Rational Molecular Design towards Vis/NIR Absorption and Fluorescence by using Pyrrolopyrrole aza‐BODIPY and its Highly Conjugated Structures for Organic Photovoltaics

Pyrrolopyrrole aza‐BODIPY (PPAB) developed in our recent study from diketopyrrolopyrrole by titanium tetrachloride‐mediated Schiff‐base formation reaction with heteroaromatic amines is a highly potential chromophore due to its intense absorption and fluorescence in the visible region and high fluorescence quantum yield, which is greater than 0.8. To control the absorption and fluorescence of PPAB, particularly in the near‐infrared (NIR) region, further molecular design was performed using DFT calculations. This results in the postulation that the HOMO–LUMO gap of PPAB is perturbed by the heteroaromatic moieties and the aryl‐substituents. Based on this molecular design, a series of new PPAB molecules was synthesized, in which the largest redshifts of the absorption and fluorescence maxima up to 803 and 850 nm, respectively, were achieved for a PPAB consisting of benzothiazole rings and terthienyl substituents. In contrast to the sharp absorption of PPAB, a PPAB dimer, which was prepared by a cross‐coupling reaction of PPAB monomers, exhibited panchromatic absorption across the UV/Vis/NIR regions. With this series of PPAB chromophores in hand, a potential application of PPAB as an optoelectronic material was investigated. After identifying a suitable PPAB molecule for application in organic photovoltaic cells based on evaluation using time‐resolved microwave conductivity measurements, a maximized power conversion efficiency of 1.27 % was achieved.     

HPLC with fluorescence detection assay of perampanel,a novel AMPA receptor antagonist,in human plasma for clinical pharmacokinetic studies

Perampanel (Fycompa®), a novel α‐amino‐3‐hydroxy‐5‐methyl‐4‐isoxazolepropionic acid (AMPA) receptor antagonist, is registered for the adjunctive treatment of patients (aged ≥12 years) with refractory partial‐onset seizures. To support therapeutic drug monitoring, a simple high‐performance liquid chromatography (HPLC) assay with fluorescence detection was developed to determine perampanel concentrations in human plasma and validated to support clinical trials. Human plasma samples (1.0 mL) were processed by liquid extraction using diethyl ether, followed by chromatographic separation on a YMC Pack Pro C₁₈ column (150 × 4.6 mm i.d., 5 µm) with isocratic elution of acetonitrile–water–acetic acid–sodium acetate (840:560:3:1.8, v/v/v/w) at a flow rate of 1.0 mL/min. Column eluent was monitored at excitation and emission wavelengths of 290 and 430 nm, respectively. The assay was linear (range 1.0–500 ng/mL) and this could be extended to 25 µg/mL by 50‐fold dilution integrity. No endogenous peaks were detected in the elution of analytes in drug‐free blank human plasma from six individuals and no interference was observed with co‐medications tested. Intra‐ and inter‐batch reproducibility studies demonstrated accuracy and precision within the acceptance criteria of bioanalytical guidelines. Validation data demonstrated that our assay is simple, selective, reproducible and suitable for therapeutic drug monitoring of perampanel. Copyright © 2015 John Wiley & Sons, Ltd.     

Stable all-optical formation of Bose–Einstein condensate using pointing-stabilized optical trapping beams

By stabilizing the beam pointing of optical trapping beams, we have succeeded in stable formation of Bose–Einstein condensate (BEC) of ⁸⁷Rb with all-optical method. The thermal effect of acousto-optic modulator (AOM) is usually one of the most serious problems to induce beam-pointing instability, especially for high power CO₂ laser. By passing the beam through AOM twice, we have improved the beam pointing from about 4.8 mrad to less than 0.4 mrad, which has been experimentally confirmed to be small enough to stably form BEC at the crossed region of CO₂ lasers as well as to perform experiments using an optical lattice which might have been affected by beam-pointing instability. PACS 32.80.Pj; 42.79.Jq; 03.75.Mn     

Numerical study on performance of disk MHD generator using frozen inert gas plasma

In an magnetohydrodynamic (MHD) generator using a frozen inert gas plasma (FIP), the availability of a frozen argon plasma, the influence of plasma uniformity at the generator inlet on the performance, and the feasibility of a large-scale generator are numerically examined by /spl gamma/-/spl theta/ two-dimensional simulation. The FIP is produced by pre-ionizing inert gas without an alkali metal seed at the generator inlet, then the ionization degree of the plasma is kept almost constant in the whole of the channel because of considerable slow recombination of the inert gas just like frozen reaction plasma. It is found that not only helium, but also argon frozen plasma MHD generation is realized, although highly accurate control of inlet ionization degree is necessary for argon. It is important to reduce the nonuniformity of plasma properties at the generator inlet in order to raise the maximum enthalpy extraction ratio. Even for the large-scale generator with 1000-MW thermal input, the ionization degree is kept almost constant in the whole of the channel and the high performance is obtainable. This result is extremely attractive for the FIP MHD generator.     

Decomposition mechanism of triethylindium (TEI) on a GaP(0 0 1)-(2×1) surface studied by LEED, AES, TPD and HREELS

Adsorption and decomposition of triethylindium (TEI: (C₂H₅)₃In) on a GaP(0 0 1)-(2×1) surface have been studied by low-energy electron diffraction (LEED), Auger electron spectroscopy (AES), temperature-programmed desorption (TPD) and high-resolution electron energy loss spectroscopy (HREELS). It is found from the TPD result that ethyl radical and ethylene are evolved at about 300–400 and 450–550 K, respectively, as decomposition products of TEI on the surface. This result is quite different from that on the GaP(0 0 1)-(2×4) surface. The activation energy of desorption of ethyl radical is estimated to be about 93 kJ/mol. It is suggested that TEI is adsorbed molecularly on the surface at 100 K and that some of TEI molecules are dissociated into C₂H₅ to form P–C₂H₅ bonds at 300 K. The vibration modes related to ethyl group are decreased in intensity at about 300–400 and 450–550 K, which is consistent with the TPD result. The TEI molecules (including mono- and di-ethylindium) are not evolved from the surface. Based on the TPD and HREELS results, the decomposition mechanism of TEI on the GaP(0 0 1)-(2×1) surface is discussed and compared with that on the (2×4) surface.     

A perfect one-factorization ofK 36

In this paper, a perfect one-factorization ofK ₃₆ is given, which is factor-1-rotational.     

Scalar curvature of spheres

Financial support from the FRD is gratefully acknowledged     

On the possibility of a radical decrease in the strength of many-body interactions in the organic metal α-(BETS)<Subscript>2</Subscript> KHg(SCN)<Subscript>4</Subscript>

Behavior of the de Haas-van Alphen (dHvA) oscillations depending on the angle between the magnetic field direction and the perpendicular to conducting layers in the quasi-two-dimensional organic metal α-(BETS)₂ KHg(SCN)₄ was studied in detail. The angular dependence of the dHvA oscillation amplitude exhibits a series of minima (at ±43.2°, ±64.6°, and ±72.0°) related to the “zero spin” effect, through which it is possible to estimate the splitting factor. An analysis of this value suggests that many-body interactions in the compound studied are either absent or at least radically weakened.