全文获取类型
收费全文 | 187篇 |
免费 | 111篇 |
国内免费 | 2篇 |
专业分类
化学 | 1篇 |
晶体学 | 1篇 |
数学 | 2篇 |
物理学 | 296篇 |
出版年
2014年 | 4篇 |
2013年 | 1篇 |
2012年 | 1篇 |
2011年 | 9篇 |
2010年 | 14篇 |
2009年 | 32篇 |
2008年 | 22篇 |
2007年 | 27篇 |
2006年 | 34篇 |
2005年 | 54篇 |
2004年 | 18篇 |
2003年 | 12篇 |
2002年 | 8篇 |
2001年 | 5篇 |
2000年 | 12篇 |
1999年 | 11篇 |
1998年 | 2篇 |
1997年 | 2篇 |
1996年 | 5篇 |
1995年 | 3篇 |
1994年 | 3篇 |
1993年 | 1篇 |
1992年 | 6篇 |
1991年 | 3篇 |
1990年 | 2篇 |
1989年 | 4篇 |
1988年 | 1篇 |
1984年 | 2篇 |
1983年 | 1篇 |
1981年 | 1篇 |
排序方式: 共有300条查询结果,搜索用时 15 毫秒
1.
Two problems of half-wave hole and high ripples in the transmittance region for a harmonic beam splitter had been pointed out and analyzed. Based on the application of a half-wavelength control and a new admittance matching methods, a harmonic beam splitter was designed and fabricated. The former method eliminated the half-wave hole fundamentally, and the latter smoothed high ripples in the transmittance region effectively. The matching stack consisted of a symmetrically periodic structure and provided a complete matching at the desired wavelength, i.e., both conditions for the equivalent admittance and phase thickness were fulfilled. Furthermore, both the theoretical and the tested curves had been given, and a good agreement between them was obtained. 相似文献
2.
A series of Mo/Si multilayers with the same periodic length and different periodic number were prepared by magnetron sputtering, whose top layers were respectively Mo layer and Si layer. Periodic length and interface roughness of Mo/Si multilayers were determined by small angle X-ray diffraction (SAXRD). Surface roughness change curve of Mo/Si multilayer with increasing layer number was studied by atomic force microscope (AFM). Soft X-ray reflectivity of Mo/Si multilayers was measured in National Synchrotron Radiation Laboratory (NSRL). Theoretical and experimental results show that the soft X-ray reflectivity of Mo/Si multilayer is mainly determined by periodic number and interface roughness, surface roughness has little effect on reflectivity. 相似文献
3.
设计并镀制了193nm Al2O3/MgF2反射膜,对它们在空气中分别进行了250-400℃的高温退火,测量了样品的透射率光谱曲线和绝对反射率光谱曲线.发现样品在高反射区的总的光学损耗随退火温度的升高而下降,而后趋于饱和.采用总积分散射的方法对样品在不同退火温度下的散射损耗进行了分析,发现随着退火温度的升高散射损耗有所增加.因此,总的光学损耗的下降是由于吸收损耗而不是散射损耗起主导作用.对Al2O3材料的单层膜进行了同等条件的退火处理,由它们光学性能的变化推导出它们的折射率和消光系数的变化,从而解释了相应的多层膜光学性能变化的原因.反射膜的反射率在优化联系、镀膜工艺与退火工艺的基础上达98%以上. 相似文献
4.
c轴定向氮化铝薄膜的制备 总被引:3,自引:0,他引:3
利用电子回旋共振 (ECR)微波增强化学气相沉积法 (PECVD)并使用氮气 (N2 ) ,氩气 (Ar)和AlCl3蒸气作为气源在直径为 6 .35cm的 (10 0 )单晶硅片表面制备了c轴定向氮化铝 (AlN)薄膜 ,并使用X射线衍射仪及其X射线特征能谱和扫描电镜 (SEM)分析了薄膜特征 ,研究了微波功率、基板温度和N2 流量对薄膜c轴定向的影响 ,得到了c轴偏差角小于 5°的高质量大面积AlN薄膜。 相似文献
5.
6.
利用光热偏转技术实施光学薄膜弱吸收的多波长测量 总被引:2,自引:0,他引:2
介绍了光热表面形变光束偏转技术用于测量光学薄膜弱吸收的基本原理,简述多波长吸收测量装置的建立和测试过程,最后给出简单的测量实例. 相似文献
7.
8.
利用掺钛的蓝宝石飞秒激光系统输出的单脉冲和多脉冲飞秒激光(中心波长800 nm,脉宽50 fs,靶面聚焦直径Ф 40 μm),分别对BK7玻璃基底上厚约500 nm的单层HfO2和单层ZrO2薄膜进行辐照,得到了这两种薄膜在1-on-1和1 000-on-1测试方法下的激光损伤阈值。实验发现,两种方法下HfO2单层膜的阈值均比ZrO2单层膜的阈值高。从简化的Keldysh多光子离化理论出发,认为HfO2薄膜材料的带比ZrO2的宽是导致上述结果的主要原因。同时,同一种薄膜的多脉冲下的阈值比单脉冲下的低,原因是多脉冲下,飞秒激光对光学薄膜的损伤存在累积效应。 相似文献
9.
分析了连续激光辐照ZnSe/MgF2/K9滤光片引起透射特性的变化。在室温条件下,用波长0.632 8μm激光作为探测光束,测量了1.06μm连续激光辐照ZnSe/MgF2/K9滤光片温升引起薄膜折射率的改变,导致探测光束通过干涉滤光片后透过率的热致非线性变化。在光斑直径0.75mm条件下,测量了不同功率激光辐照ZnSe/MgF2/K9滤光片引起温升随时间的变化。在激光功率30W,辐照时间2.52s条件下,实验观测到ZnSe/MgF2/K9滤光片薄膜破坏温度约为90℃,辐照时间10s时干涉滤光片形成的薄膜龟裂形貌。 相似文献
10.