Multicyclic polyethers derived from 1,1,1‐tris(4‐hydroxyphenyl)ethane and 2,6‐dihalopyridines

Poly(pyridine ether)s were prepared in two ways: the polycondensation of silylated 1,1,1‐tris(4‐hydroxyphenyl)ethane (THPE) with 2,6‐difluoropyridine (method A) and the polycondensation of free THPE with 2,6‐dichloropyridine (method B). With method A, the THPE/difluoropyridine feed ratio was varied from 1.0:1.0 to 1.0:1.6. Cycles, bicycles, and multicycles were the main reaction products, and crosslinking was never observed. When ideal stoichiometry was used exclusively, multicycles free of functional groups were obtained. These multicycles were detectable in matrix‐assisted laser desorption/ionization time‐of‐flight (MALDI‐TOF) mass spectra up to B₃₈C₇₆ with a mass of approximately 32,000 Da. With method B, the reaction conditions were varied at a fixed feed ratio to achieve an optimum for the preparation of multicyclic polyethers, but because of the lower reactivity of 2,6‐dichloropyridine, a quantitative conversion was not achieved. The reaction products were characterized with MALDI‐TOF mass spectrometry, viscosity measurements, and size exclusion chromatography. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5725–5735, 2004     

Potential for micromachined actuation of ultra-wide continuously tunable optoelectronic devices

Tailored scaling represents a principle of success that, both in nature and in technology, allows the effectiveness of physical effects to be enhanced. Mutation and selection in nature are imitated in technology, e.g. by model calculation and design. Proper scaling of dimensions in natural photonic crystals and our fabricated artificial 1D photonic crystals (DBRs, distributed Bragg reflectors) enable efficient diffractive interaction in a specific spectral range. For our optical microsystems we illustrate that tailored miniaturization may also increase the mechanical stability and the effectiveness of spectral tuning by thermal and electrostatic actuation, since the relative significance of the fundamental physical forces involved considerably changes with scaling. These basic physical principles are rigorously applied in micromachined 1.55-μm vertical-resonator-based devices. We modeled, implemented and characterized 1.55-μm micromachined optical filters and vertical-cavity surface-emitting laser devices capable of wide, monotonic and kink-free tuning by a single control parameter. Tuning is achieved by mechanical actuation of one or several air-gaps that are part of the vertical resonator including two ultra-highly reflective DBR mirrors of strong refractive index contrast: (i) Δn=2.17 for InP/air-gap DBRs (3.5 periods) using GaInAs sacrificial layers and (ii) Δn=0.5 for Si₃N₄/SiO₂ DBRs (12 periods) with a polymer sacrificial layer to implement the air-cavity. In semiconductor multiple air-gap filters, a continuous tuning of >8% of the absolute wavelength is obtained. Varying the reverse voltage (U=0–5 V) between the membranes (electrostatic actuation), a tuning range of >110 nm was obtained for a large number of devices. The correlation of the wavelength and the applied voltage is accurately reproducible without any hysteresis. In two filters, tuning of 127 and 130 nm was observed for about ΔU=7 V. The extremely wide tuning range and the very small voltage required are record values to the best of our knowledge. For thermally actuated dielectric filters based on polymer sacrificial layers, Δλ/ΔU=-7 nm/V is found. Received: 10 May 2002 / Published online: 8 August 2002     

Scroll codes

We study algebraic geometric codes obtained from rational normal scrolls. We determine the complete weight hierarchy and spectrum of these codes.      

Farkas-type results for fractional programming problems

Considering a constrained fractional programming problem, within the present paper we present some necessary and sufficient conditions, which ensure that the optimal objective value of the considered problem is greater than or equal to a given real constant. The desired results are obtained using the Fenchel–Lagrange duality approach applied to an optimization problem with convex or difference of convex (DC) objective functions and finitely many convex constraints. These are obtained from the initial fractional programming problem using an idea due to Dinkelbach. We also show that our general results encompass as special cases some recently obtained Farkas-type results.     

Cyclic and telechelic ladder polymers derived from tetrahydroxytetramethylspirobisindane and 1,4‐dicyanotetrafluorobenzene

5,5′,6,6′‐Tetrahydroxy‐3,3,3′,3′‐tetramethylspirobisindane was polycondensed with 1,4‐dicyanotetrafluorobenzene in four different solvents at 70 °C. In dimethylformamide, N‐methylpyrrolidone, and sulfolane exclusively, cyclic polymers were detectable by matrix‐assisted laser desorption/ionization time‐of‐flight (MALDI‐TOF) mass spectrometry up to masses around 13,000 Da. In dimethyl sulfoxide, linear byproducts were also found. Higher temperatures caused degradation reactions catalyzed by potassium carbonate. Polycondensations performed with the addition of 4‐tert‐butyl catechol or 2,2′‐dihydroxy binaphthyl yielded linear telechelic oligomers. Equimolar mixtures of linear and cyclic ladder polymers were examined by MALDI‐TOF mass spectra to determine how the end groups and the cyclic structure influenced the signal‐to‐noise ratio. The results suggested a preferential detection of the linear chains. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5344–5352, 2006     

A catalyst-free one-step synthesis of N-pyrimidinyl amidines from endocyclic enamines and 4-azidopyrimidines

1. Download high-res image (103KB)
2. Download full-size image