Characteristics investigation on heat transfer growth of sonochemically synthesized ZnO-DW based nanofluids inside square heat exchanger

Journal of Thermal Analysis and Calorimetry - In recent decades, the growth of heat transfer using nanomaterials in the conventional base fluid has caught the attention of researchers...     

The effect of rapid rotation on a vertical bridgman furnace at large Rayleigh number

In quasi-steady operation, convection currents in a Bridgmandevice, used for producing a semi-conductor crystal, createinhomogeneities that may make the crystal unusable. It has oftenbeen suggested that additional forces due to rotation or magnetismmight be efficacious in reducing the segregation of the elementsof the alloy. It has been found that, over a wide range of rotationrates, there is no improvement in performance due to rotationabout the vertical axis. However, numerical results that havebeen obtained previously (Lee & Pearlstein, J. Crys. Growth240, 2002) indicate that, when effects of centrifugal buoyancyare introduced, a substantial reduction in segregation is achieved.In the work reported here, by contrast, in which we extend previouslarge-Rayleigh-number asymptotic analysis to include centrifugalbuoyancy, we find no improvement in radial segregation, butrather increasing segregation with increasing rotation rate.     

Stoichiometric and catalytic oxygen activation by trimesityliridium(III)

Trimesityliridium(III) (mesityl = 2,4,6-trimethylphenyl) reacts with O(2) to form oxotrimesityliridium(V), (mes)(3)Ir=O, in a reaction that is cleanly second order in iridium. In contrast to initial reports by Wilkinson, there is no evidence for substantial accumulation of an intermediate in this reaction. The oxo complex (mes)(3)Ir=O oxidizes triphenylphosphine to triphenylphosphine oxide in a second-order reaction with DeltaH++ = 10.04 +/- 0.16 kcal/mol and DeltaS++ = -21.6 +/- 0.5 cal/(mol.K) in 1,2-dichloroethane. Triphenylarsine is also oxidized, though over an order of magnitude more slowly. Ir(mes)(3) binds PPh(3) reversibly (K(assoc) = 84 +/- 3 M(-1) in toluene at 20 degrees C) to form an unsymmetrical, sawhorse-shaped four-coordinate complex, whose temperature-dependent NMR spectra reveal a variety of dynamic processes. Oxygen atom transfer from (mes)(3)Ir=O and dioxygen activation by (mes)(3)Ir can be combined to allow catalytic aerobic oxidations of triphenylphosphine at room temperature and atmospheric pressure with overall activity (approximately 60 turnovers/h) comparable to the fastest reported catalysts. A kinetic model that uses the rates measured for dioxygen activation, atom transfer, and phosphine binding describes the observed catalytic behavior well. Oxotrimesityliridium does not react with sulfides, sulfoxides, alcohols, or alkenes, apparently for kinetic reasons.     

Palladium-doped polyimides: An X-ray photoelectron study

Five polyimide films prepared from 3,3′,4,4′-benzophenone tetracarboxylic acid'dianhydride (BTDA) and diamines, 4,4′-oxydianiline (ODA), 3,3′-diaminobenzophenone (DABP), or 3,3′-diaminodiphenylcarbinol (DADPC) and doped with Li₂PdCl₄ (LTP) or Pd[(CH₃)₂S]₂Cl₂ (PDS) were selected for a detailed x-ray photoelectron spectroscopic (XPS) study to determine the oxidation state of palladium and the relative distribution of this and other elements in these films, especially as they relate to electrical resistivity. XPS shows that Pd in the films is present as a mixture of zero and +2 valence states. Films that contain lithium as part of the dopant all show that metal is present as Li⁺ and Li₂O, a fact that may have a bearing on film electrical properties. An Auger electron spectroscopic (AES) or XPS profiling was performed on two of the electrically conductive films. A film doped with PDS reveals a majority of palladium at the surface as Pd(0) and much smaller amounts in film bulk as a mixture of Pd(0) and Pd(II). Film behavior is similar to a metal-vapor deposited film. An LTP doped film, by contrast, exhibits a homogeneous composition with a mixture of Pd(0) and Pd(II). These studies support others that use chemical etching on the film surfaces. Scanning electron microscopy (SEM) has been used to provide surface evaluations.     

Quantification of hydroxycarbonyls from OH-isoprene reactions

Hydroxycarbonyls arising from OH-initiated reactions of isoprene have been quantified by the technique of a flow reactor coupled to proton-transfer reaction mass spectrometry (PTR-MS) detection. The yields of C5- and C4-hydroxycarbonyls are (19.3 +/- 6.1)% and (3.3 +/- 1.6)%, respectively, measured at a flow tube pressure of about 100 Torr and at a temperature of 298 +/- 2 K. A yield of (8.4 +/- 2.4)% is obtained for the unsaturated carbonyl C5H8O, confirming that internal OH addition represents the minor channel in the initial OH-isoprene reaction. The results show that those carbonyl compounds account for the most previously unquantified carbon, enabling the isoprene carbon closure. The study also reveals novel aspects of the delta-hydroxyalkoxy radical degradation mechanism, which is essential for modeling tropospheric O3 formation. In addition, this work demonstrates the application of PTR-MS for quantification of products of hydrocarbon reactions, which should have profound impacts on elucidation of the chemistry of atmospheric anthropogenic and biogenic hydrocarbons.     

Über einige Derivate des Isochinolins

Ohne Zusammenfassung     

Über 2-Benzoylfluoren und Über Reten

Ohne ZusammenfassungIch habe in meiner frÜheren Abhandlung Über das Benzoylfluoren die Zählung irrtÜmlicherweise mit dem der Methylengruppe benachbarten Kohlenstoffatom begonnen. Der Irrtum kam dadurch zustande, da\ Beilstein die von Gräbe aus Diphensäure dargestellte, nach der neuen Nomenklatur als Fluorenoncarbonsäure (4) zu bezeichnende Säure mit der Ziffer (5) versieht.Mit dem Studium dieser Frage bin ich gegenwärtig beschäftigt, weshalb ich das Ersuchen stelle, mir fÜr die nächste Zeit das bezÜgliche Arbeitsgebiet zu Überlassen.     

Controlled hydrothermal growth of ZnO nanostructures by sequestering the Zn metal ions with the chelating agent EDTA

In the present work, a controlled growth of ZnO nanostructures by manipulating Zn metal ion concentration by the chelating action of ethylene diaminetetra acetic acid in hydrothermal method is studied. EDTA produces metal–chelate complex by the formation of bidentate ligand with Zn²⁺ in the solution and diminishes the reactivity of Zn metal cations. Concentration of EDTA in the mother solution was varied in different ranges like 3, 5 and 10 mM while retaining the zinc metal salt and the NaOH concentration the same. Three different morphologies of wurtzite structured ZnO nanostructures such as nanorods-bunch, separate/discrete uniformly sized hexagonal nanorods and tapered flower petals like shapes are achieved by 3, 5 and 10 mM strengths of EDTA, respectively. The medium concentration 5 mM of EDTA is found to have moderate control over producing ZnO nanostructures of uniform diameter and a high aspect (length to diameter) ratio. An array of vertically aligned free standing ZnO nanorods with uniform spacing is successfully achieved by the addition of 5 mM of EDTA in the mother solution and the same is studied for its fluorescence property at an excitation of 325 nm and it has exhibited a characteristic UV emission of ZnO around 383 nm.     

The proton-reduced L X-ray spectrum of argon

The argon L X-ray spectrum produced by 100 keV protons is presented. A new line, not observed in the electron- produced spectrum, appears at 262 eV is interpreted as a 3d→2p transition. Since the 3d level is normally empty in argon, the data provide the first direct evidence from X-rays following proton bombardment of excitation of electrons to bound states.