全文获取类型
收费全文 | 22篇 |
免费 | 44篇 |
国内免费 | 11篇 |
专业分类
化学 | 5篇 |
力学 | 8篇 |
综合类 | 1篇 |
数学 | 16篇 |
物理学 | 47篇 |
出版年
2023年 | 1篇 |
2022年 | 2篇 |
2021年 | 1篇 |
2018年 | 5篇 |
2017年 | 1篇 |
2016年 | 1篇 |
2014年 | 2篇 |
2013年 | 1篇 |
2012年 | 4篇 |
2011年 | 5篇 |
2010年 | 3篇 |
2009年 | 5篇 |
2008年 | 2篇 |
2007年 | 3篇 |
2006年 | 5篇 |
2005年 | 7篇 |
2004年 | 5篇 |
2003年 | 5篇 |
2001年 | 3篇 |
1999年 | 5篇 |
1998年 | 3篇 |
1997年 | 2篇 |
1996年 | 1篇 |
1994年 | 3篇 |
1993年 | 1篇 |
1990年 | 1篇 |
排序方式: 共有77条查询结果,搜索用时 15 毫秒
1.
过渡金属Ni是地球上储量丰富的金属元素, 在加氢脱硫、重整制氢等催化领域应用非常广泛, 但是关于Ni基催化剂在烷烃脱氢方面的研究较少; 因此, 本工作采用不同的方法, 制备了三种结构的Ni基负载催化剂, 即尖晶石分解型、浸渍型和钙钛矿析出型, 并在700 ℃、C2H6-N2气氛中和50 mL•min-1气体流速下, 探索了它们的乙烷脱氢性能. 结果表明: 尖晶石分解型催化剂Ni1-xCuxCr2O4还原后在Cr2O3表面形成Ni-Cu合金颗粒, 能有效钝化Ni的C—C键断裂活性, 提高乙烯的选择性. Ni含量过高时, Ni不能有效地分散而形成大的金属团簇, 造成乙烷过度裂解, 乙烯选择性较低. 浸渍负载型催化剂NixMy/Al2O3 (M为Cu或Ag) 比表面积大, 表面活性位点分散, 但活性金属与载体结合力弱, 在高温下不稳定; Cu或Ag与Ni形成合金, 可有效提高乙烯选择性, Ag较Cu的效果更佳. 钙钛矿析出型催化剂LaCr1-xNixO3(LCNi-100x)在还原气氛中析出均匀细小的Ni颗粒, 其与基体结合力强, 抗积碳性能和稳定性较高; 含15% Ni的LCNi-15还原后(R-LCNi-15)表现出最好的催化性能, 乙烯产率最高(24%), 同时具有较好的抗积碳性能和稳定性以及氧化再生性. 相似文献
2.
Two new dicyanamide coordination polymers, {Mn(dmpz)[N(CN)2]2}2 (1) and {Cu(dmpz)[N(CN)2]2}2 (2)(dmpz=3,5-dimethylpyrazole), were synthesized and characterized by single crystal X-ray diffraction analysis and IR spectroscopy. In 1 and 2 the metal ions have two different coordination modes, where one is coordinated to four dicyanamide anions and two monodentate dmpz molecules to form a slightly distorted octahedral geometry, while the other adopts octahedral geometry, surrounded by four nitrile N atoms and two amide N atoms of the dicyanamide anions. Both complexes contain two alternating chains that are parallel to each other. 相似文献
3.
4.
讨论格自仿Tile的边界结构,得到平面格自仿Tile的边界为简单闭曲线的一个充分条件;作为应用,给出Bandt-Wang的一个定理的新证明. 相似文献
5.
A prototype of a device with an impact structure for measuring the floor tilt has been built in our laboratory. The mechanical construction and the capacitive transducer of the device are introduced. Experimental results indicate that the floor tilt is about 16#tad in our cavity laboratory, and the uncertainty AG/G caused by such tilt is less than 0.54 parts per million (ppm), so the floor tilt can be reasonably neglected in the experimental determination of the gravitational constant G with the total uncertainty of about l0ppm. 相似文献
6.
适合陆基使用的旋转重力梯度仪采用多个加速度计的组合输出,能有效地抑制平台的共模噪声,实现对地球表面微小重力梯度变化信号的测量.其关键技术之一就是对多个加速度计进行动态匹配调节,通过实时反馈来降低多种噪声和误差,从而降低对研制单个加速度计的性能要求.本文结合旋转重力梯度仪中加速度计的匹配调节方法,以重力梯度测量分辨率达到1E为目标分析,结果表明对加速度计的标度因子一致性匹配需要达到10-11的量级,对二阶非线性因子调节同样需要达到~10-11g/g2的量级. 相似文献
7.
A phenomenological study on the fitting method in real time has been done, and the method was applied to process and analyze the extensive data of a long period torsion pendulum used to determine Newtonian gravitational constant G. The result shows that the fitting method in real time is effective to determine the period of a torsion pendulum with a relative precision of 10-5 orders. 相似文献
8.
9.
OPTIMUM DURATION OF MEASUREMENT FOR REDUCING THERMAL NOISE LIMITATIONS IN TORSION PENDULUM EXPERIMENTS 下载免费PDF全文
Statistical estimates of thermal noise fluctuation of a linear harmonic oscillator used to detect weak forces are reexamined with special reference to gravitational experiments. Thermal noise limitation on the measurement of displacement of an oscillator is studied. It is found that the signal response of an oscillator reaches the maximum value while the thermal noise response reaches the minimum value at the same time during the transient state of the oscillator, and the precision of the experiments in the transient state could increase about two orders higher than that in the equilibrium state for typical experiments. It is also found that there is an optimum duration of measurement in which the uncertainty due to thermal noise in this period is the least. 相似文献
10.