Mechanical, thermal, and moisture absorption properties of nano-clay reinforced nano-cellulose biocomposites

In this research, fully environment-friendly, sustainable and biodegradable ‘green’ composites were fabricated. A novel material comprised of microfibrillated cellulose and laponite clay with different inorganic/organic ratios (m/m) was prepared. The composites were characterized by tensile, bending and water absorption tests as well as dynamic mechanical analysis. The morphologies of these nanocomposites were evaluated through scanning electron microscopy. Results showed considerable improvement of mechanical properties; specifically in elastic modulus, tensile strength and flexural modulus with the addition of nanoclay up to 7.5 wt% nano-clay. The modulus of elasticity increased significantly by about 26 % at 5 wt% nanocaly. The flexural modulus increased by about 90 % at 7.5 wt% nanoclay. However, with an increased load of clay in the nanocomposite, the mechanical properties decreased due to the agglomeration of excessive nanoclay. The storage modulus was significantly increased at high temperature with increasing the load of nanoclay.     

Radioactivity of sand, groundwater and wild plants in northeast Sinai, Egypt

The radioactivity levels are poorly studied in non-coastal arid regions. For this reason, 38 locations covering an area of about 350 km(2) in northeast Sinai, Egypt, were investigated by γ-ray spectroscopy. Moderately significant correlations among (238)U, (234)Th, and (226)Ra isotopes and low significant correlations between the concentrations of (238)U-series and (232)Th in sand were obtained. No evidence of correlation was found between the concentrations of radioisotopes and pH, grain size, total organic matter content, bicarbonate or calcium carbonate concentrations of the sand samples. The mean values of soil-to-plant transfer factor were 0.15, 0.18, 1.52 and 0.74 for (226)Ra, (232)Th, (40)K, and (137)Cs, respectively. The range of concentrations of (226)Ra,( 232)Th, and (40)K in water samples collected from five wells were<0.4-0.16,<0.4-0.13, and<0.15-1.62?Bq?l(-1), respectively. The mean absorbed dose rate in outdoor air at a height of 1?m above the ground surface for the sand samples was 19.4?nGy?h(-1). The Ra(eq) activities of the sands are lower than the recommended maximum value of 370 Bq kg(-1) criterion limit for building materials.     

Minimizing of the boundary friction coefficient in automotive engines using Al<Subscript>2</Subscript>O<Subscript>3</Subscript> and TiO<Subscript>2</Subscript> nanoparticles

Minimizing of the boundary friction coefficient is critical for engine efficiency improvement. It is known that the tribological behavior has a major role in controlling the performance of automotive engines in terms of the fuel consumption. The purpose of this research is an experimental study to minimize the boundary friction coefficient via nano-lubricant additives. The tribological characteristics of Al₂O₃ and TiO₂ nano-lubricants were evaluated under reciprocating test conditions to simulate a piston ring/cylinder liner interface in automotive engines. The nanoparticles were suspended in a commercially available lubricant in a concentration of 0.25 wt.% to formulate the nano-lubricants. The Al₂O₃ and TiO₂ nanoparticles had sizes of 8–12 and 10 nm, respectively. The experimental results have shown that the boundary friction coefficient reduced by 35–51% near the top and bottom dead center of the stroke (TDC and BDC) for the Al₂O₃ and TiO₂ nano-lubricants, respectively. The anti-wear mechanism was generated via the formation of protective films on the worn surfaces of the ring and liner. These results will be a promising approach for improving fuel economy in automotive.

Open image in new window

Graphical Abstract Minimizing of the boundary friction coefficient in automotive engines using Al₂O₃ and TiO₂ nanoparticles

     

Triazole Fungicide Residues and Their Inhibitory Effect on Some Trichothecenes Mycotoxin Excretion in Wheat Grains

Wheat is one of the global strategic crops and ranks third in terms of cereals production. Wheat crops are exposed to many fungal infections during their cultivation stages, some of which have the ability to secrete a number of toxic secondary metabolites that threaten the quality of the grains, consumer health, producer economics, and global trade exchange. Fifty-four random samples were collected from wheat which originated from different countries. The samples included 14 types of soft wheat to study the extent of their contamination with deoxynivalenol (DON) and T-2 toxin by auto-ELISA technology and r-biopharm microtiter plate. All samples were contaminated with DON toxin except one sample, and the values ranged between 40.7 and 1018.8 µg/kg⁻¹. The highest contamination rates were in Lithuanian wheat and the lowest was in Indian wheat. Meanwhile, the highest average level of T-2 toxin contamination was in Lithuanian wheat grains with 377.4 µg/kg⁻¹, and the lowest average was 115.3 µg/kg⁻¹ in Polish wheat. GC-MS/MS and multiple reaction monitoring mode (MRM) were used to detect 15 triazole derivatives in the collected samples, which may be used to combat fungal diseases on wheat during the growing season. Only 9 derivatives were found: simeconazole, penconazole, hexaconazole, cyproconazole, diniconazole, tebuconazole, metconazole, fenbuconazole, and difenoconazole. These derivatives varied according to the origin of the wheat samples as well as their concentration, whereas another 6 derivatives were not detected in any samples. A direct inverse relationship was found between the DON concentration in the samples and the residues of simeconazole, penconazole, diniconazole, tebuconazole, metconazole, fenbuconazole, and difenoconazole, and the T-2 toxin showed the same relationship except for tebuconazole. The safe and rational use of some triazole derivatives may be a new approach and a promising strategy to not only reduce plant diseases and their problems, but also to get rid of some mycotoxins as grain contaminants.     

Radioactivity of sand,groundwater and wild plants in northeast Sinai,Egypt

The radioactivity levels are poorly studied in non-coastal arid regions. For this reason, 38 locations covering an area of about 350 km² in northeast Sinai, Egypt, were investigated by γ-ray spectroscopy. Moderately significant correlations among ²³⁸U, ²³⁴Th, and ²²⁶Ra isotopes and low significant correlations between the concentrations of ²³⁸U-series and ²³²Th in sand were obtained. No evidence of correlation was found between the concentrations of radioisotopes and pH, grain size, total organic matter content, bicarbonate or calcium carbonate concentrations of the sand samples. The mean values of soil-to-plant transfer factor were 0.15, 0.18, 1.52 and 0.74 for ²²⁶Ra, ²³²Th, ⁴⁰K, and ¹³⁷Cs, respectively. The range of concentrations of ²²⁶Ra, ²³²Th, and ⁴⁰K in water samples collected from five wells were<0.4–0.16,<0.4–0.13, and<0.15–1.62 Bq l^?1, respectively. The mean absorbed dose rate in outdoor air at a height of 1 m above the ground surface for the sand samples was 19.4 nGy h^?1. The Ra_eq activities of the sands are lower than the recommended maximum value of 370 Bq kg^?1 criterion limit for building materials.     

Experimental Study on Oscillatory Natural Convection in a Hele-Shaw Cell due to Unstably Heated Side

The oscillatory motion of natural convection in a porous medium has been investigated experimentally using a Hele-Shaw cell technique. The cell has been heated on the lower half and cooled on the upper half along the same vertical sidewall. Flows have been visualized using the pH indicator method. Photographs of natural convection patterns as well as average Nusselt number data have been presented for different Rayleigh numbers. Oscillatory motion of natural convection has been observed for large enough Rayleigh numbers and the critical Rayleigh number has been estimated to be between 120 and 450. Scaling analysis has been conducted to understand the heat transfer and the oscillating mechanism. According to the scaling analysis, it has been found that the average Nusselt number is proportional to the square root of the Rayleigh number, and that the oscillation frequency is proportional to the Rayleigh number. Obtained experimental data support the scaling analysis.