Improved modeling and solution methods for the multi-resource routing problem

This paper presents modeling and solution method improvements for the Multi-Resource Routing Problem (MRRP) with flexible tasks. The MRRP with flexible tasks is used to model routing and scheduling problems for intermodal drayage operations in which two resources (tractors and trailers) perform tasks to transport loaded and empty equipment. Tasks may be either well defined, in which both the origin and the destination of a movement are given, or flexible, in which the origin or the destination is chosen by the model. This paper proposes methods to effectively manage the number of options considered for flexible tasks (either feasible origins for a known destination or feasible destinations for a known origin). This modeling change generates sufficient options to allow for low-cost solutions while maintaining reasonable computational effort. We also propose a new solution method that uses randomized route generation. Computational results from test cases show that these changes improve the quality of solutions by at least 5% in the test cases as compared to methods from previous studies.     

n元等比级数

定义了n元等比数列、n元等比级数,给出了它们的通项公式及前n项和.并解决了多元等比级数的敛散性问题,求出了多元等比级数的和.指出了多元等比数列及多元等比级数在特殊情况下与一元等比数列及一元等比级数的一致性.     

PPC/SBR并用弹性体的配方选择

利用正交法对丁苯橡胶（SBR）／聚丙撑碳酸酯（PPC）共混弹性体进行配方设计，得到了一个具有良好综合性能的配方。并通过方差分析得出PPC含量和马来酸酐（MA）用量是影响弹性体拉伸性能的最显著因素。     

THE SEPARATION,PURIFICATION AND DECOLORIZATION OF NEW ANTIBIOTICS-MILUPEINAN USING ADSORPTION RESIN

1. INTRODUCTION Fig.1 The Chemical Structure of Milupeinan As a new type of antibiotics Milupeinan, not only possesses antibacterial activities against a wide range of Gram-positive and Gram-negative bacteria, but also higgh stability under th…     

对称三唑Schif碱和氯化铜配合物的研究

本文介绍水杨配合与４－氨基－３，５－二乙基－１，２，４－三唑缩合而成对称三唑Ｓｃｈｉｆ碱（ＳＡＥＴＺ）与氯化铜（ＣｕＣｌ２）形成一种新的配合物Ｃｕ（ＳＡＥＴＺ）２（ＳＡＥＴＺ＝４－（邻羟苯基亚甲基）－亚胺－３，５－二乙基－１，２，４－三唑）。配合物的晶体结构表明，分子中两个偶氮甲碱的Ｎ原子及两个酚氧原子与中心Ｃｕ原子形成规则的平面配位结构。晶体属单斜晶系，空间群Ｐ２１／ｎ，ａ＝８．６８８（２），ｂ＝９．３１４（１），ｃ＝１６．５１５（４），β＝９４．３４（２）。，Ｖ＝１３３２．５（７）３，Ｚ＝２。     

Influence of ultrasonic field on microcystins produced by bloom-forming algae

Under the background of algae removal and growth inhibition by ultrasonic irradiation, the effects of ultrasonic irradiation on removal of Microcystis, the concentration variation of microcystins (MC) produced by Microcystis in Microcystis suspension, and sonochemical degradation of microcystins in water, were studied in the paper. The results showed that ultrasonic irradiation could efficiently inhibit the growth of Microcystis, and ultrasonic irradiation shorter than 5 min would not introduce the increase of microcystins dissolved in Microcystis suspension simultaneity. Also, microcystins dissolved in Microcystis suspension would not increase as ultrasonic power increasing. Further research showed that microcystins were effectively degraded in ultrasonic fields. After 20 min ultrasonic irradiation at 150 kHz and 30 W, the removal rate of microcystins reached 70%.     

辐照对聚己内酯结构和性能的影响

研究了γ 辐照对不同分子量的聚己内酯 (PCL)的力学性能、热性能、结晶行为的影响 ,在此基础上 ,研究了辐射交联后的PCL的形状记忆行为 .研究结果表明 ,PCL的分子量越大 ,辐射交联所需的凝胶化剂量越低 .溶胶分数S +S1 2 与 1 D的关系很好地符合Charlesby Pinner关系式 ,说明PCL的辐射交联属于无规交联 .剂量对PCL的力学性能影响显著 ,剂量越大 ,抗张强度和断裂伸长率下降越多 ,但分子量较高的PCL的抗张强度受剂量的影响较小 .DMA分析表明 ,聚己内酯辐照交联后的弹性模量和耐热性能显著提高 .交联度较高的PCL表现出高弹态 ,可以拉伸 ,并具有较好的形状记忆行为 .DSC分析表明 ,辐射交联使PCL的结晶度有所增加 ,但也使结晶熔点有所降低     

电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

几种卟啉在化学还原沉积银膜上的表面增强拉曼光谱特征

应用 Ｊｏｂｉｎ－Ｙｖｏｎ Ｕ—１０００型拉曼光谱仪和ＬＡＢＲＡＭＩ型拉曼光谱系统研究了 ３种卟啉ＴＯＨＰＰ、ＴａｍＰＰ和ＴＳＰＰ在化学还原沉积法制备的银膜上的ＲＳ和ＳＥＲＳ光谱特征。结果表明：化学还原法制备的银膜可以作为这几种卟啉的拉曼增强活性载体。这３种卟啉在获谱的过程中都形成二聚态化合物和发生银离子搀和作用，较长的放置和测谱时间有利于银离子的搀和。     

高分子-AlCuCl4膜及其气体透过行为探讨

把对一氧化碳具有选择吸附功能的液体吸附剂(AlCuCl_4-甲苯溶液和AlCuCl_4-Pst-甲苯溶液)引入到高分子(EC、Pst、ABS、CA)膜材料中,制成固体膜,考察了膜的气体透过性能,同时初步得出结果认为,膜中的AlCuCl_4以电荷转移配合物形式与高分子配位结合.