Quantification of Total Phenols and Antioxidants in Coffee Samples of Different Origins and Evaluation of the Effect of Degree of Roasting on Their Levels

Phenolic and antioxidant compounds have received considerable attention due to their beneficial effects on human health. The aim of this study is to determine the content of total phenols and antioxidants in fifty-two coffee samples of different origins, purchased from the Jordanian local market, and investigate the effect of the degree of roasting on the levels of these compounds. The coffee samples were extracted using the hot water extraction method, while Folin–Ciocalteu (FC) and 1,1-diphenyl-2-picrylhydrazyl (DPPH) assay methods were used to analyze these compounds. The results showed that the highest content of total phenol (16.55 mg/g equivalent to GAE) was found in the medium roasted coffee, and the highest content of antioxidants (1.07 mg/g equivalent to TEAC) content was found in the green coffee. Only light and medium roasted coffee showed a significant correlation (p < 0.05, R² > 0.95) between the average of total phenolic and antioxidant content. A negative correlation between the antioxidant content and the degree of roasting (p < 0.05, R² > 0.95) were shown, while it did not correlate with phenolic contents. Previously, a positive correlation between antioxidant and chlorogenic acids content was observed, with no correlation between the origin of coffee samples nor heavy metal content, which was previously determined for the same coffee samples. These findings suggest that the antioxidant content for coffee extracts is largely determined by its chlorogenic acid content, rather than the coffee origin or total phenolic and heavy metals content.     

A study on optical absorption and constants of doped poly(ethylene oxide)

Thin films of polymer electrolyte based on poly(ethylene oxide) doped with sodium iodide (NaI) were prepared using the solution cast method. The films obtained have average thickness of 70 μm and different NaI concentrations. Absorption and reflectance spectra of UV-radiation were studied in the wavelength range 300-800 nm. The optical results were analyzed in terms of absorption formula for non-crystalline materials.The optical energy gap and the basic optical constants, refractive index, and dielectric constants of the prepared films have been investigated and showed a clear dependence on the NaI concentration. The interpreted absorption mechanism is a direct electron transition.The observed optical energy gap for neat poly(ethylene oxide) is about 2.6 eV, and decreases to a value 2.36 eV for the film of 15 wt% NaI content. It was found that the calculated refractive index and the dielectric constants of the polymer electrolyte thin films increase with NaI content. Models were used to describe the dependences of the dielectric constant on the NaI concentration, and the refractive index on the incident photon energy.     

Identification of Single-Particle Configurations at Very High Spin in Some Rare-Earth Nuclei

The nuclear behaviour at high angular momenta is studied by γ-rays emitted in (HI, Xn) reaction. The study of very-high spin states in ¹⁵³Ho via discrete-line γ-ray spectroscopy and a comparison between the partial decay schemes of ¹⁵³Ho and the neighbouring ¹⁵²Dy and ¹⁵⁴Er nuclei are discussed in the context of the high spin structure. Second, we present comments on some phenomena observed at high spin states in ¹⁵³Ho and ¹⁵²Dy nuclei.     

Water-dispersible sugar-coated iron oxide nanoparticles. An evaluation of their relaxometric and magnetic hyperthermia properties

Synthesis of functionalized magnetic nanoparticles (NPs) for biomedical applications represents a current challenge. In this paper we present the synthesis and characterization of water-dispersible sugar-coated iron oxide NPs specifically designed as magnetic fluid hyperthermia heat mediators and negative contrast agents for magnetic resonance imaging. In particular, the influence of the inorganic core size was investigated. To this end, iron oxide NPs with average size in the range of 4-35 nm were prepared by thermal decomposition of molecular precursors and then coated with organic ligands bearing a phosphonate group on one side and rhamnose, mannose, or ribose moieties on the other side. In this way a strong anchorage of the organic ligand on the inorganic surface was simply realized by ligand exchange, due to covalent bonding between the Fe(3+) atom and the phosphonate group. These synthesized nanoobjects can be fully dispersed in water forming colloids that are stable over very long periods. Mannose, ribose, and rhamnose were chosen to test the versatility of the method and also because these carbohydrates, in particular rhamnose, which is a substrate of skin lectin, confer targeting properties to the nanosystems. The magnetic, hyperthermal, and relaxometric properties of all the synthesized samples were investigated. Iron oxide NPs of ca. 16-18 nm were found to represent an efficient bifunctional targeting system for theranostic applications, as they have very good transverse relaxivity (three times larger than the best currently available commercial products) and large heat release upon application of radio frequency (RF) electromagnetic radiation with amplitude and frequency close to the human tolerance limit. The results have been rationalized on the basis of the magnetic properties of the investigated samples.     

Determination of Fenofibric Acid in Human Plasma by LC–MS/MS and LC–UV

A sensitive, high-throughput and economic liquid chromatographic method for determination of fenofibric acid in human plasma was developed and validated by ultraviolet detection and tandem mass spectrometry, then applied in pharmacokinetic study to investigate Lipanthyl™ 200 mg MC bioavailability under food and fasting conditions. Fenofibric acid with 2-chloro fenofibric acid-d6 (internal standard) was extracted from 100 µL of human plasma by acetonitrile in a single extraction step. 25 and 2 µL from supernatant were injected onto ACE column, 50 mm, 5 micron with 4.6 mm inner diameter for LC–UV and 2.1 mm for LC–MS/MS, and both systems were eluted isocratically by water:methanol:formic acid (35:65:0.1, v/v/v), with a constant flow rate of 1 mL min⁻¹. The established calibration curve was linear between 0.05–20 µg mL⁻¹, and the within- and between-day precisions were all below 13 % in both LC–MS/MS and LC–UV systems during validation, and accuracies ranged between 91 and 112 %. Twenty-eight healthy adult subjects participated in this clinical study, and the pharmacokinetic parameters including coefficient of variation were calculated and discussed. A dramatic decrease in C _max and AUC0-72 (3.63- and 1.85-fold, respectively) were observed for Lipanthyl™ MC under fasting conditions with more variable inter subject measurements comparing to the fed state.

     

Quantification of Caffeine and Chlorogenic Acid in Green and Roasted Coffee Samples Using HPLC-DAD and Evaluation of the Effect of Degree of Roasting on Their Levels

Chlorogenic acid and caffeine are among the important components in coffee beans, determining the taste and aroma. In addition, phenols and antioxidants content possess vital health values. The main aim of this study is to determine the levels of caffeine and chlorogenic acid in several coffee samples of different origins and degrees of roasting. The coffee samples were extracted using hot water. The levels of caffeine and chlorogenic acid were quantified using high-performance liquid chromatography (HPLC) equipped with a diode array detector, a reverse phase system, and an ODS column (C18). Total phenol and antioxidant contents were previously determined for the same samples. The results showed that the highest content of caffeine was found in the medium roasted coffee (203.63 mg/L), and the highest content of chlorogenic acid content was found in the green coffee (543.23 mg/L). The results demonstrated a negative correlation between the chlorogenic acid levels with the degree of roasting, while it showed a positive correlation between the caffeine levels with the degree of roasting till a certain point where the levels dropped in the dark roasted coffee. The origin of coffee samples did not show any effect on any of the measured variables. Antioxidant effects of coffee samples were largely determined by chlorogenic acid content.     

Effect of annealing on the electrical properties and refractive index of HgI2 single crystals

The effect of annealing on the electrical properties and the refractive index of red mercuric iodide (HgI₂) single crystals is investigated. The ac-impedance and phase angle were measured in the frequency range from 100 Hz to 10 kHz at different annealing temperatures. The ac-conductivity, dielectric constants, loss tangent and the refractive index as a function of frequency are determined. The results are discussed in terms of structural changes taking place as a result of the heat treatment of the HgI₂ single crystals.     

Molecular interaction of N-formylmorpholine with alkanols,a spectroscopic study

The interactions of N-formylmorpholine (NFM) with different alkanols were monitored using proton nuclear magnetic resonance and IR spectroscopy. It was found that the NFM interaction with alkanols decreases with increasing length and branching of the alkanols. A good correlation was obtained between the proton chemical shift and the volume of mixing of alkanols with NFM.     

Adsorption of chromium ions from aqueous solution by using activated carbo-aluminosilicate material from oil shale

A novel activated carbo-aluminosilicate material was prepared from oil shale by chemical activation. The chemicals used in the activation process were 95 wt% sulfuric and 5 wt% nitric acids. The produced material combines the sorption properties and the mechanical strength of both activated carbon and zeolite. An X-ray diffraction analysis shows the formation of zeolite Y, Na-X, and A-types, sodalite, sodium silicate, mullite, and cancrinite. FT-IR spectrum shows the presence of carboxylic, phenolic, and lactonic groups on the surface of this material. The zero point of charge estimated at different mass to solution ratio ranged from 7.9 to 8.3. Chromium removal by this material showed sorption capacity of 92 mg/g.