thermal stability of OPS was improved through the consumption of the disulfide bond and the coupling of the chain.     

Enhancement of electronic excitation energy transfer in the colloidal crystals of colloidal silica suspensions doped with fluorescent dyes

The efficiency of electronic excitation energy transfer from photo-excited rhodamine 110 (Rh110, energy donor) to rhodamine B (RhB, energy acceptor) in an exhaustively deionized colloidal silica suspension has been studied. This colloidal suspension shows Bragg reflection due to the formation of colloidal crystals and the Bragg-peak wavelength is controllable by the volume fraction of the silica spheres. When the Bragg-peak wavelength matches with the fluorescence band of Rh110, a depletion was observed in the Rh110 fluorescence spectrum. This means the fluorescence of Rh110 is partially trapped due to the Bragg reflection inside the crystal lattice. In the coexistence of RhB, the enhancement of RhB fluorescence intensity was observed. These facts clearly indicate the trapped photon energy of Rh110 is efficiently transferred to RhB within the colloidal crystals. The quantitative measurements showed that the enhancement of the transfer efficiency is 20% (or slightly more) in the present experimental conditions.     

Gamma-ray polymerization of phospholipids having diene or triene groups as liposomes

Small unilamellar liposomes were prepared in an aqueous medium by the sonication of phospholipids containing diene or triene groups in their hydrocarbon acyl chains. These liposomes were polymerized by gamma-ray irradiation. Conversion of polymerization was successively followed by UV spectrometry. Diene-type lipid liposomes were revealed for which a gamma-ray dose of 0.8 Mrad was required for complete polymerization and which were polymerized more easily than triene-type lipid liposomes. Triene-type lipids required 2.3 Mrad gamma ray to polymerize them completely. Contrary to UV-irradiation polymerization, there was no concentration dependence on the polymerization. Structure of the polymerized liposomes were confirmed by electron microscopy as small unilamellar liposomes. Study on the leakage of fluorescein from inner aqueous phase of the polymerized liposomes revealed that polymerized triene-type liposomes were relatively more stable than the polymerized diene-type liposomes.     

Correlation between Site ll-Specific Human Serum Albumin (HSA) Binding Affinity and Murine in vivo Photosensitizing Efficacy of Some Photofrin Components

Human serum albumin (HSA) is one of the key components in human blood that may influence drug distribution. As such, it is important to know the affinity of any drug for albumin. Previously, Photofrina mixture of monomeric, dimeric and oligomeric porphyrins, has been subjected to HSA binding studies. However, due to its complex nature, binding studies on Photofrin or other hematoporphyrin derivatives with HSA are inconclusive. In this report, the binding properties of some components (dimers and trimers) of Photofrin® and the relationship between murine photosensitizing efficacy and those binding properties were investigated. The interaction of these porphyrins with HSA was investigated by direct ultrafiltration and fluorescent titration techniques with fluorescent probes such as dansyl-L-proline (DP), which is known to interact selectively with site II on HSA. Porphyrins also were tested for antitumor activity in a mouse model following intravenous administration and exposure to laser light. Together, the results suggest that the photosensitizers that were preferentially bound to site II of HSA were most effective at controlling murine tumor regrowth     

A new strategy for construction of eight-membered carbocycles by Brook rearrangement mediated [6 + 2] annulation

[reaction: see text] A newly developed strategy for construction of eight-membered carbocycles via [6 + 2] annulation that involves the combination of beta-alkenoyl acylsilanes and a vinyllithium derivative is described. A unique feature of this annulative approach is that it enables in one operation and a stereoselective manner construction of eight-membered ring systems containing useful functionalities for further synthetic elaboration from readily available six- and two-carbon components.