A post curing strategy toward the feasible covalent adaptable networks in polyacrylate latex films

The implementation of covalent adaptable networks (CANs) in general resin system is becoming attractive. In this work, we propose a simple post-curing strategy based on the core-shell structured acrylate latex for the achievement on both the improved general performance and the CANs characteristics in latex films. The building to the CANs was relied on the introduction of 4,4′-diaminophenyl disulfide as the curing agent, which cured the acetoacetoxy decorated shell polymer through the ketoamine reaction. The metathesis reaction of aromatic disulfides in the crosslinking segments enabled the thermally induced dynamic behavior of the network as revealed in the stress relaxation tests by comparison with other diamine crosslinking agents without the incorporation of disulfide. The synergism of the dynamic crosslinking of the shell polymer and static crosslinking in the core polymer contributed to the improved mechanical strength (15 MPa, strain% = 250%) and the suppressed water adsorption (~1% in 24 h of soaking) of the latex film, which exhibited above 90% of recovery in both strength and strain from a cut-off film damage within 1 h at 80°C. Moreover, the cured latex film could be recycled, and 75% of the mechanical performance was regained after three fragmentation-hot-pressing cycles. These, in addition with the feasible and environmental friendly characteristics, suggest a sustainable paradigm toward the smart thermosetting latex polymers.     

Development of an LC‐MS/MS method for determining the pharmacokinetics of clonidine following oral administration of Zhenju antihypertensive compound

Zhenju antihypertensive compound (ZJAHC) is a combined Chinese–Western medicine formula including clonidine (CLO), hydrochlorothiazide (HCT), rutin, Chrysanthemum indicum extract and pearl powder. Compared with CLO preparations, ZJAHC shows improved activities and decreased adverse effects. It is believed that the side effects of CLO are caused by its high peak plasma concentration. Hence, study of the influence of ZJAHC on the pharmacokinetic behaviors of clonidine seems essential. In present study, the plasma concentrations of CLO were determined with a liquid chromatography–tandem mass spectrometry (LC‐MS/MS) method. The MS/MS transitions monitored for clonidine and internal standard were 230.2 → 213.1 and 152.2 → 110.2, respectively. The analyte was quantified in a single run within 3 min. The pharmacokinetic study showed that the area under the plasma concentration–time curve of CLO in ZJAHC (60 µg/kg CLO) was similar to that of CLO‐HCT‐high (120 µg/kg CLO) but the peak concentration was much lower than that in CLO‐HCT‐high. ZJAHC could enhance the bioavailability without greatly increasing peak concentration of clonidine. This comprehensive effect of enhancing the bioavailability and avoiding the high peak plasma concentration for CLO might mainly result from the co‐contribution of Western medicine and traditional Chinese medicine (TCM), while the effect of TCM was stronger than that of Western medicine. Copyright © 2014 John Wiley & Sons, Ltd.     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

线性规划问题的规范型算法

提出了线性规划问题的两种规范标准形式；证明了任意一个线性规划问题都可化为这两种形式之一；给出了不需引入人工变量的线性规划问题的求解算法。     

聚乙烯基咔唑与Alq3混合薄膜的发光性能与能量传递过程

研究了Alq3与聚乙烯基咔唑(PVK)按不同比例的混合体系制备的薄膜的发光特性.通过对混合薄膜的吸收光谱、激发光谱和发射光谱的分析，研究了PVK与Alq3之间的 能量传递规律.当Alq3与PVK的质量比为1∶7时，能量传递效率最高.用一个由单链模 型扩展到包括杂质的哈密顿量对实验进行模拟，发现该模型能够较好地解释有关的实验结果. 关键词： 吸收光谱 激发光谱 发射光谱 能量传递     

耦合非线性Schrdinger系统的多辛差分格式

近年来,Bridges等人在Hamiltonian力学意义下,直接把有限维Hamiltonian系统推广到无穷维,通过引入新的函数坐标,使得偏微分方程在时间和空间的各个方向上都有各自不同的有限维辛结构,这样原偏微分方程就由各个有限维辛结构以及右端的梯度函数决定,称这样的方程为多辛Hamiltonian系统.多辛Hamiltonian系统满足多辛守恒定律,满足多辛Hamiltonian系统的多辛守恒律的离散算法称为多辛算法.以耦合非线性Schr dinger方程为例,研究无穷维Hamiltonian系统的多辛算法,验证了两孤立子碰撞后会发生相互通过、反射及融合现象.     

Nonvolatile photorefractive holographic recording in Sc:Ce:Cu:LiNbO3

In this paper experimental studies of nonvolatile photorefractive holographic recording in Ce:Cu:LiNbO₃ crystals doped with Sc(0,1,2,3 mol%) were carried out. The Sc:Ce:Cu:LiNbO₃ crystals were grown by the Czochralski method and oxidized in Nb₂O₅ powders. The nonvolatile holographic recording in Sc:Ce:Cu:LiNbO₃ crystals was realized by the two-photon fixed method. We found that the recording time of Sc:Ce:Cu:LiNbO₃ crystal became shorter with the increase of Sc doping concentration, especially doping with Sc(3 mol%), which exceeds the so-called threshold, and there was little loss of nonvolatile diffraction efficiencies between Sc(3 mol%):Ce:Cu:LiNbO₃ and Ce:Cu:LiNbO₃ crystals.     

First-Principles Study on the Electronic Structures for Y^3＋：PbWO4 Crystals

The possible defect models of Y^3＋：PbWO4 crystals are discussed by defect chemistry and the most possible substituting positions of the impurity Y^3＋ ions are studied by using the general utility lattice program （GULP）. The calculated results indicate that in the lightly doped Y^3＋ ：PWO crystal, the main compensating mechanism is [2Ypb^＋ ＋ VPb^2-], and in the heavily doped Y^3＋ ：PWO crystal, it will bring interstitial oxygen ions to compensate the positive electricity caused by YPb^＋, forming defect clusters of [2Ypb^＋ ＋Oi^2-] in the crystal. The electronic structures of Y3＋ ：PWO with different defect models are calculated using the DV-Xα method. It can be concluded from the electronic structures that, for lightly doped cases, the energy gap of the crystal would be broadened and the 420nm absorption band will be restricted; for heavily doped cases, because of the existence of interstitial oxygen ions, it can bring a new absorption band and reduce the radiation hardness of the crystal.